Question about 1998 Pontiac Grand Prix
The indicator light comes on and off and beeps telling me the back drivers door is open, but it's not.
Check the switch on the door frame. IT might be bad or have a loose wire behind it. If that is not the case, the wire might be shorted in the body somewhere. It might also be the BCM and those are not cheap.
Posted on Feb 09, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
After you adjust the tire presuure you must drive the vehicle for a few miles then look at the gage again/ you can also disconnect battery for 15-20 minutes. Please rate my response Thank you very much
Posted on Jan 28, 2009
Posted on Oct 17, 2009
Hello! This indicates a fault with the wheel speed sensor/ABS sensor. Any major auto parts retailer can pull the details of this code (which sensor) for free, which will help you identify if the wiring is loose or damaged or if the sensor will need to be replaced. If you need to replace the sensor - you will need to replace the entire wheel bearing assembly, as the sensor is internal.
Thanks for using FixYa!
Posted on Nov 02, 2009
SOURCE: code P0442 on a 2000 grand prix
That means that there is a fuel evaporation leak detected in your fuel tank. Generally this means that your fuel cap is loose- go tighten it and see if the code goes away after driving your vehicle for awhile. The problem can also be holes in the evaporation hoses...but not likely.
Posted on Feb 22, 2010
Just an philips screw, you'll need to remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them.
If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door.
Hope helped with this (remember rated this).
Posted on Mar 09, 2010
Tips for a great answer:
Jan 30, 2017 | 1999 Pontiac Grand Prix
May 30, 2015 | 2003 Pontiac Grand Prix
Mar 21, 2014 | 2005 Jeep Wrangler
Nov 15, 2012 | 1998 Pontiac Grand Prix
Jul 20, 2011 | 1998 Dodge Grand Caravan
Press and hold down both the lock and unlock buttons for fifteen seconds and listen for the beep which will signal that the fob has been programmed. Continue this for all existing and new fobs, you will be able to program four remotes to your Grand Prix and will have to do them all at once due to the memory being forgotten every time you enter Programming Mode. Once you have programmed all of the remotes and heard a beep for each one programmed, remove the key from the ignition to exit Programming Mode. You are now free to test your fobs and ensure that they all work.
Apr 02, 2011 | 2007 Pontiac Grand Prix GXP Sedan
May 06, 2010 | 2007 Pontiac Grand Prix GXP Sedan
Oct 28, 2015 | 1998 Pontiac Grand Prix
Feb 07, 2015 | 1998 Pontiac Grand Prix
41 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: