Question about 2007 Toyota 4Runner

Open Question

What do the dots mean on the interior light for door, on, off, are they same as reading from left to right, door, off, on?

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2007 Buick Lucerne and the front reading lamps won't turn off.


Overhead Console Lamp and Roof Rail Courtesy/Reading Lamps
The courtesy/reading lamp is a duel purpose lamp that can be illuminated two different ways. First, the lamp can be turned ON during courtesy lamp operation as described above. Second, the lamps can be turned ON individually for reading lamp operation by the lamp switch. The BCM supplies battery voltage from the INT LAMPS fuse through the inadvertent power courtesy lamps circuit to the courtesy/reading lamps for reading lamp operation only. Ground for the courtesy lamp module or the roof/rail reading lamps is provided at G402

Courtesy Lamps
When either one of the front doors is opened, ground is applied through the door latch door open switch and the door open switch signal circuit to the door module indicting the door open position. In response to this signal, the door module sends a GMLAN serial data message to the BCM of the door open position. Or, when either one of the rear doors is opened, ground is applied through the door latch door open switch and the rear door open switch signal circuit to the BCM is indicating the rear door open position. Once a door open message or signal received, the BCM will then apply battery voltage from the CTSY/RF TRN fuse through the courtesy lamp supply voltage circuits illuminating the lamps listed below:
• Overhead console lamp
• Roof rail courtesy lamps
• Footwell courtesy lamps The BCM receives battery voltage from the INT LAMPS fuse in order to supply power to the inadvertent courtesy lamps. Inadvertent power courtesy lamp feature provides a similar function for the interior lamps as a retained accessory power feature. The BCM will energize the courtesy lamps supply voltage circuit when the BCM is in the active state (awake). When the inadvertent power courtesy lamps supply voltage circuit is energized, it supplies voltage to all the interior lights listed below. The BCM will continue to supply voltage to the interior lamps after the ignition is turned OFF so that the interior lamps may be operated.
• Overhead Console Reading Lamps
• Roof Rail Reading Lamps
• Vanity Mirror Lamps
• I/P Compartment Lamp
• Rear Compartment Courtesy Lamp
In the event that any of these lamps were to remain illuminated for a period of more than 20 minutes with the ignition switch in the OFF position and no BCM input activity, the BCM will deactivate the inadvertent power supply voltage circuit to prevent a total battery discharge condition. The BCM receives battery voltage from the CTSY/RF TRN fuse in order to supply power to the courtesy lamps. The BCM applies this voltage to the courtesy lamps through the courtesy lamp supply voltage circuits. When any door is opened, the door open switch contacts close and the BCM receives a door-open signal. If the BCM receives a door lock or unlock signal, the BCM will activate the courtesy lamp supply voltage circuit, providing battery voltage to the dome lamps and the left and right footwell courtesy lamps. The courtesy lamps can be manually activated by placing the interior lamp switch in the DOME position. For more detailed information concerning courtesy lamp operation refer to Interior Lighting Systems Description and Operation.

Jan 16, 2017 | Buick Cars & Trucks

1 Answer

Honda 2003 element, interior lights don't come on


is it on each door or only one door?
- only 1 door look like it's the switch of the door the trouble

-if it's all doorsyour light can be burn or you switch control can be off!! check where is you interior light you have a little switch with 3 positions OFF, AUTOMATIC AND ON! PLAY WITH AND SEE IF YOUR LIGHT TURN ON! put it in the middle the get full acces!
and on your Dashboard ( on the left side of the steering) you suppose the get a dimmer setting for you Dashboard lights and it control the interior lights too. if you put it too far from the right side you put the interior lights off and your Dashboard lights will be at full range! do the test!

