Question about 2004 Honda Civic
Check engine light is on and I scanned the codes and got p2A00 is the code is this the o2 sensor malfunctioning or is there another problem causing this issue?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: code PO131
Code PO131 is O2 sensor circuit low voltage , bank 1, sensor 1. That sensor I would say is the one in the exhaust manifold. I would check voltage to the sensor from the computer. If the voltage is not 5 volts, then it could be a computer problem or a wiring problem. I have seen factory wiring and connectors give a voltage problem. Check for a damaged or burnt, pinched wire. You need to know for sure that the voltage is correct to the sensor. Intermittent problems are hard to trace , but patience and knowledge helps.
Posted on Mar 11, 2009
SOURCE: P1298 Code Fuel/Air Metering
Are you sure you wrote the correct code. According to Honda, P1298 is a high ELD circuit voltage. If what I just put is correct, Honda has a service bulletin as this is a common problem( it could be another fault, but this is the most likely choice).
The ELD has a bad solder joint. I have done several of these, you will need to replace the ELD, and this is how.
1 D/C the negative battery cable (make sure you know your radio code, it will be needed to use the radio again)
2 Unbolt the fuse box that is in the engine bay.
3 Attached to the fuse box underneath there is a plastic cover, remove this cover.
4 There is a 3 pin connector under this cover. Remove it
5 Flip the fuse box back over, there are 2 big fuses bolted down, a 40 A and a 80A
6 Under these fuses is the ELD, remove it and pull the bar that sticks out of it.
7 Stick the bar in the new ELD
8 Put everything back together. Do the idle learn (just idle the car for 10 minutes with no loads on such as radio, headlights etc..)
This is probably the first thing they will do if you bring it to Honda assuming the code you have is P1298.
Posted on May 07, 2009
SOURCE: p 1705 code, honda civic lx 2001
Have tranny serviced . Check tranny fluid level fill with HONDA ONLY fluid. If not fixed have fluid drained and filter replaced on tranny
Posted on Jan 21, 2010
Testimonial: "thanks u very much. the problem has been resolved. very good advice."
I would send the car for a smoke test for the emissions leak...Find out where the leak is comming from..Repair it..Reset the codes, then do a drive cycle and see what happens...
Posted on Feb 19, 2010
Tips for a great answer:
Nov 21, 2013 | 1993 Honda Accord
Mar 05, 2013 | 1990 Honda Civic
May 24, 2011 | 1998 Honda Civic
Sep 18, 2010 | 1997 Honda Civic
May 27, 2010 | 1998 Honda Civic
Sep 25, 2009 | 1998 Honda Accord
Mar 11, 2009 | 1999 Honda Civic
Nov 25, 2008 | 1999 Honda Civic
60 people viewed this question
Usually answered in minutes!