Question about Mazda Cars & Trucks

Open Question

Mazda 3 2004 2.0lt oil pressure switch broken car no start

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 187 Answers

SOURCE: 1990 mazda mpv power steering pressure switch

You can try a junk yard or better yet the dealer for new.

Posted on May 09, 2009

  • 107 Answers

SOURCE: car wont start

there is a safty switch on your car to prevent run dry just add oil and car should start the oil pressure well reset the switch no need to worry simple fix good luck CJ

Posted on May 12, 2010

  • 1 Answer

SOURCE: location of oil pressure switch.

how change oil pressure sensor in 2001 mazda mpv dx

Posted on Apr 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a very bad oil leak around the pan of a 1997 mazda protege. where else could oil be leaking form.


you could have a bad oil pressure switch leaking oil,oil pan gasket,rotted out oil pan,head gasket leaking oil and running down the block.

Jul 04, 2011 | 1997 Mazda Protege

1 Answer

Truck starts runs for a second shuts off .


The fuelpump is primed by the oil pressure switch.When the fuel pressure reaches normal PSI the computer shuts that pressure switch off and turns thepoweron to the fuelpump relay.You have a bad fuel pump relay

Jun 02, 2010 | 1994 Mazda 2WD B Series Pickup

1 Answer

Car wont start


there is a safty switch on your car to prevent run dry just add oil and car should start the oil pressure well reset the switch no need to worry simple fix good luck CJ

May 12, 2010 | 2005 Mazda 6

1 Answer

Car low on oil and motor wont start. It cranks over but wont start. No oil lights have come on on dash board so had no idea it was low on oil;


Some cars, not sure about yours had a switch on the fuel pump, if the oil was low, they wouldn't start. Get the oil back up the re and see what happens. The oil sending switch must be for pressure and not level, it will register 60 lbs pressure with only 1 qt of oil in there, try it, hope it helps.

May 04, 2010 | 2004 Mazda 6

1 Answer

1992 mazda navajo oil gauge bounces


Could be a faulty oil pressure sender switch ( quite a common fault ) . Remove it and fit a mechanical gauge to test.
Much less likely ( if the test shows fluctuating pressure) the oil pressure bypass valve may be sticking. Make sure your oil is nice and clean, contaminants can sludge up the oilways. The bypass valve is usually in or near the oil pump on most cars.
My pick would be the switch.
Happy hunting!!

Apr 17, 2010 | 1992 Mazda Navajo

1 Answer

I have a mazda 626 it will turn over but it won't


If the timing belt or chain is broken, or if there is no oil pressure, the car will not start to protect the engine from damage. Check these two items.

Feb 27, 2010 | 1999 Mazda 626

2 Answers

Low oil pressure light is on on 2000 lexus rx300. Doesn't need oil or an oil change. Not leaking oil.


try replacing the oil preasure switch, if that doesnt solve your problem then have your oil preasure tested, if it really doesnt have oil preasure it will cause internal engine damage so start with the switch and then go from there, hope this is helpful.

Nov 29, 2009 | 2000 Lexus RX 300

1 Answer

1990 mazda mpv power steering pressure switch


You can try a junk yard or better yet the dealer for new.

May 09, 2009 | 1990 Mazda MPV

1 Answer

Location of oil pressure switch.


how change oil pressure sensor in 2001 mazda mpv dx

Apr 10, 2009 | 2001 Mazda MPV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...