Question about Cars & Trucks

Open Question

Urban beatz energy mount, no flexible goose neck....solid rod

The part of the mount that is supposed to be a gooseneck, is a solid rod. There is no way for it to fit in the cigarette lighter and bend to be seen while driving.

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 9 Answers

SOURCE: fuse for 1999/2000 ford focus diesel estate cigarette lighter

its fuse 46 and it should be a 15 amp according to the manual as i have the same car as you hope this helps

Posted on Apr 13, 2009

  • 253 Answers

SOURCE: Locating fuse box for cigarette lighter in 05 Chevy Malibu Classi

It is in the rear fuse block, in the trunk under the left side carpet. Good Luck

Posted on May 06, 2009

  • 17970 Answers

SOURCE: replace cigarette lighter

Review the section ZJ-Secc-8E-Instrument-Cluster-and-Gauges in the page 8E-5 you can find the graphics about this work.

Good luck!!!

Posted on Jul 21, 2009

  • 176 Answers

SOURCE: drivers side rear brake line has a hole in it near

The best, SAFEST, and cheapest way to fix anything that has to with your brakes is just replace the brake line.

The brake fluid you're losing doesn't only affect that brake it will affect al four of your brakes and if the leak expands you could mash the peddle one time and have absolutely no brakes at all.

Brake lines aren't that much and it shoud take you under an hour to change it.

I hope this helps you out.

Thanks for letting ya


Posted on Sep 14, 2009

  • 3400 Answers

SOURCE: Hi, I need to replace the cigarette lighter in my

Before replacing lighter socket, try gluing it with super glue. Sounds like your only problem is that socket is moving because of broken plastic. Or you can buy aftermarket accessory plugs from autoparts stores and you can get them with up to three outlets for multiple plug ins.

Posted on Jan 07, 2011

Testimonial: "Thanks for the advice!"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I replace thermostat for 2007 Suzuki forenza

Like most motors the tstat is located under a goose neck with typically only two blots that the top radiator hose is connected to with a hose clamp, so you drain cooling system, remove top hose, remove goose neck, carefully remove tstat, take note of the direction, scrape old gasket mating areas, clean thoroughly, install new gasket, reinstall goose neck, Do not Over tighten, reinstall top radiator hose, fill system, start vehicle, turn on heat, check for leaks.....

Feb 20, 2015 | 2007 Suzuki Forenza Sedan

1 Answer

How far back from the cab on a 2009 silverado short bed do i install hitch?

  • Hope this helps and thank you for using FixYa.
Regards, Tony

Jul 15, 2011 | Chevrolet 2500 Cars & Trucks

1 Answer

Can you tell me where the thermostat is located in the engine compartment on a 1991 Mercury Cougar LS 6 cylinder 2 door coupe. Thanks!

The thermostat is located under the gooseneck at the end of the engine side of the top radiator hose. After it is completely cooled off ,preferably after sitting all night you can release any pressure by removing the radiator cap. Then loosen the hose clamp at the goose neck and you will be able to see it inside. You will have to take out the two bolts in the neck to gain access to it. Remember you will need to drain some of the coolant into a drain pan from the lower radiator petcock beforehand. Also dont leave the coolant sitting as cats and other animals will drink it and die.

May 26, 2011 | 1991 Mercury Cougar

1 Answer

Installing thermostat

im guessing your question is how to install it its pretty simple follow you upper radiator hose to were it meets the engine the matal thing it is hooked to is your goosneck, take the upper radiator hose off of the goooseneck just to make it a little easier then you will take the two bolts of the goose neck and remove the gooseneck then take the thermostate out and replace it with new one make sure you install it the right way or you will have issues then replace the gooseneck gasket and reinstall the gooseneck onto the engine im not sure of the tourqe specs but i usually just tighten them down dont give them the he man strength but snug them down, then reinstall your upper radiator hose if you lost any antifreeze replace what you lost and you should be good to go. run the engine for a while and make sure your gooseneck gasket doesnt leak and you can runn the engine long enough in the yard to make sure the thermostate is going to open when your truck gets to operating temp, youll know it opens when your trucks temp stops going up and goes back down just a little, once that happens you know you are all set and it is good to drive

Apr 21, 2011 | 1997 GMC Sierra

1 Answer

How do i change a thermostate in a ford fiesta & whr is it located h reg 1.4 petrol?????

follow the bottom radiator hose to the engine. the termostat will be under the goose neck the hose is atached to. remove the hose and the bolts on the goose neck. pull the goose neck off and the thermostat will pull right off. remember to replace the gasket with it

Jan 15, 2010 | 1989 Ford Festiva

1 Answer

How do you replace A thermostat on a chevy impala 95

follow the bottom of the radiator hose till it goes into the goose neck remove the hose and the goose neck the thermostat will be under the goose neck. make sure to replace the gasket with the thermostat

Jan 02, 2010 | 1996 Chevrolet Impala SS

1 Answer

Escort 55d van 1998 model... my heater fan will not blow hot air?what are my options,and,where is my thermostat positioned?

follow your top radiator hose to the engine where it conects is called a gooseneck from its shape the thermostat is under the goose neck

Dec 10, 2009 | 1998 Ford Escort

1 Answer

The car overheats. How can i replace the

follow the top rad hose to the block, should be connected to a goose neck, remove gooseneck, thermostat should be there.

Oct 27, 2009 | 2002 Chrysler PT Cruiser

3 Answers

Where is the thermostat located on a 2001 chevy silverado with a 5.7 vortec v-8?

It is located where the top hose from the radiator meats the top end of the engine.. Should be 2 bolts to remove the housing and the thermostat is inside..

Sep 30, 2009 | 2001 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides