Question about 2007 Hyundai Atos Prime

Open Question

Transmission band adjustment

Where is the band adjustment for the automatic transmission on Hyundai atos and hoe do you adjust the bands

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 11 Answers

SOURCE: on a manual transmission 2000 hyundai elantra

nope if the clutch slips it needs to be replaced

Posted on Feb 06, 2009

Ad
csmock132
  • 4669 Answers

SOURCE: Service band adjustment for 1995

Are you talking about the transmission band? If you aren't having a problem, don't worry about it. If you are having a problem, describe the problem, maybe I can help.

Posted on May 04, 2009

ghost45
  • 1280 Answers

SOURCE: my 2001 hyundai sonota gls jerks at times when driving at speeds

There is no band adjustment procedure on the 2001 Sonata. Fluid replacement is no guarantee of repair. First of all, have you checked the TCU (Transmission Control Unit) for any DTC's? (Diagnostic Trouble Codes). Has the "Check Engine" light come on when this problem occurs? If so, find an OBDII scanner and check the system for any trouble codes. It may not be what you suspect... it could simply be a defective fluid temperature sensor or a solenoid which has gone bad - these can be replaced without spending gobs of money.

Posted on Sep 07, 2009

Testimonial: "Thanx very much. I will do the checks. I have a repair book but just can't find it at this time. This nfo was very helpful to me thanx again"

  • 40 Answers

SOURCE: Hyundai atos 1.1 2004, 100,000 what parts must be replaced

if it has one, the timing belt should be done, along with a tune up. spark plugs air filter, fuel filter. etc

Posted on Jan 02, 2010

alicantecoli
  • 22156 Answers

SOURCE: can the bands in a automatic gearbox out of a

honestly do not know ,used to do it on the old C4 and borg warner boxes ,have a look for any adjusters on the outside ,then drop sump and have a look up from underneath

Posted on Jan 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a transmission band adjustment or not on 09 matrix for 4th gear


automatic transmissions have both band and clutch adjustments
take it to an accredited auto transmission special shop for the inspection and adjustment

Nov 01, 2016 | Cars & Trucks

1 Answer

Where are the adjusting band bolds in the Hyundai Santa Fe 2003 2.7. Automatic 4x4?


There is no adjusting band , that is older transmission like GM built and Ford.

Sep 24, 2016 | 2003 Hyundai Santa Fe

1 Answer

No reverse ranger automatic transmission


Loss of reverse gear in an automatic gearbox

Broken Reverse selector Band

Brake material on Selector band is Worn out

Selector band needs sever adjustment

Selector bands hydraulic piston seal had failed

Selector not getting oil to work the piston.

Apr 03, 2014 | 1998 Ford Ranger SuperCab

1 Answer

Automatic transmission service adjustments for 2000 mazda bravo


There should not need to be any "adjustments" for a normal fluid and filter service for your vehicle, unless you have replaced some parts of your transmission that requires adjustment such as the gearshift lever, intermediate and overdrive band, throttle cable, or transmission range sensor/switch.

With that said, the band adjustment specs are "Tighten the band adjusting screw to 10 Ft.Lbs. (14 N.m.) then back off 2 full turns. While holding band adjusting scew stationary, tighten the locking nut to 35-45 Ft.Lbs. (48-61 N.m.)

Jun 16, 2012 | Cars & Trucks

2 Answers

Where is the band adjustment on the transmission for a 1993 lincoln mark viii


Hello! The transmission in your Lincoln is the 4R70W...4R70W does not have band adjustments. it is a 4-speed automatic transmission with overdrive that is computer controlled..Th Manual Lever Position Sensor goes bad due to transmission fluid seeping into the sensor's connector..Send a comment if you require additional information or help..Guru...Saailer

Sep 29, 2011 | 1993 Lincoln Mark VIII

1 Answer

87 cutlass no reverse


foward and no reverse.In order for the reverse to happen there is a transmission brake assemble,the transmission band holds the brake assembly thus allowing fluid to be driven according to gear selection, when no reverse happens there is a malfunction of mechanical or hydraulic part, Depending on the condition you can adjust the kick down or adjust the band. A general procedure for automatic transmission band adjustment involves tightening the band adjusting screw to a given torque sequence, back off the adjusting screw from turning while torque-tightening the adjustment screw about a 1/4 turn and lock down the lock nut,and recheck to see if reverse has been restored.

Apr 23, 2011 | 1987 Oldsmobile Cutlass Supreme

1 Answer

Automatic transmission band adjustment in a 1997 chevy blazer


I have a 1995 Chevy 1500 4.3 v6 trans bands need to be adjusted I have two out of the four gears. Reverse tends to slip but works. How do I adjust the bands. And what side are they on. I baught it as is.

Sep 20, 2010 | 1997 Chevrolet Blazer

2 Answers

Do you need to drain transmission fluid out,to do a band adjustment on a transmision?


The band adjustment on a 2008 model are done electronically and only automatics have bands for adjusting, but if it is an automatic and they are in need of manual adjustments then yes you will need to drain the fluid to be able to remove the pan and get to the adjusters.

Aug 26, 2010 | 2008 Dodge Ram Pickup 1500

2 Answers

1998 subaru band adjustment for auto transmission.


It is on the left side hard to spot. Look below the heater hoses. Good luck, take your time and have a great day.

Jun 26, 2009 | 1998 Subaru Legacy

2 Answers

Automatic transmission band adjustment


Don't have specs on band but the rule is that it should be close enough to the drum to engage without slamming, and loose enough to permit drum to turn without band dragging on it. Biggest problem I've seen people have when adjusting is that adjustment tightens down while turning lock nut. To avoid this, I usually adjust a bit looser than final adjustment so it tightens to correct position instead of becoming too tight. Don't drive 'till you have it right or you will burn band surface. When engaged in reverse, band should be applied and cannot drag. If you adjusted another band, check that one for improper adjustment.

May 10, 2009 | 1997 Jeep Wrangler

Not finding what you are looking for?
2007 Hyundai Atos Prime Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...