Question about Chrysler Cars & Trucks

1 Answer

Chrysler town and country 2006, gave these codes P0700, P048.0 and P063.3. What do they mean?

Noticed that my minivan was consuming too much fuel and tried listen to see if the transmission was selecting gears and I found out that it wasn't. I did the on/off stuff with the keys and these were the codes that showed, P0700, P048.0 and P063.3.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 45,620 Answers

Code po700 refers to transmission control system/ MIL --malfunction====causes---wiring---TCM
As to the other codes they are specific to the manufacturer and will require determination from a service centre

Posted on Feb 09, 2014

  • Olushola Adeleye
    Olushola Adeleye Feb 11, 2014

    Is it possible to replace the TCM

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dsacco86
  • 1077 Answers

SOURCE: check engine light on 2005 town and country 3.3

(DTC) CODE # P0700....Transmission Control System (MIL Request)

Translation:
Transmission Control Module (TCM) Malfunction or Failure.

P0700 Information Code

The Transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. If any malfunction is detected, the TCM informs the PCM by sending a signal (P0700 code). P0700 means that a code has been set in the TCM.

This code is for information ONLY. If this code is present, check for transaxle codes.


P1776: Solenoid Switch Valve Latched in Low/Reverse Position. The TCM monitors the L/R solenoid to ensure that the fluid transfer happens. It uses a Pressure switch to verify this. Usually this code is set by a switch that is stuck or a solenoid that is not mechanically operating.

A transmission shop would be better suited for this type of work.

Posted on Apr 11, 2009

  • 1 Answer

SOURCE: fuse for stereo/cd in chrysler town and country minivan

Its in the box next to the battery and i had the same problem.The fuse is on the first line top.

Thanks

Posted on Mar 08, 2009

  • 1 Answer

SOURCE: 2006 Chrysler Minivan - oil consumption - time is running out

I do not believe there is a fix by Chrysler. My van has 50000 and seems oil consumption is getting worse. It is either past the valve seals or the piston oil control ring. I believe Chrysler KNOWS ALL ABOUT THIS! If you google search this there are to many complaints! 1 quart every 3 thousand miles is not exceptable unless you are driving a model T!

Posted on Nov 26, 2009

  • 52 Answers

SOURCE: how do i replace a fuel pump on a 99 chrysler town

the fuel pump is in the gas tank. you will have to remove the bolts that hold the straps in place, lower the tank a few inches as to easier access to the fuel lines and wiring harness. unhook all the wiring and the fuel lines and you will probably see hose clamps for the filler neck, after all things are unhooked the gas tank should come out, if you came this far you will probably be able to figure out how to remove the fuel pump, usually i will use a screwdriver and a hammer to turn the retaining ring or clip holding the pump in the tank..

Posted on Mar 12, 2010

  • 78 Answers

SOURCE: 2006 Chrysler Town and Country key needs reprograming

Keylessride.com my be a little cheaper

Posted on May 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my 2001 town & country 3.8 will not shift gears?


p1784 shift up /down wire open,,,P0700 Transmission Control System Malfunction

Read more at: http://www.obd-codes.com/trouble_codes/
Copyright © OBD-Codes.com

P0732 Gear 2 Incorrect ratio

Read more at: http://www.obd-codes.com/trouble_codes/
Copyright © OBD-Codes.com

Apr 23, 2015 | 2001 Chrysler Town & Country

1 Answer

Needs celluoid


Do you mean the starter solenoid ?

Jun 19, 2013 | 2006 Chrysler Town & Country

1 Answer

How do you repair the drivers side outer CV axle and boot on a 2006 Chrysler Town and Country Limited minivan?


Obtain a Hayne's manual from AutoZone. It will give you detailed directions how to do this.

Apr 30, 2012 | 2006 Chrysler Town & Country

1 Answer

Error code 0700 aa1 aa2


Hi there:
The DTC P0700 is a Information Code The Transaxle Control Module (TCM) that monitors the malfunction of sensors and actuators relating to transaxle control. If any malfunction is detected, the TCM informs the PCM by sending a signal (P0700 code). P0700 means that a code has been set in the TCM.
This code is for information ONLY. If this code is present, check for transaxle codes. So basically, the P0700 code is telling you to check the TCM for a transaxle DTC. The TCM can not turn on the check engine light so it has the PCM do it, which can only be done with a diagnostic scanner. The self retreival method for chryslers with the ignition key will not pull up the specific transmission fault codes in the TCM.


Hope this helps.

Mar 30, 2012 | 2001 Chrysler Town & Country

2 Answers

I got two odometor codes p1684 and p0700 do you know what it means 2002 chysler town and country


P0 700 is a transmission control malfunction and P1684 is a indication that your battery was disconnected within the last fifty states.However what is puzzling is your PO 700 is a generic code your P1684 is a dedicated Chrysler code your cars computer should only store one or the other not both.

Dec 24, 2010 | 2002 Chrysler Town & Country

1 Answer

Check engine light on 2005 town and country 3.3


(DTC) CODE # P0700....Transmission Control System (MIL Request)

Translation:
Transmission Control Module (TCM) Malfunction or Failure.

P0700 Information Code

The Transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. If any malfunction is detected, the TCM informs the PCM by sending a signal (P0700 code). P0700 means that a code has been set in the TCM.

This code is for information ONLY. If this code is present, check for transaxle codes.


P1776: Solenoid Switch Valve Latched in Low/Reverse Position. The TCM monitors the L/R solenoid to ensure that the fluid transfer happens. It uses a Pressure switch to verify this. Usually this code is set by a switch that is stuck or a solenoid that is not mechanically operating.

A transmission shop would be better suited for this type of work.

Apr 11, 2009 | 2005 Chrysler Town & Country

3 Answers

2006 Chrysler Minivan - oil consumption - time is running out


I do not believe there is a fix by Chrysler. My van has 50000 and seems oil consumption is getting worse. It is either past the valve seals or the piston oil control ring. I believe Chrysler KNOWS ALL ABOUT THIS! If you google search this there are to many complaints! 1 quart every 3 thousand miles is not exceptable unless you are driving a model T!

Jan 19, 2009 | 2006 Chrysler Town & Country

1 Answer

I want to know what trouble code P0700 means in a chrysler town and country 1998, and how do I reset the check engine light?


0700 is a "transmission control system malfunction". The entire 0700 series of codes deals with transmission trouble codes in more detail so the 0700 won't tell you much unless one or more of the other codes also were set.

Jan 10, 2009 | 1998 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...