Question about Cars & Trucks

1 Answer

Remington parifin spa hs200 quit working. light dosent illuminate and wax dosent melt

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 43 Answers

Your posting in the wrong place this is for car in truck questions

Posted on Feb 08, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Some one burned candles in my mortar and pestal. how do i get the wax out of the mortar? It is volcanic stone

try turning the bowl up side down on a baking tray and place to a hot oven at say 250 degrees for 1/2 hour or so.. The wax should melt out of the rock

Apr 03, 2013 | Cars & Trucks

1 Answer

1994 dodge pickup at aidle oil presser drop to o shout down and restate and will pick it backup

There may be an excess of sludge blocking the oil pump strainer. This same thing happened to me a couple of years ago. I bought a salvaged 95 Dakota that had been in a flood. The seller may have ran an oil flushing product in the engine which frees oil resides in the motor. However, the product states that the oil pan and pump screen may need to be removed and cleaned in high mileage motors. At the time my motor only had @ 40K on it. I also used the flush trying to clean the motor but it got worse.
Bottom line drop oil pan and clean the pump screen.
Remember, some oils have parifin (wax) in them so use a wire brush and parts cleaner on the screen.
Your problem could also be an engine idle speed problem or electrical so tune the engine and check engine codes before dropping the pan. But do it soon because if it is the screen then it could become completely clogged at any time.
AR in NE

Aug 22, 2010 | Dodge Ram 1500 Cars & Trucks

1 Answer


For the year of the truck I would go with 10w-40w it is a multi weight oil for summer and winter, I refuse to use Quaker state or pennzoil, they are parifin based (like a candle wax) and tends to build up in engine when cold (lack of lube), I am a certified aircraft mechanic and those two oils are forbidden to use in aircraft engines.
As far as what brand = Valvoline, Casteroil, Mobile, ect.

May 21, 2010 | 1997 Chevrolet Blazer

3 Answers

1995 subaru legacy l the dashboard lights are not working

  • Check fuse #9 at in car fuse panel
  • Check Illumination CTRL Module for melt-down
  • Check that Tail and Illumination relay is fully seated, top center of in-car fuse panel.
The relay is most likely the cause.

Sep 10, 2009 | 1995 Subaru Legacy

1 Answer

I cannot break the bolts loose on the front brake calipers. I have sprayed a lot of rust cutter and let it sit with no good results. Cannot change the brake pads without loosening these bolts.

use a regular propaine torch to heat the bolts (be careful not to melt anything else inthe process) then melt gulf wax onto the bolt. you will see the wax sucked into the rust, and bolt housing. the gulf wax does an amazing job to free up stuck bolts because of the way it permieates the rust. then while the bolt is still warm losten it. you can get gulf way at any hoby store or candle making place.

Sep 02, 2009 | 1994 Geo Tracker

1 Answer

Dashboard lights out after replacing headlamp switch..

Did the old switch melt the pluggin? Might be a bad connection on the switch. Or you new switch is defective.

Aug 16, 2009 | 1996 Dodge Ram 1500 Club Cab

1 Answer

Cars emergeny blinkers keep going off and wont start

connection on temp coolant sensor must be bad the wax the keeps pins in place will melt causing poor connection ac to stop working and fans .. check connection on fans two yellow wires .. also wax melts causing poor connection

Jun 15, 2009 | 1998 Volvo S70

1 Answer

I had a pot of wax in my car it spilled over the seat

scrape off as much as you can with a dull knife or a credit card. Then use toilet paper to blot up the wax while you heat it with a hair blow dryer. Put the toilet paper on the wax and apply warm air above the paper. The wax will melt and absorb into the paper. This will get some more out but not all. To get the remnant of the wax caught in the cloth fibers, use naptha (lighter fluid) to dissolve the remaining wax and blot up with more paper towels or tissue. The naptha will smell some for a little while but since it is dry cleaning solution, it will evaporate quickly. The other choice for cleaner is electrical contact cleaning solution. It will dissolve the petroleum based wax and it evaporates without leaving a smell or residue behind. This technique should get out about 95% of the stain.

Jun 07, 2009 | 2004 Honda Accord

1 Answer

Seat belt buckle

Soak it soak it and soak it....... may take a few days.... If nothing works, get a hair dryer and heat it up warm to the touch..... melt wax all over the quite warm bolt unit and let sit overnight.... as it cools it will draw the wax down along the threads

May 15, 2008 | Mercury Montego Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13604 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides