Question about 2001 Chevrolet Silverado 1500

Open Question

Winshield wipers wont work on low

Winshield wipers were froze down and now wont work on low but will on high

Posted by Anonymous on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: winshield wipers stick

Had the same problem on my '92 and 97. on the wiper motor there is a front cover held by a center screw... remove the cover there should be a small computer circuit board... disconect and replace... the cards are known to fail and a new replacement part, not a used one. they all fail on the older models.. new one has corrected the issue with the card... hope this works;;

Posted on Jan 03, 2009

  • 40 Answers

SOURCE: windshield wipers work intermittent

Typical problem is the pulse board on the wiper motor fails on this year of truck. I have had both a 97 and 98 K1500 and had to replace on both. Sometimes the wipers would work, sometimes they would quit when I was driving. Part is less than $50 at auto parts stores. Follow the instructions included. Requires removing 4-5 torx (star) head screws. Takes less than 10 minutes.

Posted on Feb 02, 2010

  • 3600 Answers

SOURCE: 2002 Trail Blazer. Wipers work on low and high

the switch is bad replace it, it is a common problem costs about $60.00 and has two screws holding it on. you can get it at auto zone Shucks or Orilays or checker auto or pep boys.

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Winshield wipers wont work

Hi Cindy,

It sounds like the gears in your wiper motor are stripped. The fix would be to replace the wiper motor.

Dec 07, 2011 | 1999 Saturn SL

1 Answer

Winshield wiper try to move but wont, the last time they worked was on high. when ignighton is turned on wipers jumps like they are trying to work.. during this time the wiper motor is very hot.

Thanks for choosing FixYa and welcome to the site. It sounds like your transmission in the wiper motor is slipping or broke. I would think you probably need a new one. But before, check your fuses. It could also be your actual wiper switch that is broke. But hearing what you said, I would think it is the motor.

Apr 18, 2011 | 1998 Buick Park Avenue

1 Answer

Windsheild wipers work only on the low speed

check the winshield wiper fuse sometimes they have a high low wiper fuses otherwise they can be known for the winshield wiper delay switch to go out

Nov 21, 2010 | 1993 Ford F350

1 Answer

99 yukon brake lights will not work, repllaced brake light switch still wont work

Had the same problem on my Yukon, I had to get the winshield wiper switch (controls cruise control, turn signal, and winshield wipers) replaced. This switch controls the hazards as well.

Nov 06, 2010 | 1999 GMC Yukon

1 Answer

On a 2002 dodge ram 1500 truck the brake lights and the turn signals and winshield wipers dont work the only brake light that works is above the cab. and the turn signal flashes on the dash like they are...

I suspect a bad multi function switch located in the left hand side of the steering column. This switch controls your high/low beams/wiper delay/windshield washer/turn signals and hazards.

Dec 31, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Winshield wipers just stopped working

put wipers on high check voltage at motor if theres volt. at motor and its not working motor is defect,if theres no volt. check wiring circuit!

Jun 22, 2009 | 1992 Toyota Tercel

1 Answer

1999 pontiac bonneville winshield wipers

Likely you don't have the blade arms adjusted properly. Also, make sure that the motor has a good ground or it will not "park" when turned off.

Feb 19, 2009 | 1995 Pontiac Bonneville

1 Answer

How would I adjust the stop position for my winshield wipers that recently froze to my winshield and began stopping in abnormal positions.

take them off and reclock them what has happend is the stud peice has turned in the wiper assembly its self orit bent and internal rob just reclocking themby removing and replacing will work for a long time if it is just one of the 2

Dec 29, 2008 | 2001 Dodge Ram 2500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides