Question about Jaguar Cars & Trucks

Open Question

Alarm won't go off it stays own and with the key in our out it stays own and runs down the battery

The alarm wont go off key in our out and while it sets it runs down the battery

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Caesarfix
  • 141 Answers

SOURCE: alarm system on hyundai xg350

disconnect the the alarm speaker by taking one end of the speaker inside engine compartment, it looks like horn, follow wires and look for one of both (any) and cut it or disconnect if You find terminals, Your Relay is the problem, or your switch

Posted on Feb 10, 2009

Ad
  • 121 Answers

SOURCE: alarm won`t stop, can`t start 96 jetta trek

find the fuse for the alarm and pull it out tha=is should solve it, but means you have no alarm

Posted on Jun 06, 2009

  • 1 Answer

SOURCE: disable alarm 1999 dodge intrepid

HOW DO I MANUALLY DISABLE THE ALARM FOR A 99 DODGE INTREPID

Posted on Jul 08, 2009

  • 1 Answer

SOURCE: Have a 2000 VW Beetle. The alarm won't turn off!

My 2000 Beetle does same thing (although not all the time). Just found an internet post that suggests there is a problem in the door lock sensor. I assume you are using a regular key - not
the keyless entry - like I am. He also said that you can disable the alarm (also disables the
keyless entry - which doesn't bother me) by leaving the front door AND the rear trunk open and
starting the car up. Seems to work so far. I will get the door lock sensor replaced and turn the
alarm system back on (not sure how yet), and let you know if that stops the problem.

Posted on Jul 24, 2009

  • 4793 Answers

SOURCE: car alarm went off while unlocking the door, now

you need to reset alarm/immobiliser.lock car with remote, hold button down for 30 secs,then press/hold down unlock button,should reset.another way is with key in ignition/turned on, press alarm button down and hold for 30 secs.this resets immobiliser.toyota
systems vary..depending on market.

Posted on Mar 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The battery was changed on my car. after new one installed the alarm went off. the guy push the black button and turned the key. now the alarm wont work. how do i get it workind again? .


the guy pushed a button under my dash turned the key and car started

you need to know where that push button is under the dash

if you cant find it your self ... ring the place back for instructions

not nice but
you may have to get them to call out and show you or
tow the car back to where you got the battery fitted

Oct 11, 2016 | Cars & Trucks

1 Answer

Cannot unlock doors and reset alarm


Go on youtube and put in how to reset your car key after renewing key fob battery good luck colin

Jun 30, 2017 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer

Alarm won't turn off


Turn key to on position, but not start it. Push red button on left of steering wheel twice, then start

Apr 05, 2017 | 2001 Toyota MR2 Spyder

2 Answers

92 Toyota 4runner truck was running perfectly fine Later in the day went to start and the alarm just started going off and wouldn't turn off. Truck won't start even with keys turned in igniti


The alarm system somehow got activated , this is usually because the battery becomes discharged or disconnected try doing this:
Remove the key from the ignition
disconnect the negative battery terminal
put the key back in and turn to ON
exit the truck and leave door open
reconnect the battery terminal
get in and leave door open, if the alarm horn stays off it should start.

Dec 07, 2012 | 1992 Toyota 4Runner

1 Answer

Key fob wont re set on my ssan yan rexton


I recently changed the battery on my key fob for my ssanyong rexton. I then did the following for the key fob to make it work. 1. Enter vehicle and close all doors.

2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.

3. Put key in ignition, turn to run position but don't start it.

4. Press and hold both buttons on key fob until red light on fob stays on. Then let go of both buttons. Then pressed the alarm button then the panic button, somthing like that. To be fair the button sequence after the red light came on is a bit vague. The alarm was blaring so i was happy when it just stopped.

May 23, 2012 | SsangYong Rexton Cars & Trucks

1 Answer

Both key fobs with new batteries dont respond. I set the alarm off when i manualy open the door and alarm wont allow me to start car for more than two seconds. What do i do??


The question is .... Did you get the keys wet? I know you won't want to hear this but if you replaced the batteries and they are still not responding then either the batteries are dead from new or you will need to replace the key(s) through your chrysler dealer ( very expensive). I also had a similar problem with my 08 Avenger where I replaced the battery on my key and it would unlock the doors/turn off alarm but when I started the car it would only run for a minute then shut off. Luckily I had the second key that was operational so I could make it down to have my key replaced that was bad. Hope this helps.

Aug 19, 2011 | 2006 Chrysler 300

1 Answer

I have a 2005 JGC 5.7 hemi and sometimes remotes wont work only when you want to unlock it.If you use the key to open door alarm sounds. what could be the problem?


Have you tried a new battery in the remote, or do you have a second remote you can test. Either your remote is worn out or the battery is dead.
Once you lock the car with your remote it will active the alarm and if you use your key it won't deactive the alarm only your remote will, on some cars putting the key in the ignition will deactive it.
If you can deactive your alarm with your remote and can just manualy lock and unlock your doors and that should prevent your alarm from going off until you get a new remote or battery.

Aug 05, 2011 | 2005 Jeep Grand Cherokee

1 Answer

Alarm won`t stop, can`t start 96 jetta trek


find the fuse for the alarm and pull it out tha=is should solve it, but means you have no alarm

Jun 06, 2009 | 1996 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

yadayada
yadayada

Level 3 Expert

77202 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...