Question about 2004 Saturn VUE

1 Answer

P2019 intake manifold runner position sensor/switch circuit bank 2

Engine acceleration intermittently cuts out at highe speed (50-60mph).

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Saturn Master
  • 17,155 Answers
Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: I have a saturn sl2 1998 5 speed that idles too high. Aprox.2000

i had the same problem, much money spent for nothing, it ended up being the temperature sensor on the side of the block, advance auto, had the part for 10 bucks,

Posted on Feb 24, 2009

juggernautxt
  • 145 Answers

SOURCE: Code: P0133 - O2 Sensor Circuit Slow Response Bank 1 Sensor 1

is this a 4 or 6 cylinder?
if a 4 cylinder it will only have 2 o2 sensors
V6 will have 4 o2 senors which the sensor will be the right side of the engine first sensor.
1st sensor on exhaust, I recommend if you change one change all, as this will make the computer when it rechecks the system you have all clean/fast responding sensors.

if you have a slow response it means the sensor is dirty and not reading well, which is usually caused by minor misfires that the engine computer dismisses, so a tune up would be recommended too.

Posted on May 06, 2009

  • 3600 Answers

SOURCE: I have 2004 GMC ENVOY XL the engine light stay on.

P1133 is a slow 02 sensor or a shorted to ground at the PCM to 02 sensor signal. If the 02 sensor does not cycle fast enought it is called a lazy 02 sensor, the only way to test for this is with a digital volt meter or a scanner. if it will not pulse fast enough it will throw the code so Replace the 02 senor on the driver side bank. Bank one. then clear the codes. The code is thrown do to seveal reasons the 02 sensor could be dirty or it just could be worn out, you could pull it and clean it and try it again or just replace it and be done with it. The cost of a heated 02 sensor is $50.00 at a auto parts store or the dealer might charge a little higher but the cost in savings of fuel is well worth it.

Posted on Jul 09, 2009

Testimonial: "thanks for the info it was very helpful. truck is woking well. THANK"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why does the clutch slip intermittently on my Audi A4 2009 Diesel in high gears


Agreed. The clutch disk is likely worn. The pressure plate is self adjusting so there is no adjustment available on stock Audi pressure plates or indeed in most pressure plates.

Another possible cause is a leaking rear main engine seal that is allowing engine oil to seep and then be thrown around the bell housing and work its way onto the flywheel/clutch/pressure plate.

Test you clutch in 3-4 gear acceleration from a slow speed...if the engine speed flares faster than the car accelerates, you have a worn/bad clutch.

Mar 22, 2015 | 2004 Audi A4

1 Answer

A sudden loss of power like the engine was turned off (or short in electrical system suppling power to plugs), then, a slight surge, power restored. 'Short' is intermittent. Occurs at high speeds, but more...


It is possible, in fact likely, that your ECU (main computer) is failing. Less likely, you may have a bad oxygen sensor or other bad sensor. Best first step is take the car to your local auto parts store and have them use an ODB reader to determine the error causing your Check Engine light to be on.

Apr 09, 2014 | 2000 Toyota Avalon

1 Answer

When accelerating fast the engine cuts out suddenly then returns to normal multiple times. If I try to accelerate at a lower pace then it works fine. It feels like an electronic problem


Engine ECU is provided with a high RPM ignition cut off. Perhaps that is what is confusing you. When you accelerate at a fast rate, probably you get higher RPM's and the ECU cuts the ignition to protect the engine from damage.

Nov 19, 2013 | 2003 Nissan Altima

1 Answer

92 NISSAN WITH BOGGING AT 2800 3500 RPM AND AT LEVEL SPEED 4CYL AND 5 SPEED


For this types of problem,there are few help inks to troubleshoot the problem.Click the link below to go through the troubleshooting procedure to resolve the issues :----Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html-----------van idles rough? http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html
--------------runs lean and idles rough? http://technoanswers.blogspot.in/2012/02/ford-runs-lean-and-idles-rough.html
-----------Car still runs Rough after tune up? http://howtobyme.blogspot.com/2011/12/car-still-runs-rough-after-tune-up.html
------------Idle flair is noticed on car? Rough idle? car will not idle? Erratic idle speed? http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html
----------High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html
------------Engine Backfires? http://technoanswers.blogspot.in/2012/02/jeep-backfires.html----------- Nissan stalls and bucks on Acceleration?

http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

-----------
Nissan Pathfinder Backfires? http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-backfires.html
---------How to adjust rpm? http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
------------Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html
----------This will help.Thanks.

Feb 17, 2012 | 1992 Nissan Pickup

1 Answer

Engine intermittently suddenly cuts out at low speed when foot is removed from accelerator. Car is an automatic Jaguar xjr (2007). Amber engine management light comes on. Restarting engine, clears the...


Hi it may be an air sensor, air mass sensor.

When you ease off the power they often cut out with this fault. Try cleaning the air mass sensor with carb cleaner, its a easy job. let me know if you are unsure where it is and I will talk you through it.

Regards
Dan

Feb 10, 2010 | 2005 Jaguar X-Type

1 Answer

Engine stuttering 1993 taurus 3.0


give it a tune up and change the fuel filter!!!

Apr 16, 2009 | 1993 Ford Taurus

1 Answer

Will cut out at speed. And then starts again.


boost too high,theres a boost cut out that interupts the engine by cutting out split seconds to stop overboosting,is it stock or has there been mods done

Mar 07, 2009 | 1995 Subaru Impreza

1 Answer

Intermttent vibration front end at high speeds


Vibration during acceleration is probably from axle going bad. Intermittent vibration at high speed could be a loose piece of plastic under the car or in the wheel well.

Aug 10, 2008 | 1992 Mazda MX-3

Not finding what you are looking for?
2004 Saturn VUE Logo

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...