SOURCE: Blower motor or resistor?
If it was the motor that went out then it would not blow at all. The resistor is the culprit that starts killing off speeds. It should be about $25 to $30 at an aftermarket store like autozone or advanced auto parts.
SOURCE: 2005 GMC Envoy SLE blower fan speed #5 is not working
More than likely this should just be your resistor. You have different sized coils on the back of your resistor for all the different fan speeds. if one of them burns out or breaks then that certain speed will not work.
SOURCE: 2006 Ford Explorer XLT the Blower Fan only works on 4 and 3 Sp
Look under the dash on passenger side and just to the left of the blower motor housing you will see the 4WD control module.Remove the 2 screws holding the module and let it hang down and your resistors are behind this.Remove the 2 screws holding the resistors and remove.
Now I am assuming you have manual climate control and not electonic.
SOURCE: Blower motor or resistor?
Yes its the blower motor resistor.
More then likley theres some trash or something in it, or possibly the motor itself is on it's way out. There not that bad to pull out of that body car, just pull it out and see what you can see.
The blower motor is under the glove compartment
You can replace the resistor on your own. Please find a detailed diagram which would guide you to do it.
http://autorepair.about.com/library/images/bl629a-lib.htm
Thanks
SOURCE: NEED TO REPLACE BLOWER RESISITOR. FAN ONLY WORKS ON HIGH SPEED
Under the dashboard on the passenger side you will see the blower motor. Near the blower motor inside the air duct is the resistor. It should be held in place by two screws. Hope this helps. Good luck
21 views
Usually answered in minutes!
×