Question about Cars & Trucks

1 Answer

REVERSING CAMERA PROBLEM

CAMERA WORKS WHEN ENGINE NOT RUNNING AND WHEN ITIS RUNNING IT IS INTERMITANT

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 65 Answers

Will be a contact problem with the wireing.

Posted on Feb 09, 2014


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 Caddy Van, 1.9tdi. When accelerating it will sometimes shudder, almost like a rev limiter, plus loses power / cuts out at low speeds.


I'd start with a thorough check of all your engine area harness connections making sure the multi plugs are properly home. Then any ground cables for a good clean connection. Has it had any work recently that could lead to a trapped part of the harness? I can't say whether the poor running is part of the electrical gremlins but as most engines have lots of electrical devices, who knows.

Aug 14, 2016 | Cars & Trucks

1 Answer

My ford focus speedo only works intermitently when this happens the car seems to run lumpy


I would say, get the fault codes checked, the engine need the speed signal, to run properly , so take it from there.

Feb 27, 2015 | 2005 Ford Focus

1 Answer

Intermitente starting problems & transmission seemed to go out the other day while driving it


sounds more like an engine issue off the top of my head. The transmission runs off the vacuum from the engine. If the engine timing chain is stretched it will run then not run, have problems idling and shifting and won't charge the battery properly. anyone who has done one before could probably tell you just by the sound of the engine running.

Feb 26, 2014 | 1998 GMC Jimmy

1 Answer

Lost reverse gear and drive after towing across state


You cannot tow a auto is what i was taught at college 40 yrs ago and the rule is still the same and no doubt as ity has no rear pump in the box only certain older cars had this then you effectivly run the gearbox with no oil circulating causing i wouldnt like to imagine all sorts of damage internally

Dec 31, 2012 | 1995 Ford Aspire

1 Answer

Ford focus 1.6 tdci 05 plate-intermitting oil light


I believe your oil pump is not working, Please do not start the car anymore or your engine will suffer severe engine damage, have it towed to your mechanic.

May 28, 2010 | 2005 Ford Focus

2 Answers

A604 CHRYSLER TRANS WILL NOT MOVE IN FORWARD OR REVERSE INTERMITANTLY. CLUTCHES ALL LOOK GOOD AND PISTONS ARE WORKING WITH AIR PRESSURE APPLIED.


Did you check the pump pressure? If you have a problem with the pump or the relief valve and its not putting out a constant pressure ( what ever spec is ) then you will have that problem.

Mar 08, 2010 | 1997 Chevrolet Tahoe

1 Answer

Changing speedo cable on peaugot 306 m reg


Note: On later models an electronic transducer providers road speed signals to the speedometer and engine management system and speedometer drive cable is not fitted.

1, Working in the engine compartment, pull the cable securing pin from the gearbox/transmission housing. then release the end of the cable from the gearbox.

2, Pull the speedometer cable sharply to release the cable ball from the locating grommet in the bulkhead.

3, Pull the cable through the bulkhead grommet into the engine compartment, and withdraw it from the car.

4, REFITTING, is reversal of the removal, but coat the cable ball with some soapy water( eg washing up liquid) to aid refitting, and ensure that itis correctly located on the bulkhead grommet.

I hope this as helped!!

Jul 22, 2009 | 1995 Ford Aspire

2 Answers

Chevy 350 express van 2000 runs great idles rough


If it does not do it in park or neutral, it could be a number of things. One being a sticking Torque Converter Clutch solenoid (TCC). It could be that it needs a simple tune-up. How often does this problem happen?

Jun 29, 2009 | 1996 Chevrolet Suburban

1 Answer

Reverse lights


reverse lights are on while in drive.98 envoy

Aug 25, 2008 | 1999 Nissan Frontier

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...