Question about 2003 Subaru Forester

Open Question

My forester is lugging and hesitating - 2003 Subaru Forester

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is wheel lug nut torque for Subaru forster

Forester wheel lug torque spec is 89 lb-ft.

Jun 28, 2016 | 2003 Subaru Forester

1 Answer

I cannot get the front tire off of my 2001 subaru forester

Not overly familiar with this car but usually not. They put a small amount of grease between the wheel and hub to avoid rust and it creates a vacuum almost like glue. Take a bar or your biggest screwdriver and pry on your wheel spoke for leverage as not to damage your disc or caliper It seems strange but it will pop off. My explored and Yukon do the same thing.

May 06, 2012 | 2001 Subaru Forester

1 Answer

2001 Subaru Forester hesitates on acceleration after it has been warmed up.

Might be a spark plug wire, or spark plug. Fuel filter may cause this too. May want to change that if it has not been done in a while and your air filter. To check the wires, try to look under the hood in a really dark spot to see if any sparks are grounding out anywhere. Have someone put the car in gear while you look under the hood and keep their foot on the brake, that way you can simulate a load on the engine. The fuel filter may work ok until you go up a hill or equivalent. I assume you mean hesitation and not some kind of slippage of the transmission if it is an automatic. take care, good luck

Feb 12, 2011 | 2001 Subaru Forester

1 Answer

Inertmitant low idle after flat battery

Hi there am having same problem with my 2001, did you find anything out. also when I go up a hill it trys to sputter out on me, never on the flats tho.

May 18, 2010 | 2004 Subaru Forester

1 Answer

Engine hestitation, 2000 subaru forester

I think these codes are indicating a fault with your catalytic converter. The 02 sensors are each not returning the correct values to the ECM, causing a "suspect the 02 sensors" fault code.

Apr 01, 2010 | 2000 Subaru Forester

1 Answer

Subaru Forester hesitates turning

Just know you're not 1999 Saturn S-Series is doing this too, particularly at low RPMs when I turn a corner. It feels like its going to stall like a manual car, but is auto. If anyone has a solution for us I'm curious to find out....

Nov 21, 2009 | 2003 Subaru Forester

1 Answer

Shift to drive hesitancy on a '00 Forester

transmission fluid "bleeding" internally at low clutch piston,when fluid leaks past the piston seal there is not enough apply pressure for the drive clutches to apply,sometimes depending on size of leak you can rev the engine to build up enough pressure to apply drive hope this helps good luck

Jul 27, 2009 | 1998 Subaru Forester

2 Answers

Perfect Idle, no Codes, but stepping on gas causes hesitation

i would try cleaning mass air sensor, its mounted in air duct between air filter and throttle body, they sell the cleaner at auto parts stores, also as stated bofore make sure the intake pipe clamps are tight and it's not cracked, if that doen't fix it i would investigate a fuel pressure problem either a weak pump or problem with regulator

May 24, 2009 | 1999 Subaru Forester

Not finding what you are looking for?
2003 Subaru Forester Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides