Question about Ford Falcon

Open Question

How do you replace a clock spring on a bf falcon.

Does the clock spring go 2 and a half turns to the left and right..

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 610 Answers

SOURCE: i replace the thermostat in

The section with the spring goes toward the engine, as opposed to tward the radiator.

Posted on Sep 24, 2011

Ad
  • 80 Answers

SOURCE: My car ford falcon bf doesn't shift gear in the

run a scan on the car

Posted on Apr 13, 2012

sulavaca
  • 1007 Answers

SOURCE: battery charge rate drops below 3.8volts thus after a few months after replacing the battery starting can be difficult

If your charging rate is too low, then check the connections and wires to your alternator. Replace alternator if necessary.

Posted on Nov 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why isn't horn working?


Before replacing the relay did you test ? You could have a clock spring problem . VEHICLE RELAYS Operation Diagnosis Do you know what a clock spring is ? I'm not saying that is the problem , it could be . A clock spring is a device with wire inside that allow the steering wheel to be turned from full left to full right keeping the air bag an cruise control an any other buttons on the steering wheel connected electrically , to wiring in the steering column . The wiring does fail inside the clock spring. How cars clock spring works

Oct 15, 2015 | 1997 Jeep Wrangler

1 Answer

The cruise control and the hooter does not work on my steering please help


Does the air bag light come on as well ? The clock spring in the upper steering column is use so your steering wheel button's have power an you can still turn the wheel from right to left . They break no an then ! How to replace clock spring in 2006 Hyundai Sonata

May 24, 2015 | 2003 Hyundai Santa Fe

1 Answer

08 bf xr6, steering wheel cruise, radio controls not working ?


The clock spring in the steering wheel may have failed and will have to be replaced.

Feb 05, 2015 | Cars & Trucks

2 Answers

Bf falcon auto wont select gear or drive


My 2003 BA had the same problem and it was the bush on the end of the gear selector cable, but required getting a new cable. Don't know if this is relevant for you.

Jun 15, 2014 | 2005 Ford Falcon

1 Answer

My 2007 BF Falcon wagon occasionally misfires when starting causing it to go into 'safe mode' with dash instruments flashing. The car can be driven with reduced power, sufficient to get home.


Your car should be fitted with an obd2 connector. Go to your local dealer and ask him to download the error codes on the ecu it will give the reasons causing the vehicle to go into safe mode.

Dec 16, 2013 | Ford Fairmont Cars & Trucks

1 Answer

Bf ford falcon surging/losing power


Read fault codes . Check cat converter for failure /blocking exhaust system

Apr 23, 2013 | Cars & Trucks

1 Answer

Oil light on dash of bf falcon wont go off


Need more info. Whats a bf falcon for starters?

Jan 16, 2013 | Ford Expedition Cars & Trucks

1 Answer

2000 airbag code flashing 47 had very minor accident in rear


probably its just coincidence but the accident dont have much to do with the error code .. This is a common problem ,, basically there is a device called a clock spring in the steering wheel, this device is like a bearing with a coil that turns with the steering yet allows the air bag in the steering to be powered. Now this has brushes and wires and a bearing fitted in such a manner the steering can turn freely without breaking contact. Well eventually the wires break and it needs replacing. This involves removing the steering and replacing the spring. I strongly suggest you get a professional to do this as there is no room for error reasons being
  1. the clock spring needs to be set propperly 1 1/2 turns left and 1 1/2 turns right if not your steering will not function as it should and you wont be able to make turns left or right and over turn on the other end (big problem) as it can lead to accidents.
  2. you can discharge the air bags and that's bad as its expensive to replace, not mention your air bags use gun powder to discharge ,, this can cause critical injuries m burns etc..
  3. if the wiring is wrong , you can blow the ecu as the ecu directly controls the air bags on a 12 volt relay.. Well i guess you get the point.
simply put your's needs replacing..

Sep 17, 2010 | 2000 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5575 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...