Question about 2003 Nissan Maxima

Open Question

When Accelarating I heard a rattle coming from the transmission especially on low gear from 1 to 3rd.

And also when the car is on neutral. when I release the clutch you can also hear a noise , when u push the clutch in you don't hear nothing. Plz help . thank you

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
j_del
  • 1586 Answers

SOURCE: 1993 nissan 240sx clutch problems

Did you bleed the system fully after changing the cylinders? Those are the two main components that cause such problems. If you bled the system out, and it still has the problem, then you most likely have a ruptured line somewhere that is allowing air into the system.

Posted on Aug 24, 2008

Ad
greg_margo
  • 1959 Answers

SOURCE: oil consumption, rattle, engine noise

Check under the hood and inspect the valve cover gasket. If it's bad it would explain why you don't see any leaks on the ground because it's probably burning off on the manifold. This ticking you're hearing is a lack of lubrication to the rocker arms. Apart from the valve cover gasket, you should get under the car and inspect the oil pan and oil filter for seepage. Best of luck on your problem.
Greg

Posted on Jun 10, 2009

miket756
  • 2702 Answers

SOURCE: 2003 Nissan Maxima reving noise

no, its not the transmisshion,,,, its the cluch release bearing worn out,
every time you press on the cluch it screems or chaters, yes?
you just need to fit a new cluch, as its realy not worth the effort in just replacing the bearing only to have the rest of the cluch go in 6 months
that would be mad ness and pricy

Posted on Oct 24, 2009

smartr10U
  • 1305 Answers

SOURCE: manual transmission noise

It's most likely your throw-out bearing. It's located very inconveniently on the front shaft of the transmission and the way to remove and replace is to pull the tranny from the car... While you're at it, inspect the clutch and pressure plates and the pilot bushing (located in the center of the flywheel).

Posted on Nov 23, 2009

dmsr63
  • 2050 Answers

SOURCE: rattling / grinding sound coming from engine area

Just a couple ideas...
Your engine and transmission will shift slightly when in drive, and maybe that movement is allowing it to rub on something. Another issue may be that the noise is actually from the transmission.
Torn motor mounts will allow the drive train to shift or move farther than normal.

Posted on Jul 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Audi A6 is stuck in neutral and will not budge I can start the car and everything works it just will not come out of neutral


When you say it is stuck in neutral what is stuck? is the shiftter stuck in the neutral postion or is the car not moving when shifter is placed in drive or other gears,
if the car doesnt move in gear i would say it is transmission releated, this may be a bad tranny or fluid is very low.

check your transmission oil, make sure it is full. this is were i would start,

Sep 02, 2013 | 2005 Audi A6

1 Answer

1999 buick park ave has loss of power when accelarating from stop


if your engne rpm race upward when you apply gas but the car move slowly, you have transmission problem. I had this same problem when my transmission gone bad. you may need to have it services or low on transmission fluid. if not the low fluid problem, then you have transmission gears defect.

Mar 28, 2011 | 1998 Buick Park Avenue

2 Answers

Manual Transmission rattling and rough driving.


If the truck was ran low on fluid to the point it clangs and bangs, the internal damage is done.
The best you can hope for is burnt bearings and hopefully the shafts are not scored. Disassembly is the only solution. Or a used transmission.

Feb 24, 2010 | 1988 Ford Ranger

1 Answer

95 4Runner, hearing a rattling sound underneath, from drive train perhaps (do not think it is trainie, drive rod or rear gear box?), sound occurs during drive acceleration or braking -- indicating loose...


rattling when doing what? if it rattles when it is running or when it is driving, this will tell you roughly where to look. If rattling while idling, coming from engine or transmission. If you ONLY hear it when you are driving, check you U joint. they can wear out and start to rattle and clunk sometimes, especially when going in and out of gear...reverse to drive etc...

Jul 23, 2009 | 1995 Toyota 4Runner

2 Answers

Noisey Clutch accelarating in 1st and 2nd gear


Sounds like its not sticking to the flywheel instantly but skippng a little bit and the squeek could be the clutch plate springs groaning.If the clutch and flywheel have been used hard it could have a heat glaze on it that resists grip Probably need to get flywheel machined when you eventualy change the clutch.

Oct 13, 2008 | 2000 Volkswagen Golf

1 Answer

Transmission shifting into nuetral


Check your fluid level. If the fluid level gets low, the pump basically pumps the pan dry in which the trans. valve body has no fluid to direct to keep in engaged in gear. Check your fluid level while running at operating temp. in nuetral. If this checks out ok, the trans. clutches are worn out to the point of the trans. no longer has the ability to stay engaged.

Jul 13, 2008 | 1991 Isuzu Trooper

Not finding what you are looking for?
2003 Nissan Maxima Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...