SOURCE: fuse panel location and diagram 2000 chevy malibu
if the car is built like monte carlo for 2000 there are 2 fuse panels inside. one on the driver side when you open door and theres one the passenger side when you open the door there are panels on both sides of the dash that pull off. and then of course there are the fuse blocks under the hood. by the battery.
SOURCE: 93 silverado 2500need free online mechanical diagram of doors
GM Full-Size Trucks 1988-1998 Repair Information
Doors - REMOVAL & INSTALLATION
R/V Series
See
Figures 1, 2 and 3
If the door being removed is to be reinstalled, matchmark the hinge
position.
Fig. 1: Door hinge-R/V Series
Fig. 2: Door hinge components-C/K Series
Fig. 3: Removing the hinge spring
C/K Series
To install:
ADJUSTMENTSee Figure 4
The holes for the hinges are oversized to provide for latitude in
alignment. Align the door hinges first, then the striker.
C/K series utilize hinges that are welded to the door and frame. No
adjustment is possible except when replacement hinges have been
installed.
Fig. 4: Door adjustment check points
If the door has not been removed, determine which hinge bolts must be
loosed to effect alignment.
Be sure that there is no binding or interference with adjacent
panels.
R/V Series:
Door edge-to-rocker panel: 6mm
Door edge-to-roof panel: 5mm
Door edge-to-rear pillar: 5mm
Door edge-to-front pillar: 2mm
C/K Series:
Door edge-to-rocker panel: 6mm
Door edge-to-roof panel: 6mm
Door edge-to-rear pillar: 4mm
Door edge-to-front pillar: 7mm
Door front edge-to-fender: 5mm
Shims may be either fabricated or purchased to install behind the
hinges as an aid in alignment.
Hope this help, TY for using Fixya (remember comment and rated this). Good luck.
Testimonial: "very helpful just needed abit more info. thx "
SOURCE: I need a diagram of fuse box for 2000 Chevy Express Van
i have a 2000 Chevy van where is the fuse for the two(2) rear power outlets
404 views
Usually answered in minutes!
×