Question about Mazda B2200

Open Question

How to tighten power steering belt on a mazda e2200 van

When pulling off my van squeels and the power steering/alternator belt is loose, how do i tighten it.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 98 Answers

SOURCE: power steering noise

The belt is almost assuredly to tight and needs to be loosened just a hair. It is hard sometimes to get the tension just right. Try looseneing it a bit and hopefully that will help. I have had the same problem in the past.

Posted on Feb 28, 2009

  • 423 Answers

SOURCE: Replacing 2 belts on a 2000 Mazda Protege

I recommend that you go to any Auto Parts store and by a repair user manual for your 2000 Mazda Protege.  They have pictures and arrows and stuff that you will need to do the whole job.  The non-Mazda version will cost approximately $15.00.
Because of the tensioner that may come off when while you are doing these belt changes, it is too complicated to talk you through this.
But with the manual, I am confident you can change them.

Posted on Apr 16, 2009

  • 420 Answers

SOURCE: sounds like a loose belt.

Most surpentine belts have an atomatic tensoner. I have had 2 fail on different cars and it is a simple fix, both of them required removal of one bolt.

Posted on Jul 16, 2009

jim9813
  • 124 Answers

SOURCE: squeeling belt, have replaced idler pulley,

Try using a very small spray of silicone spray on the belt next time you're hearing the squeal. If it temporarily stops, replace the belt. Check the p/s fluid level, if it's low it could cause the pump to make noise. Also if it's low, you have a leak, check all lines, connections and pull back the bellows boots on the p/s rack (if rack and pinion). Finally, pick yourself up a mechanic's stethescope, good tool for diagnosing accesory noises. Listen to all components while duplicating the noise.

Posted on Aug 04, 2009

  • 548 Answers

SOURCE: how do you tighten the belt on a 99 mitsubishi

yes it is the serpentine belt and there is only one and you need to make sure it is on properly and that it is on the idle tensioner pully andd you have to loosen the tensioner to put the belt on and tighten it to tighten the belt look for a belt schematic on the engine compartment area of your car near the front or sodes on the upper outer area where the hood comes opver the comparment

Posted on Sep 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Belt slip


Tighten your serpentine belt.

Apr 12, 2014 | Chevrolet Uplander Cars & Trucks

1 Answer

Serpentine belt is loose. How do I tighten it?


I bet the belt is also cracked and should be replaced before it fails most cars have a tension bolt you tighten to tighten the belt, and when removing the belt simply loosen slide the old off stay aware of routing and then slip the new on tighten to specs

Feb 18, 2014 | Daewoo Lanos Cars & Trucks

1 Answer

Steering pump belt adjustment


some bolts do have a nut on the other end.. some go into threaded holes on the pump itself..if it tightens then just make sure the belt itself is also and check everything else while it idles..

Dec 27, 2013 | Cars & Trucks

1 Answer

How do you tighten the fanbelt on a mazda E2200 panel van


see the generator in the engine the fan belt goes around it there is a iron strip attached to the generator which holds the generator loosen this screw a bit and pull the generator with an iron bar or some thing that can when the belt is tight tighten the screw

Jan 29, 2011 | Mazda B2200 Cars & Trucks

5 Answers

My power steering goes and comes, loud squeeling noise when I try to turn the wheel, gets worse when I steer goes away when steering is straight. Just started happening all of a sudden after bumpy ride...


this peice belongs to your power steering pulley its a plastic o\piece that over time brakes off you can either call your dealer and see if its covered by your warranty because its has to be replaced the pats that the plastic belongs on is top pulley you 'll notice powersteering wheel hard to steer and squeeling you must replace part or adjust it so its holding pulley tight itshas grooves in it 2 as a matter of fact if you keep using this pulley with broken plastic it could brake your belt

Jan 24, 2010 | 2006 Suzuki Grand Vitara

2 Answers

Power steering squeel


This is not an unusual problem with power steering and is most frequently caused by a worn belt on the power steering pump. Check the belt and replace if needed. Also check the power steering fluid level and top it off.

Dec 22, 2009 | 1996 Geo Prizm

1 Answer

How do I replace the alternator belt on the 95 mazda mpv 6 cylinder van ?


Locate the alternator, there should be a adjustment bolt on top, loosen it so the alternator can slide to get the belt loose, remove the belt, put the new one the same way as the old one was, then use a bracket or strong screwdriver to slide the alternator back to make the belt tight again, belt should not bend more then 0,5 cm or 1/4 of the inch when pressed with fingers, tighten the bolt on the adjustment.

Oct 06, 2009 | 1995 Mazda 626

2 Answers

2000 Mazda Protege replace belts


change the new attentioner,u can,t tight

Nov 29, 2008 | 2000 Mazda Protege

1 Answer

1997 MADZA MVP


sounds like your altonator belt is loose and needs tightened. if you put a new belt on with the altonator it just needs re adjusted..

Oct 18, 2008 | Mazda MPV Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...