Question about 2008 Ford Edge

1 Answer

Warning light MY WRENCH,ABS,AND SKID LIGHTS COME ON AT THE SAME TIME STAY ON AND THEN GO OFF TWO THREE DAYS LATER...BUT NO PROBLEM WITH VECHILE,NO LOSS OF POWER BRAKE WORK...THIS STARTED WHEN THE WEATHER IS COLD!!

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,039 Answers

That a bad whell sensor that start to actup get the car pass on a scanner to identified the bad sensor

Posted on Mar 23, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: abs light emergency light stay on

Had a similar problem. Check the ABS wheel sensors and wirring to them. I had that problem when i tempered with my hubs

Posted on Oct 16, 2008

  • 1 Answer

SOURCE: abs brake warning light comes on and rear brakes remain stuck on

I would bypass abs contraption with new line.(87 dually) abs located under drivers side cab looks very susceptible and is known to fail.I would trust my foot before that old thing.Im rippin it out of my truck & replacing it with new line all the way back.Old lines rusted pretty bad.Better safe than sorry.unplug light bulb or just leave it in .Jersey cant say anything if its 94 or older at inspection.that goes for all the lights.For me,older is better.I dont know what setup you have or if you sold it, you could try replacing it for about 160 at advanced.I hope its not the computer screwin up,thats probably a dealer item.Try unpluging hydraulic unit for shits & giggles.Go over rear brakes again before you start cutting.

Posted on Dec 26, 2008

SOURCE: Air Bag Light, Brake Light, & ABS Light came on in the dashboard.

Check and see if your alternator is charging
Low voltage will cause those lights to come on, as the computer is shutting down.

To check your alternator you will need a volt meter... WITH the engine running you should have about 14 volts coming out. IF NOT you need to replace the Alternator!

Posted on Apr 19, 2009

michigan man
  • 3533 Answers

SOURCE: 2007 ford edge, three lights are on: ABS, wrench

it sound like a ABS-sensor is sticking are its bad give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Posted on Jan 12, 2010

  • 36 Answers

SOURCE: ford puma abs and traction warning lights

The first thing i would do is check the wiring on all four wheels.It could be a faulty solenoid.The next thing is a diagnostic check.

Posted on Jan 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i turn back on esc


The ESC light will go out when the ABS system is repaired. The skid may have damaged a speed sensor or some other component causing both lights to stay on.

Feb 16, 2015 | Kia Rondo Cars & Trucks

1 Answer

Abs light flashing


Please check the following:
1. ABS warning light circuit.
2. Sort circuit in wiring.
2. Brake actuator (skid control ECU)

Mar 25, 2014 | 1998 Toyota Corolla

1 Answer

Triangle with car and skid marks behind car and a triangle with wrench both dash board warning lights


{: ) These triangles you saw is for the Stabilitrak (traction control) indicators. Normally these lights should be off after the engine has started, unless you disable it by pressing the stabilitrak button. Sometimes it lights up automatically when driving under certain road conditions, and will turn off later when normal conditions resume. A wrench beside the triangle indicates a fault is detected on thge traction system and it requires servicing.
What you can try, stop the vehicle, turn ignition off for a few seconds to reset the system, and then restart the vehicle. If the lights wont go off, then tghe vehicle really needed to be checked right away.

Jan 06, 2011 | 2008 Chevrolet Trailblazer

1 Answer

About a week ago, having switched on and set off, all the brake warning lights stayed on, that is the ABS, TCS, TCS OFF and Brake System Warning lights. The brakes continued to work OK with no extra travel...


abs=anti-lock brake system/ tcs=traction control system ==sounds like you have a problem with ur abs possible bad sensor or a wiring connection problem when abs shuts down [trouble light] your brakes will work normal but if u stomp or brake hard the brakes will lock up skid and the tcs doesnt affect brakes but if u accelerate hard tires will spin lose traction check the wiring and connections to the sensors sometimes debris hits the wire and loosens the connection if looks ok and light is on have car scanned for the trouble code most auto stores such as auto zone/advanced auto offer this service for free the code will what and where the problem is so repair can be made

Jul 18, 2010 | 2000 Mazda 626

2 Answers

ABS light always on- any way to turn it off- i am


under the hood you will find a relay center ,the relay for your abs is bad.the way it effects the braking system is (now that the abs light is on )when you slam on the brakes your truck will skid to a stop,the abs system prevents the skidding,you will feel the brake pedal pulsate until stopped.

Jun 05, 2010 | 1997 Ford Explorer AWD

1 Answer

Intermittent electrical fault Saab 9-5


Check connectors,pins grimping force,bad contact between pins in main plug connector(abs unit)or connectors near pilar A left.
Good luck!

Sep 29, 2009 | 2000 Saab 9-3 Viggen

1 Answer

Warning Lights Stay on.


I think your alternator went bad,or the belt broke or the battery died, All three of these are connected together.
Any thing is possible lightning could have something to do with it,I doubt it.

Aug 11, 2009 | 2000 Ford Focus

1 Answer

ABS and ASC warning lights stay on 2000 530d


Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

Jul 06, 2009 | 1999 BMW 5 Series

1 Answer

ABS and anti skid tracking control lights stay on in my BMW 523i


Unfortunately there are several possibilities that are common to causing the light to come on. I would suggest taking the car in to a dealer and having them read out the fault memory. Such possibilities are a failed speed sensor, a binding DSC/ACS actuator cable, or faulty DCS/ASC control unit. If you know how, you can disconnect the speed sensors, and check for voltage output across the the terminals inside the connector going to the speed sensor while rotating the wheel. A dealer should charge you about an 1hour fee to check out your system. Due to the cost of parts involved, I would recommend having it checked before just guessing.

Mar 15, 2009 | 1998 BMW 5 Series

1 Answer

Own a 2005 ford 500. recently had front and rear pads replaced at 93k miles. Several days later warning lights started on startup ABS etc. Several days later unable to start car, battery drained. Jumped...


Firstand foremost,this snota problem for a echanic tooodagnose. Ifurbatery isdrainng, u shouldcek to cifur charging system is functioningproperly. Ifur ABS lite iscoming on, probaly during dis-assemby, something went wrong witur sesors. check it out with someone knowledgeable and experienced

Jan 25, 2009 | Ford Five Hundred Cars & Trucks

Not finding what you are looking for?
2008 Ford Edge Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...