Question about Cars & Trucks

1 Answer

2003 vw bettle will not tach over 3000

No throttle respons

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 103 Answers

Check the throttle position sensor.

Do you get the same result on/off the road?

Posted on Feb 08, 2014

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ginko
  • 19396 Answers

SOURCE: 03 vw bettle serptine belt

Replacing the serpentine belt on a New beetle is not easy as it was on the old one.

First you need to remove the Water tank, and undo the hoses near to the water tank.
Then you remove the three bolts securing the tensioner with a 13mm socket wrench, and release the tensioner.
Then you replace the belt.

The procedure is explained here on pages 2 to 5
, do not go over page 5, the rest of the procedure is on replacing the timing belt, and you risk to damage your car by touching the timing belt.

Once you replace serpentine belt, ensure that the pumps is running, that the belt is well in tension, and that is solidly there, not slipping out.

All the repairs must be done or supervised personally by a qulified mechanic.

Regards.


Posted on Dec 16, 2008

  • 14036 Answers

SOURCE: How do i remove the air bag on my 2005 vw bettle?

TURN IGNITION SWITCH OFF.MAKE SURE RADIO IS OFF SO YOU WONT LOSE CODE.DISCONNECT NEGATIVE BATTERY CABLE.WAIT AT LEAST 10 MINUTES BEFORE REMOVING AIR BAG.LET THE AIR BAG BATTERY BACK UP POWER. DISCHARGE.BECAREFUL HANDLING AIR BAG. DONT CARRY IT BY IT WIRES.WHEN CARRYING IT.HOLD IN BOTH HANDS SECURLY.WHEN LAYING IT DOWN .BESURE THE BAG AND TRIM COVER FACING UP.BESURE TO KEEP KIDS AND PETS AWAY. BECAUSE AIR BAG CAN STILL BE DEPLOYED.SO BE CAREFUL.

Posted on Jun 16, 2009

alicantecoli
  • 22095 Answers

SOURCE: vw bettle driver side crash sensor location

never heard of theis but yes it sounds right ,i would look in the door or the door pillar

Posted on Dec 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 2.0 vw bettle. When it warms up, it will die when I give it gas. I have replaced the maf sensor already and still the same out come


Source of this can be low fuel pressure (have it tested under a load) and a defective Throttle position sensor (test with a DVOM meter). Google "how to test a TPS"

Jul 10, 2016 | Cars & Trucks

1 Answer

Mileage not showin on my 01 vw bettle


how to change my oil pan in my 2001 vw bettle bolt wont come out .

Jun 26, 2012 | 2001 Volkswagen Beetle

1 Answer

2001 vw bettle, the car cuts of when u press the gas pedal but will run in idle


that sounds like a bad throttle position sensor, do you have a check engine light?

Jul 04, 2011 | 2001 Volkswagen Beetle

1 Answer

I have to keep charging the battery on my 2001 vw bettle


Please check on the link below for tips if the battery is draining off;



http://www.fixya.com/cars/r5824824-draining_car_battery_charge
Please make sure that the battery is not weak or the alternator is working with the required output.

Jul 02, 2011 | 2003 Volkswagen New Beetle Convertible

1 Answer

Replacing front wheel bearings on 2002 new bettle


how to change rear wheel bearing on vw. beatel 2002 1.9

Dec 18, 2009 | 2001 Volkswagen Beetle

2 Answers

Vw bettle driver side crash sensor location


never heard of theis but yes it sounds right ,i would look in the door or the door pillar

Dec 03, 2009 | 2003 Volkswagen Beetle TDI

2 Answers

I have a 2001 vw bettle and it has a ticking in it i had new time chain put on but it still ticks and the o2 sencor is messing up where can i go now vw mech are not fixing it


Cam folowers are worn.Any good garage will change them for you.You realy need to get this repaired.The followers are sticking holding the valves open.And thats messing up your o2 sensor.

Jul 17, 2009 | 2001 Volkswagen Beetle

1 Answer

03 vw bettle serptine belt


Replacing the serpentine belt on a New beetle is not easy as it was on the old one.

First you need to remove the Water tank, and undo the hoses near to the water tank.
Then you remove the three bolts securing the tensioner with a 13mm socket wrench, and release the tensioner.
Then you replace the belt.

The procedure is explained here on pages 2 to 5
, do not go over page 5, the rest of the procedure is on replacing the timing belt, and you risk to damage your car by touching the timing belt.

Once you replace serpentine belt, ensure that the pumps is running, that the belt is well in tension, and that is solidly there, not slipping out.

All the repairs must be done or supervised personally by a qulified mechanic.

Regards.


Dec 16, 2008 | 2003 Volkswagen New Beetle Convertible

1 Answer

No fuel response control respone


check mass air flow volt at idle

Oct 09, 2008 | 2003 Jaguar S-Type

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...