Question about 2000 Chevrolet Silverado

1 Answer

Whining noise in rear end as the transmission shifts

When turning left or right driver side rear end feels like its pulling and at times i hear a clunk. feels like its binding.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

  • Expert
  • 72 Answers

Could be brakes... or bearings... check both and repost with more details if that doesnt fix.

Posted on Feb 08, 2014

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Rear end in 1999 chevy 1500 binds on turns

well i had the same problem everyone told me the clutches in the rearend were sticking making it stick in positive traction (only your passanger side rear wheel pulls unless you start spinning then a type of clutch engages the other side so you have traction then when you stop spinning it disengages it should never be engaged if your on pavment) now you can do what i did listen to everyone when they tell you its normal or you can take it to someone with experience now and save yourself some money cause it will start popping then it will get some viberation then next it will break the clutches and when that happens you will have to replace the pinion,ring,and the spider gears as well as the clutches.make sure you have pleanty oil in rearend if you dont add the limited slip conditioner it might free clutches up but if i had it to do over id put it in the shop or stop driving it before i broke something hope this helped

Posted on Mar 30, 2009

  • 109 Answers

SOURCE: whirring/whining noise from rear trans-axle

check your rear end and make sure it has plenty of gear oil..if full then there is friction in it somewhere and it is probly getting ready to go out.

Posted on Dec 02, 2008

  • 255 Answers

SOURCE: Cavalier rear suspension clunks

HI, this noise can be caused by worn shocks,even if the bushings look good, you can remove one of them and check if is hard to constracts ,if not they must be replaced,

Posted on Jan 04, 2009

jmgldsmth
  • 1889 Answers

SOURCE: 2001 Chevrolet Cavalier front End Roar

You must replace wheel bearings in pairs to avoid loading the old bearing and, in time ruining your new bearing hub it is possible that you have already damaged the new hub

Posted on Apr 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have whinning noise when turning right or slowing down sounds like a power steering noise in rear end


A whinning noise while turning is an indication of a worn bearing. The extra pressure put against the bearing/race during the turn and the closing of a gap creates this noise.I would chech the axle bearings on the side of the truck on the outside the curve when you hear it. What I'm saying is if you hear it when you turn left....check the right side bearing

Sep 17, 2014 | 2004 Dodge Ram 1500

3 Answers

Whining noise progressively gets louder with speed


One wheel turning faster than the other is normal if both wheels are off the ground. If one wheel is dragging when the other wheel is on the ground, it could be brakes or a wheel hub bearing.
Usually if the noise happens on right turns, the left hub bearing is failing, and vice versa.

May 07, 2013 | 2000 Buick LeSabre

2 Answers

Something Humming


sounds like a wheel bearing is going bad

Feb 07, 2012 | Chevrolet Venture Cars & Trucks

1 Answer

95 landrover disco has problem with transmission or transfer case. will move when I put it in Lock HI and Lock Lo but will not move when transfer case shifter goes to road gears in hi or lo and will whine...


Sounds as if the gears may be broken in the rear axle, the front axle will pull the car if in four wheel drive but when in 2 wheel drive only the rear axle pulls. Get the back tires off the ground and turn the rear end by the wheels. You may or may not hear any noise but if it is in park it you should feel some resistance if the gears are in good shape, will likely turn freely or lock up completely in spots if the gears are broken.

Sep 15, 2011 | 1995 Land Rover Discovery

1 Answer

2002 Dodge SX 2.0 I'm getting a howling or ( high frequency vibration of some type) noise from the front end when in motion. Lessens when steering is pointed left of center. No howling when at a...


The first thing I would check is for a bad wheel bearing. If the noise lessens when turning left than I would look at the left front first. Chalk the rear wheels or set the emergency brake. Put the transmission in neutral. Jack up the left side of the car. Grab the coil spring and rotate the tire by hand. If you can feel/hear the noise than your on the right track with the bad wheel bearing. I can give you instructions on how to replace if you need them.

May 26, 2011 | Dodge Neon Cars & Trucks

1 Answer

When out of 4 wheel drive the left and right rear end makes a shattering sound. while the verhicle is not running i can rotate the wheels left and right on the rear i don't feel any resistance or hear...


its possible that the problem could be in the transfeer case. you didnt state which 4x4 unit is in the jeep.... there were 3 types, one was all wheel drive full time with a low gear selector, the 2nd was a part time 4x4 manual shift with a low range selector and the 3rd was a pushbutton on demand 4x4 unit. if your jeep is a all wheel drive unit and you are having these problems its defititely something for a transmission shop to look at due to how everything works. if you have the manual select, are you following the proper shifting procedure for the transfer case (found in the owners manual and possibly also on the inside of the driver sun visor). as for the pushbutton if you are not having any electrical issues( no lights on the selector switch) it could be the the transfer case itself. if you are sure you are performing mode changes (2wd to 4wd or 4wd to 2wd) properly its probably time for a shop to take a look at it.

Mar 14, 2011 | 1997 Jeep Grand Cherokee

1 Answer

2002 dodge 1500 rear end making whining nosie


This could be one of several problems: If the noise increases with speed, and you are only hearing it from the rear differential and not the transmission, it could be the rear differential carrier bearings, or rear axle bearings going bad. If you are only hearing the noise upon acceleration or deceleration, the rear differential ring and/or pinion gears may be going bad and the rear differential will need an overhaul. You'll have to get the rear wheels off the ground and see if you can pinpoint the location of the noise with something such as a stethoscope. If it's coming from the rear differential, you'll need to pull the bolts and the cover to determine if the gears are still in good shape, or if there is any pitting. Same with the carrier bearings; if you see pitting/ discoloration, they'll need replacement. If the noise is coming from one side towards the end of the axle shaft near the wheel, it's most likely a axle bearing going bad, and you'll need to pull the wheels, remove the diff. cover to release the C clip which holds the rear axle in place at the differential, and pull the axle out. You also need a special tool with a slide hammer to remove the axle bearing and seal.

Nov 20, 2009 | Dodge Ram 1500 Cars & Trucks

Not finding what you are looking for?
2000 Chevrolet Silverado Logo

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...