Question about 2003 Chevrolet Blazer

1 Answer

Gas goes in car slow air way pluged - 2003 Chevrolet Blazer

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    Visited the website for 3 consecutive days.


    An expert who has answered 20 questions.

  • Expert
  • 147 Answers

Check the breather hose for kinks, it runs to the tank right beside the filler tube.

Posted on Feb 08, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a problem with my engine missing at idle and while accelerating lacks power has exessive fuel consumption sounds like its choking but if i dont give it hardly any gas in will run smooth.

pluged cadliletic convertor or choke stuck or pluged air filter If this started over a period of time,lose of power put your hand in frount of tail pipe check air flow slow or no air flow disconnect cadliectic convertor..i think it is your cadlectic convertot.

Jan 29, 2012 | Chevrolet Cars & Trucks

1 Answer

When i push on my gas my rpms go up and i have slow acceleration

The question is, is this an automatic or manual transmission, if its automatic then the tranny is sliping and if its a manual then the clutch plate is done. Now here is another thing very important IF the catlic converter is pluged then the acceleration gets slow too cause the exhaust cannot get out, so make sure?

Mar 02, 2011 | 2003 Toyota Celica

2 Answers

I have trouble filling my fuel tank. the nozzle always shuts off no matter how slow I pump the gas.

there is a screen in the fill neck, sounds like it is pluged, but being that new of a vehicle, id say someone had to of done something.

Dec 04, 2010 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

Why getting excess air in gas tank? when opening gas cap expulsion of air realeases every time. After about ten miles the car begins to hesitate as if you were putting your foot on and off the gas. It runs...

Youg tank shouldn't build up air.It has a vent or vent hose by the filler sout which maybe pluged or abstructed in some way.......Hope this helps.

Oct 08, 2010 | 1995 Mercury Villager

2 Answers

My jeep just started acting up it raddals and shakes when i push the gas and pops when i go around a curve and push the gas i have no power goin up a hill goes so slow. Anyone know whats wrong with it

Sounds like you might have bad spark plug wires, nothing a tune -up wont fix, spark plugs, spark plug wires, air filter, and gas filter, not knowing the year of your car, also check distributor cap and rotor,good luck, hope this was very helpful, happy 4th.

Jun 25, 2010 | Cars & Trucks

2 Answers

Car will start but then it dies wont stay on.oil indicator came on,checked oil, oil ok.has gas.

check your air filter. sounds like a bad map sensor or clogged fuel filter or possibly fuel pump is going

Dec 06, 2009 | 1999 Mercury Cougar

1 Answer

2003 Chevy S-10 Crew Cab slow filling tank which splashes back and shuts off gas pump hose. ? filler pipe problem.

Sounds like the vent is pluged, its either next to the filler pipe or inside the filler pipe, but in any case it will come from the gas tank
( most likely on top of tank) to vent the air thats traped in the tank, when its pluged there is no other place for the air to go but out the filler tube.

Oct 19, 2009 | 2003 Chevrolet S-10

1 Answer

Back end rides high!

it may not have been pluged in or the arm that goes from the contrl arm to the sensor not snap in to place . the rod snaps in to a ball and socket . if you look under the rear of the car you should see it it bolts to the fram and has a arm that goes to the lower control arm .

Jun 02, 2009 | 1990 Cadillac SeVille

1 Answer

Slow aceleration

has the fuel filter ben change?see if you catlike convertors are pluged.or try you mass air flow senser. it could be bad. good luck

May 31, 2009 | 1993 Saturn SW1

Not finding what you are looking for?
2003 Chevrolet Blazer Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides