Question about Cars & Trucks

Open Question

Crank position sensor location for opel astra h

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 50 Answers

SOURCE: crank position sensor location

you will need to remove the starter to gain acess to the ckp sensor. once you remove the starter look on the engine block and you will see the sensor. The only problem with doing this repair yourself is that you will not be able to preform the crankshaft position variation learn procedure with out a factory scan tool. The vehicle may crank an run, but the timing advance curves will be wrong so the vehicle will probably cut off every time you remove your foot from the gas pedal. Hope this info helps!

Posted on Aug 18, 2008

  • 39 Answers

SOURCE: 1997 Dodge caravan crank position sensor

it is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine.

Posted on Sep 25, 2008

  • 2 Answers

SOURCE: Crank Position Sensor

what is a crank position sensor ,what does that do ..

Posted on Oct 08, 2008

emissionwiz
  • 75822 Answers

SOURCE: location of crank position sensor on 92 chevy corsica 3.1

You will have a no start or stalls after engine gets hot and then cools down restarts, the sensor is on the front of the engine mounted into the cam gear cover if it is not visiable get under the, (here is a picture) car and look.d37e0b9.jpg

Posted on Jan 21, 2009

pugwash814
  • 377 Answers

SOURCE: opel astra headlight adjustment

two screws on each headlight control the direction the headlights are aimed. One screw, usually at the top but sometimes below the headlight, adjusts the headlight up and down. The other screw, located to one side, controls the headlight from right to left. Turning the appropriate screw one direction or the other will change the direction the headlight points.
In order to aim your headlights you need to have a flat vertical surface you can aim your headlights at in front of a level surface on which to park the car. If your driveway is level your garage door is the perfect place to aim your headlights.
The tools you will need for this job are simple. Masking tape is used to mark where the headlights are to be aimed and a screwdriver is needed to adjust the headlights. A tape measure will be necessary to measure the distance of the vehicle to the surface you're using to check the aim and to measure the up and down distances from your marks

Posted on Nov 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im driving an opel astra j essentia 1.6 2011 model,recently it started jerking or cutting petrol supply, i bought a new petrol pump the problem still persists please assist.


Jerking or cutting fuel supply? How did you determine that? This is most likely a sensor in the engine. Could be a fuel pump relay but it most likely is a crank shaft sensor.

Jan 27, 2017 | Opel Cars & Trucks

1 Answer

Where on engine can a crank shaft position sensor be located on a 2002 Saturn sl


I think this saturn is the same as the opel astra /zafiro if so then its front bottom right on the engine block in line with the crankshaft ,But no doubt iam wrong as never seen this saturn car here in spain

Dec 09, 2014 | 2002 Saturn Sl

1 Answer

Where are the central locking system located in a 1996 opel astra


Hehe that's quite a job , it's just beneath under your left panel and just remove rubbers etc and probably one hook is loose , if not, the motor is dead

Aug 17, 2014 | 1998 Opel Astra 1.7

1 Answer

How to install Opel Astra Crank sensor?


locate the crank sensor there should be two screws and a electric plug pretty simple if u can locate the sensor

May 18, 2014 | Opel Astra Cars & Trucks

1 Answer

How to replace the crank sensor?


opel. 1.6L

if the PCM scans ,cranking for 5 long seconds , does NOT throw
CKP sensor bad DTC errors, id bet its good.
why not trust the PCM to see those missiong pulses and tell you;.
call EFI gas cars do this. and do it well.
the crank sensor on all engine can be in 3 spots.
front,. rear and middle of crank.
a fast look finds this easy.
did you even look?

1.6L dont say much. there are 7 , 1.6L opal engines.
SOHC and DOHC.
Z16SE/X16SE 62 (5400)/138 (2600) Z16XE/X16XE 74 (6000)/150 (3600) Z16XEP/X16XEP 76 (6000)/147 (3600)
if hell bent on swapping it out, why not buy one, ?
they will ask you engine exact name(above) or VIN and sell it to you
then look at the connector, id bet you can find it , on the engine now
with knowing the pin count and shape.
no?
on some harder cars, FWD, the sensor takes removing the transmission to see the sensor. bolted where not easy to change.
that is why we do the tests. first. not guess.
got a scan tool ?do the tests. ask.

http://www.carpartgiant.co.uk/Products/Vauxhall/Astra/1.6L/Crankshaft-Sensors.aspx

wild guessing see the gold looking sensor. this might be it.

May 18, 2014 | 2001 Opel Astra

1 Answer

What is the location pcv valve on the opel astra 2003


The PCV Valve, or Positive Crankcase Ventilation valve is an emission control device that ...It is located on the inlet manifold

May 07, 2014 | 2003 Opel Astra

1 Answer

Hard starting


Crank Angle Sensor (CAS) should be replace.

Most battery last 48 months,check the date code on top of the battery to see how long it is in service.

Jan 13, 2014 | Opel Astra Cars & Trucks

1 Answer

Opel astra 1.6cde is jerking while driving


try checking all the wiring pugs on the engine particuarly the ones to the crank and knock sensors if you have a managment light on then plug in a code raeder and see what codes are stored

Dec 31, 2013 | Opel Astra Cars & Trucks

1 Answer

Where is opel astra`s oil sensor connected


sump on the side. prone to let water into the sensor plug when the seal gets weak or splits.

Apr 14, 2013 | 1998 Opel Astra 1.8

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...