Question about 2004 Ford Freestar

Open Question

2004 ford freestar....front blower motor ...works than stop

Let car run for about 45mins, then drove another 30mins. turned off than would not come back on..thne came on again.Its been doing this couple of days.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4369 Answers

SOURCE: Front Windsheild Wipers

I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal

  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Posted on Apr 10, 2009

Ad
  • 1 Answer

SOURCE: ford freestar 2004 the TRAC OFF message comes

I had the same problem and apparently fixed it by mistake. I replaced the cruise control deactivation switch under the master cylinder, hoping the cruise would be fixed. Some how with that the "trac off" light went out and gave me the ability to turn it on/off from the button again. The part was $30 from the local dealer and easy to replace. Before you run out to replace the switch check the connections on the old one. It plugs in upside down which may accumulate water from puddles and things causing connection issues ( a known problem ).

Posted on Sep 23, 2009

  • 4369 Answers

SOURCE: 2004 Ford Freestar with P0340 Code. What is it

camshaft position sensor

Posted on Jan 16, 2010

  • 1 Answer

SOURCE: 2004 ford freestar rear hatch latch broken

have you fixed yours yet? mine started doing this last year

Posted on Mar 18, 2010

  • 100 Answers

SOURCE: 2004 Ford Freestar missing Possible fuel pump?

if you have a bad spark plug wire, it will draw condensation and make engine run rough.... you can check this by getting a spray bottle and filling it with water, spray a mist over top of the wires while the car is running, and if one is bad it will show.... (looks like little lightning coming off of wire) .... hope this helps

Posted on Mar 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 ford freestar front blower motor will not come on. Windshield wipers only work occasionally


Pull the control switch out of the dash and check the switch connector for burnt connectors terminals, it will be be discolored, if you do find the switch burnt replace the switch and buy a repair connector from Ford. If the connector is ok then replace the blower motor resistor near the blower motor, it can cause this problem as well, in fact do that first, the blower resistor module is only about $18.00 (Source Rockauto.com). the wipers are controlled through the BCM (body control module), it can be tested with a scan tool. Below is a picture of the blower resistor module.
resistor-cvwiva3pd4w10j2ma2c0he5w-1-0.jpg

Apr 03, 2017 | 2004 Ford Freestar

1 Answer

Does anyone have any suggestions regarding how to diagnose no power to front blower motor in a 2006 Ford Freestar mini van.


You also have the front blower motor speed controller and the electronic automatic temperature control (EATC) module to check.

Nov 10, 2016 | 2006 Ford Freestar

1 Answer

Driver side blows hot air while passenger side blows cold air


You need to replace the driver side temperature blend door actuator , electric motor that controls the temp .The instrument panel may need to be pulled out to replace it . You may want to take it to a qualified repair shop . As far as the rear blower motor , the motor could be bad or the auxiliary blower relay module , or the blower motor relay could be the problem . Without knowing component position in the vehicle you have a difficult time tracking down these parts .

Jun 29, 2016 | 2004 Ford Freestar

1 Answer

2007 ford freestar their is no blower operation resistor board is okay replaced blower


you may have to have the GEM module checked out as I believe it controls heater control operation.

Aug 29, 2014 | 2007 Ford Freestar Limited Minivan

1 Answer

Where is the cowl on a 2004 ford freestar


its the black cover that covers wiper motor and half the engine in front of your windshield need to take that off to get to back side of engine also to get to your computer

Feb 27, 2013 | 2004 Ford Freestar

2 Answers

Ac works great in the rear but not in the front


My 2004 freestar has the same problem. I hate this car it is the worst car I have ever owned.

Aug 24, 2012 | 2004 Ford Freestar

1 Answer

My wife drove her ford freestar thru three feet of water and now the car wont start or even turn over.


sounds like its hydrolocked. remove the spark plugs and see if it will turn over. if it does replace the plugs and change the oil

Jun 07, 2010 | 2004 Ford Freestar

1 Answer

I need to know if the blower motor for the 2004 ford freestar hvac is the same front and rear or not.


the blower will diferent from the front blower if that is what ur asking

Jun 29, 2009 | 2004 Ford Freestar

Not finding what you are looking for?
2004 Ford Freestar Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...