Question about Cars & Trucks

1 Answer

545rfe oil level is too high,how to regulate - Cars & Trucks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 103 Answers

The oil LEVEL is too high, or the oil PRESSURE is too high?

To lower the oil level, just drain some off. Doing this will naturally lower the oil pressure, as well.

Posted on Feb 08, 2014

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

oneStan
  • 430 Answers

SOURCE: 03 jeep gr.cher.

There is a temperature sensor in the transmission to allow overdrive to work once the temp reaches a certain point. This is mainly to aid in getting the engine & trans to operating temperature, you could have a weak sensor or it could just be taking a while to warm up. Sensor is accessible without removing the trans.

good luck

Posted on Feb 15, 2010

  • 1453 Answers

SOURCE: Looks and smells like gas in the oil. The oil

Unlikely it's the regulator causing fuel to be dumped into your oil. A stuck open or leaking fuel injector would dump fuel into your oil.

Posted on Jan 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where do one add auto transmision oil to a jeep grand cherokee 3.7l petrol model and what type do one use


The transmission on this truck is sealer, it doesn't have a fill tube or dipstick. To add fluid requires a scanner be hooked up to monitor fluid temperature and a special fill port used under the truck to add fluid.

Sep 13, 2016 | 2002 Jeep Grand Cherokee

2 Answers

I have a 1994 chevy silverado c1500 v/6 4.3 litre and failed smog for high hc levels st idle . what should i do before i take it back to try and smog? ive already done complete tune up.


as long as you have no check engine light on change oil, air filter. pep boys sells a product called guaranteed to pass add to fuel make sure car is hot when you go back for emission test cold car has high hc levels it also helps to post the hc level you tested at and the limit on your receipt hope this helps

Apr 08, 2016 | Cars & Trucks

1 Answer

How to change a fuel filter on a polo vivo 2010


Engine oil: Drain or extract and replenish; renew oil filter Engine oil: Drain or extract engine oil ? Chapter. Renewing oil filter ? Chapter. Replenishing engine oil ? Chapter. Draining or extracting engine oil Special tools and workshop equipment required t Used oil collection and extraction unit -V.A.G 1782- t Oil spill cloth -VAS 6204/1- Draining or extracting engine oil Carry out the following procedure: > Note
t For engines with standing oil filter the oil filter must be renewed before changing the engine oil. When removing the filter element a valve is opened, the oil in the filter housing automatically flows into crankcase. t If the engine oil is drained and not extracted with an oil extractor, replace drain plug. This prevents leaks. t Observe disposal regulations! - Extract engine oil using used oil collection and extraction unit -V.A.G 1782-. or - Remove oil drain plug. - Let engine oil drain. > Note
t The oil drain plug is fitted with a secure seal, therefore the oil drain plug must always be renewed. t Observe disposal regulations! - Screw in new oil drain plug with seal hand-tight. - Replenish engine oil, specification ? Chapter. Engine oil capacity: "Power unit" ? Power unit; Rep. Gr.17"Lubrication; oil capacities" or ? Maintenance table. Specified torques for oil drain plug: t Petrol and diesel engines 30 Nm > WARNING
t Torque specifications must not be exceeded. t Excess torque can cause leaks in the area of the oil drain plug or even damage. Renewing oil filter Renewing oil filter, 1.4 l and 1.6 l injection engines > Note
t Prevent engine oil from dripping onto components in engine compartment. t Oil new O-rings before installing. t Observe disposal regulations! Renewing oil filter, 1.4 land 1.6 l engine Carry out the following procedure: alt="W00-10211"> - Unscrew cover cap -1- with socket insert 36 mm AF and remove cover with oil filter insert -4- and valve -5-. - Renew O-ring -2- of cover cap and O-ring -3- of valve. - Renew used oil filter element with new filter element. > Note
Observe disposal regulations! - Tighten cover cap -1-. Cover cap torque setting: 25 Nm. Replenishing engine oil Oil specifications ? Chapter Engine oil capacities: "Power unit" ? Power unit; Rep. Gr.17"Lubrication; oil capacities" or ? Maintenance table. General notes > Note
Observe disposal regulations! - After replenishing with oil, wait at least 3 minutes and then check oil level. - Pull out dipstick, wipe with a clean cloth and push dipstick in again to limit stop. - Pull dipstick out again and read oil level. alt="N01-10183"> For dipstick as illustrated: A - Oil must not be replenished. B - Oil may be replenished. It may happen that the oil level afterwards is in the -A- region. C - Oil must be replenished. It is sufficient if the oil level is in the -B- region (hatched area) afterwards. There is a danger of damaging the catalytic converter if the oil level is above the -A- marking. - If oil level is below -C- marking, top-up oil to -A- marking. alt="N01-10255">
25567142-tnzdbwhiaswbtdy3r1p2vgzs-2-2.png

Mar 14, 2015 | Volkswagen Polo Cars & Trucks

1 Answer

Grand Cherokee Laredo Model 2000 Transmission Oil Quantity


Transmission 42RE Mopar ATF +4, type 9602 = 4-6 qts. (service) Transmission 45RFE or 545RFE Mopar ATF +4, type 9602 = 5.5 qts. (2WD) ATF+4 full synthetic

May 27, 2014 | Cars & Trucks

1 Answer

Oil level on mark when engine is cold, way high when running


Are you pulling the dip stick out with the engine running to check the oil level? You are only suppose the check the level when the engine is off. Oil level is high and in accurate while engine is running due to the oil pump pumping oil around the engine. :p

Apr 07, 2014 | 1992 Honda Accord

1 Answer

Oil psi is still high


now when oil is already in you have to find out some way to take some oil out (Pump at services or at some petrol station )Next time you change oil put about lowest level of gauge and wait 1/2 h.usually it will be enaugh because it takes time oil goes to carter.

Apr 23, 2012 | Pontiac Bonneville Cars & Trucks

1 Answer

Looks and smells like gas in the oil. The oil level is high on the dipstick and very thin. Think its the fuel pressure regulator?


Unlikely it's the regulator causing fuel to be dumped into your oil. A stuck open or leaking fuel injector would dump fuel into your oil.

Jan 08, 2011 | 1993 Jeep Grand Cherokee

1 Answer

Oil level shows about 1.5 qts high oil changed 6


If you added oil level before engine was warm
Then when engine is warm you recheck the level
Oil Expands with heat
let it cool down and then re-check if its too much drain a touch off.

Jun 23, 2010 | 1998 Ford F150 Regular Cab

1 Answer

03 jeep gr.cher. 4.7 HO 545RFE tranny when cold it takes tranny 5 - 10 min to shift into overdrive once warmed up everything works flawlessly. oil level is good. otherwise no problems at all, no slipping,...


There is a temperature sensor in the transmission to allow overdrive to work once the temp reaches a certain point. This is mainly to aid in getting the engine & trans to operating temperature, you could have a weak sensor or it could just be taking a while to warm up. Sensor is accessible without removing the trans.

good luck

Feb 15, 2010 | 2003 Jeep Grand Cherokee

1 Answer

High Hydrocarbons cant pass emmissions test 1994 Jeep 5.2L. I changed plugs, oil, PCV valve, temp. sensor. oil filter. Truck has 112000 miles. Engine runs very strong. I lowered the fuel by regulating the...


If you changed the battery or it went dead before your test ,it reset you history you will have to drive it a couple of weeks to update you emission control module then have it retested

Mar 13, 2009 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...