Question about Cars & Trucks

1 Answer

98chevyblazer wont go into reverse

Drive works no reverse fluid full

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 443 Answers

Did you get stuck or spin and catch traction ,
if so you probably stripped the sun gear

Posted on Feb 10, 2014


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 200 Answers

SOURCE: when i put my car in reverse it won't move but will drive forward perfect and is full of transmission fluid

Assuming this is an automatic transmission, odds are you have lost a band in your transmission, this will require a rebuild,  you may also notice it will fail to shift into high gear as well?

Posted on Oct 29, 2008

  • 4 Answers

SOURCE: my car wont move forward or reverse

Chances are is that the torque converter needs to be replaced. However, the transmssion on this vehicle are only serviceable by transmision shops. No regular mechanic will open up the transmission. When the torque converter fails (clutch and plates shutters to small pieces) the debri flows in the transmision thereby potentially destroying the gears and/or clogging the filter and pump. Go straight to a reputable transmission shop and let them correctly diagnose the transmission.

Posted on Jul 26, 2010

  • 38 Answers

SOURCE: 1995 saturn sl2 automatic transmission wont work in reverse fluid is full

time for a rebuild. hard to find someone to work on saturn because of parts issues

Posted on Sep 14, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My mercury sable wagon, shifter wont engage in anything. just stopped working, no slipping in trans.

indicates a torque converter clutch servo/ solenoid problem
check wiring and connections
run fault codes

Oct 28, 2017 | Mercury Cars & Trucks

1 Answer

00 durango only goes in drive

Sounds like a lot of miles...any routine maintenance completed? Fluid, filter change? Your least costly attempt to fix would be to add a full bottle of Lucas Oil Transmission treatment to your existing ****** drain is needed. Be sure to warm your Durango by driving for a few minutes before adding the whole bottle. This fluid will attempt to reseal and lubricate the ******. Hope this helps.

Jun 20, 2012 | 2000 Dodge Durango

2 Answers

I just purchased a used toyota 4 runner,1998, the transmission only engage reverse and not drive

I think you know you need a transmission, the only check that you can do is FLUID check f its to low the truck wont move, check for transmission codes, if oe of the codes is for line pressure solenoid that could be the entire problem, one more thing take a look at the radiator coolant if the color is like a pink shake the radiator is damage mixing coolant and transmission fluid.

If you need further help, I’m available over the phone at

Dec 26, 2010 | 1998 Toyota 4Runner

1 Answer

Car wont shift into reverse

check the fluid levels, then try again, if not working after full of fluid, cracked drive shell.

Dec 17, 2009 | 2000 Chevrolet Blazer

2 Answers

Same as a lot of folks. 1995 Pathfinder. Without warning will not reverse. Hardly any difference in RPM between park/Neutral/Reverse. How can I tell if I need a rebuild ?

if it is the automatic transmission and the other gears work but it wont drive in reverse. then I suspect the transmission fluid is too low.
are you checking the fluid correctly?
my sister had a car that reverse went out on. my dad asked her, how long has it been doing this?
she said 6 months and that she had to always park in a position that she wouldnt need reverse.
my dad asked how is the fluid? my sister said its always full on the dip stick.
she showed my dad it was full.
she didnt check the level correctly..
she checked the fluid when the car was cold. she checked the fluid when the car had been sitting for quite sometime and when it was not running.
run the engine till the transmission is warm. shift the car in all the gears. leave the car running in park on level ground and check the fluid then.

Jun 17, 2009 | 1995 Nissan Pathfinder

1 Answer

Auto Transmission not working.

Replace the tranny filter and fluid

Jun 05, 2009 | 1991 Toyota Cressida

1 Answer

HELP Will not go in Reverse

Need more information to be sure but usually reverse is the first thing to stop working when the fluid is low.  Check the fluid level and if it is low fill it to the proper level and then check for a leak.  If the fluid level is full more than likely it is an internal problem.

Jan 14, 2009 | 1994 Pontiac Sunbird

1 Answer

1995 blazer s-10 4l60 e drive down block shifts get bad wont pull so i parked went to check for reverse and drive no reverse no drive nothing shut off start right back up and have both again ??

Presuming the fluid level is full,it is quite common for a broken reverse sun shell to give the symptoms you are experiencing,as well as some other areas that could also give similar symptoms such as burnt clutch packs,or the torque convertor going bad,and eventually the vehicle will stop pulling altogether.If the fluid is full,the problem is pretty much going to require trans removal and repair.Further diagnostic would include installing a mechanical oil pressure gauge onto the transmission to monitor main line pressure and see what it's doing while the trans is acting up and not pulling,and this does require a gauge capable of handling 300 psi.Also pull diagnostic trouble codes from the vehicle computer (PCM).Good luck.

Aug 30, 2008 | Chevrolet Blazer Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15148 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides