2007 CRV, a few weeks ago my battery died because I left the light on... I took the car in for inspcction (NY emission) this week but it did not pass because of the OBD monitor readiness (catalyst & oxygen senor both failed) How many miles do I need to drive before it is reset?
I know a website that has every info on all vehicles and vehicle problems, with their solution In detail.. it's
www.reliable-store.com
SOURCE: arizona vehicle emission test
is your check engine light on? if not you can bring it back in to see if the monitors are ready yet, the only thing you can do is drive it until its ready or the CEL comes on good luck and please rate -jeff
SOURCE: obd codes for a 1994 cadillac seville sls
what that means is that the ecm(main computer) is not getting a voltage signal value from the o2 sensor. this could be due to a broken wire,bad plug or a bad sensor please rate this thanks
SOURCE: 2005 Honda CRV Headlight Chime
I just found an answer at an auto forum site on the web. The problem is the door switch in the door. It thinks the door is "closed" when it is in fact open. So fix the door sensor switch in the driver's door
SOURCE: EMISSIONS INSPECTION FAILED
you can try this unplug the batt. from ground. let it set for 30min.put it back but still you need to replace the main pproblems if this dont work
SOURCE: 1996 doge intrepid wont pass emission test because IM monitors ar
Just maybe your O2 sensors are not operating properly. They may be requiring your engine to heat them up to get upper temperature readings but not lower. You can easily diagnose these and all other sensors and problems by purchasing a Hains manual at your local Auto Zone or Advance auto store which will greatly aide you in diagnosing all your auto needs. And the fault symptom index at the beginning of the book will ease your troubles with professional one on one advice with step by step instructions. Its like having your own ASE certified mechanic at your finger tips. Good luck.
513 views
Usually answered in minutes!
×