Question about 2003 Chrysler Concorde

1 Answer

2003 chrysler concorde fuselink from battery to altenator burning

Fuselink wire from battery to altenator burnt i spliced in a 60amp inline fuse keeps blowing fuse

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    A rookie expert who has answered 20 questions on their first day.

  • Expert
  • 63 Answers

Sounds like a rectifier malfunction, or wiring short.

Posted on Feb 09, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 55 Answers

SOURCE: battery removal

The battery is located under the right front fender behind the tire. Remove the wheel, remove access panel from fender well. From engine compartment, remove 2 battery hold down bolts,10mm, slide battery rearward to remove battery cables.

Posted on Oct 18, 2008

  • 1 Answer

SOURCE: 2000 chrysler concorde switch unlocks but wont lock doors.

sounds like the actuator. I had the same problem. Mine got to the point where it will now only work with the key. Had it looked at by dealer.. actuator is bad. Good luck.

Posted on Apr 28, 2009

  • 101 Answers

SOURCE: chrysler wont start

Sounds like a short maybe. maybe the wire completely broke? if you know a technician, see if the fuel pump is even getting power when key is on

Posted on Jul 02, 2009

  • 122 Answers


You will need to disengage the Negative terminal (Black side) and then the Red (positive side). In addition, there might be a securing bracket with two bolts or wing nuts, loosen these and the rods can be pushed down and twist out of the bottom. Once this is done remove the battery and head to your local Auto parts store, they can help you select the correct one. re-assemble as you have taken apart. you will need to re program your stereo and reset your clock, (prior to removing terminals) make sure there are no special lock out codes for your stereo. Good luck!

Posted on Sep 12, 2009

  • 811 Answers

SOURCE: 1998 chrysler concorde and the a/c and heat blower resistor blown

check amp draw on motor

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2001 Chrysler Concorde, need to disable GPS tracker put on by previous owner

gps tracker should be plugged into ob2 port trace wires out one by one and disconnect if the spliced into a wire unplug it if a wire is cut to loop through tracker first remove and reconnect cut wires recommend soldering and heat shrinking cut wires

Apr 17, 2015 | 2001 Chrysler Concorde

2 Answers

No power to key ignition 1998 GMC Jimmy

Look for the inline fuse link in the red wire from the battery . It looks like something was spliced into the wire. It's the fuselink.

Jun 25, 2014 | 1998 GMC Jimmy

1 Answer

How to change an altenator on a Chrysler Concorde 2003

disconnect battery loosen tensioner for belt take belt off two bolt on alternator then comes right off take wires off back of alternator then replace it

Feb 05, 2013 | 2000 Chrysler Concorde

1 Answer

Eng controler fuse keeps blowing out from power distribution box every time i put neg cable on

Hi, if it is fuse A that is burning, trace the red wire from the underhood fuse box to the starter and auto shut-down relays to see if the wire is shorted to the chassis. If it is fuse B, trace the red wire with a white stripe to the other relays.


Jun 30, 2011 | 1997 Chrysler Concorde

1 Answer

!998 chevy caprice classic starter solenoid wires are burnt

check all wires for bare spots and ensure all grounds are good .probably have short

Jul 10, 2009 | 1991 Chevrolet Caprice

2 Answers

Chrysler concord brake lights stay on

the brake light switch is located on the lever that the brake pedal is attached to, near the top. U will need to pull the under dash hush panel off to get at it.

May 28, 2009 | 2003 Chrysler Concorde

1 Answer

Is there a fuse/fusible link to alternator,

The wiring burning up at the altenator most likely caused the diode inside the altenator to short out. I would just replace the altenator now.

Mar 18, 2009 | 1987 Ford F 150

Not finding what you are looking for?
2003 Chrysler Concorde Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides