Question about Toyota Tacoma

Open Question

When I am driving with speed 20 until 30 with hold that speed car is start shake

170 it has a mil

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 979 Answers

SOURCE: My explorer shakes at driving of high speed

Something out-of-balance somewhere. Start with the tires, check the wheels, then have the driveshaft balance checked. Do any off-roading?

Posted on Jul 29, 2008

MrScary66613
  • 1990 Answers

SOURCE: shakes

Your Tires are Out of Balance. Get them Rotated and Balanced, Should fix Ya right up!

Posted on Jan 03, 2009

csmock132
  • 4669 Answers

SOURCE: 95 Bonneville won't start when hot

Yes I know, but If you hold the accelerator pedal to the floor on a fuel injected car, the Throttle position sensor will tell the computer to enter clear flood mode. Then the computer will shut off the fuel injectors while you have the pedal to the floor. If it is flooded, you should be able to get it started in clear flood.

Posted on Mar 09, 2009

  • 166 Answers

SOURCE: car jerks while holding a constant speed

You're not very specific. However, the common causes of this jerking six, and there is a great diagnostic article about it right here:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Transmission_System_Jerking_When_Engine_Accelerated_Transmission_First_Gear.htm

Posted on May 25, 2009

  • 1 Answer

SOURCE: Mazda 626 'HOLD' light after gear box oil seal was replaced

I have the same problem with my car I think its the torque converter clutch but you should visit a diagonestic machine just to find out

Posted on Nov 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause a a 2006 Saturn Ion Base 2.2L manual to have reduced power and a blinking MIL?


You most likely have a cylinder mis-fire. Usually a bad spark plug or ignition coil/ignition wire. Check the codes to determine what cylinder is causing the misfire and repair a necessary

Dec 29, 2015 | 2006 Saturn ION

2 Answers

1995 Ply Voyager 3.0 V6. Feels like the front passenger tire wobbles while driving above 20 mph on straight stretches. In a right hand curve (not turning, just a curve) at any speed the whole front end...


SOUND LIKE BAD WHEEL BEARING.SAFELY RAISE SUPPORT VECHICLE ON JACK STANDS,MAKE SURE VECHICLE PARKED ON SOLID LEVEL GROUND.GRAB WHEEL OR TIRE AT THE WITH ONE HAND TOP AND GRAB BOTTOM WHEEL TIRE WITH OTHER HAND,TRY TO SHAKE MOVE WHEEL IF WHEEL TIRE MOVES WHEN YOU SHAKE OR MOVE IT ANY.THE WHEEL BEARING MORE LIKELY BAD.IF WHEEL BEARING OKAY YOUR FRONT BRAKE ROTOR RUN OUT WORN OR WARPED.

Jul 21, 2011 | Plymouth Voyager Cars & Trucks

1 Answer

Good morning, I have a 2003 lincoln ls v8 and the check advance trac has come on dashboard and the car has begain to sway above 30 miles an hour and feels like the gas peddle is sticking


You have a MIL Lamp (mafunction indicator fault code
for the ABS Braking System)

It could be a Wheel Speed Sensor or a half dozen
other issues.

Don't drive it more than a couple days, until your
able to schedule a diagnoses and repair

Mar 14, 2011 | 2003 Lincoln LS

2 Answers

I have 2005 subaru forester. my engine shakes all the time especially when it is idle. when driving i dont feel the shake but when i stop it shakes. i have replaced my plugs but still shakes. also when i...


First step is to access the Engine Control Module (ECM) using diagnostic equipment connected to the data link connector of the car, in order to pull out all Diagnostic Trouble Codes (DTC) memored. Even if engine Malfunction Indicator Lamp (MIL) goes off after engine starting, it's possible to find out temporary DTC codes memored in the ECM. Then you will be full informed about bad components (e.g. bad heated oxygen sensor(s), cylinder(s) misfire(s), bad injector(s), bad ignition coil(s), ... etc). Therefore you will be able to repair & replace bad components and reset the ECM.
In the most cases when you smell something like rotten egg there are bad oxygen sensor(s).

Feb 01, 2011 | 2005 Subaru Forester

1 Answer

After driving the jeep for 20-30 min the front


it sounds to me like you need tie rods and hub assembly's and bushings

Mar 14, 2010 | 1994 Jeep Grand Cherokee

1 Answer

VW shaking


sounds like the fuel pressure regulator but first try new fuel filter and maybe clean spark plugs and reset them

Sep 23, 2009 | 1995 Volkswagen Jetta

3 Answers

Why does my 99 lumina start to shake after 20 mph


is the engine shaking or the whole car?If its the car (steering wheel) balance the wheels.

Apr 04, 2009 | 1999 Chevrolet Lumina

2 Answers

Mazda 626 'HOLD' light after gear box oil seal was replaced


I have the same problem with my car I think its the torque converter clutch but you should visit a diagonestic machine just to find out

Dec 06, 2008 | 1998 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...