Question about Cars & Trucks

Open Question

Nissan primera p12 03 plate surging problem

Surging when accelerating usually on motorway or above 40mph

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: nissan primera gearbox

how much is the price for nissan primera 2003 gear box

Posted on Jan 14, 2009

Ad
MNfisherman
  • 11896 Answers

SOURCE: The turbo blew on my Nissan Primera 2.2dci 55

The bearing of these to tend to go out threw time., Escpecially if you accelerate quickly then bearing may slip.. You will have to get a new turbo and accelerate slower or keep rpm's down below 4 grand

Posted on Sep 05, 2009

  • 1 Answer

SOURCE: noise from nissan primera gearbox

it appears to be a design problem , i had the same problem twice in 2 years

Posted on Oct 28, 2010

  • 2 Answers

SOURCE: How do i reset engine management light on my 53

dissconect battery for 15 mins this will put the computer on learning mode

Posted on Dec 23, 2010

elix0411
  • 3530 Answers

SOURCE: I have a 2010 Elantra

Welcome to Fixya

Souns like a fuel delivery problem. Check the Fuel filter or the fuel pump. Replace then if possible. Engione lacks fuel that is why i wont go any further. It would be better of you get a scan tool end provide me the error code that you will be getting.

Your response will be highly appreciated.

Thank you for using Fixya!

Posted on May 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 zetec Focus 1.8, slight miss fire when accelerating in fourth gear, pulling onto motorway yesterday and tried to accelerate and it was as if something was holding me back


A miss under load on a Focus is usually a bad or failing coil on one or more of the plugs.Also how old are the spark plugs?

May 08, 2017 | Cars & Trucks

1 Answer

No power above 40MPH, could the exhaust brake contribute to this issue?


If applying at cruise or acceleration instead of deceleration , yes.

Oct 29, 2015 | Cars & Trucks

1 Answer

96 escort 1.9 manual jerking while accelerating 96 escort 1.9 manual


best advice is dont go 40mph in 5th gear... if you are going up a hill at 40mph in 5th gear i have no doubt that it is jerking, your putting too much stress on the engine. shift up to 4th or 3rd you will be fine. 5th gear is an overdrive gear. 55+mph

Dec 01, 2011 | Ford Escort Cars & Trucks

2 Answers

I have a 1997 landcruiser,when driveing at 40 to 50mph a vibration appers when accelerating up to 70mph it gets worse take foot of accelerater goin down hill thers is no noise or vibration


Check your universal joints in the drive shaft. When you remove your foot fromt the accelerator you are no longer applying power to the rear wheels and in turn there is no load on the drive shaft. When you accelerate below 40mph, there isn't enough centrifugal force to cause the driveshaft to wobble, but once you go above 40mph, it begins to show slop.

Another thing to check is your wheel bearings.

Mar 07, 2011 | 1997 Toyota Land Cruiser

1 Answer

I recently bought a 1992 model toyota camry SV21 and 3S-FE engine, it starts well exept that when you try to accelerate, the engine will miss and would like to stall, so just to bring it home I rev it high...


the fuel must be adjusted ,it loses the torque, when press the accelerator ,the engine need more torque when moving the car on 1st gear,compare on the motorway,check for the fuel man ,this will affect the engine on long period

Aug 22, 2009 | 1992 Toyota Camry V6

2 Answers

1995 Camaro skipping


for the check engine light replace your knck sensor on the passenger side of the block and skipping above 40mph check the vaccum lines to the transmission and if not its your tourqe caonverter there about 75-100 at a tranny shop and 35 at a junk yard nake sure your get it for manual if your car is stick and automatic if its auto

Apr 10, 2009 | 1995 Chevrolet Camaro

1 Answer

Acceleration - cannot get above 40 miles per hr.


If the engine revs up while in drive and running at 40mph, your transmission is probably slipping. Try checking your transmission fluid level. If it is OK, I would get it by a garage to have them look at it to cofirm.

Mar 30, 2009 | 1998 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14445 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...