Oct 05, 2014 | Cars & Trucks

1 Answer

How do you make the interior lights to come on


your switch control can be off!! check where is you interior light you maybe have a little switch with 3 positions OFF, AUTOMATIC AND ON! PLAY WITH AND SEE IF YOUR LIGHT TURN ON! put it in the middle the get full acces!
and on your Dashboard ( on the left side of the steering) you suppose the get a dimmer setting for you Dashboard lights and it control the interior lights too. if you put it too far from the right side you put the interior lights off and your Dashboard lights will be at full range! do the test!

only 1 door look like it's the switch of the door the trouble
if it's all doors your light can be burn

Oct 05, 2014 | Cars & Trucks

2 Answers

Interior lights won t turn on


It can be one of two problems. One: pending on what kind of car you have. ..there is a switch near the steering column that turns left or right...adjusting your dash lights and or turning on/you interior lights.#2...check the interior fuse bus panel/box

May 22, 2014 | 2005 Jaguar S-Type

2 Answers

Chevy trailblazer problems


its either a bad door switch,or could be the dome override switch by headlight switch,or your interior light switch is all the way up

May 01, 2014 | 2004 Chevrolet TrailBlazer

1 Answer

What is the function of three buttons located between the two interior front dome lights in the 2006 honda pilot?


One button has one dot, the next has two dots, and the third has three dots? These are the "home link" buttons. They can be programmed to open your automatic garage door openers.

Apr 14, 2013 | Honda Pilot Cars & Trucks

2 Answers

The rear cargo light won't turn off. This happened after I replaced a rear turn signal tail light bulb and a fuse for the horn. (These went out at the same time.) When the blinker light and horn were...


Hello! The instigator of this problem appears to be the the rear cargo lamp; Official name is rear dome light. You'll need a multimeter set on the X10 ohm scale to shoot this trouble. Leave the rear dome light bulb out. There are two switches involved; #1 the rear dome light on/off. #2 the right hand front door switch.

Pull the horn fuse out, remove the rear dome light cover, drop the rear dome light down to access the wiring and close all doors on the vehicle. Connect one lead of the ohm meter to the white wire and the other to body ground. If you read any resistance one or both of the two switches (dome light switch or right hand front door switch) is remaining closed when all doors are closed. Next disconnect the black lead from the dome light switch and see if reading changes to zero. If it does this is indicating that the dome light switch is defective. If it does not, disconnect the right hand door switch and take another reading at the same location. If you still measure any resistance, the black wire of the rear dome light is shorted to ground, if not then the right hand door switch is the culprit.

The reason the right hand door switch and not the left hand door switch is involved is the fact that opening the left front door would turn on the front dome light as well as the rear light. If both dome lights are staying on with all doors closed I would then involve both door switches in this test procedure. If your vehicle is a four door model then disconnect one door switch at a time while performing this test procedure.

The horn fuse also supplies power to the rear dome light, and I suspect the two events are related.


Guru..............saailer

Dec 13, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

Interior lights won't turn on when door opens


you have a bad drivers door latch, the micro switch inside is not telling the computer that the latch has been opened which would normally mean the door is open.

Mar 31, 2009 | 2000 Volkswagen Jetta TDI

1 Answer

Saturn Turn Signal / Dome Light Issues


The interior lamps system consists of 2 main features. Illuminated entry and a battery saver feature that will turn the interior lights off after 20 minutes if they are left On with all doors closed and the ignition Off. The body control module (BCM) controls both of these functions. Battery power is supplied by the BCM through CKT 1732 to the following lamps:
• The dome lamp
• The map lamps
• The rear reading lamps
• The rear dome lamp
• The cargo lamp
• The glove compartment lamp
• The courtesy lamps
• The sunshade lamps
The BCM also controls the ground circuit side of the dome lamp and reading lamps for illuminated entry. The dome lamp and reading lamp will remain on for 20 seconds after the ignition key is removed and the last door is closed. In addition, if the vehicle is equipped with remote keyless entry (RKE), the dome and reading lamps will turn On and stay on for 20 seconds after an UNLOCK signal is received from the keyless entry transmitter.
The reading lamps, dome lamp and map lamps can be turned On at any time by moving the appropriate switch to the On position.
The rear dome lamp is fed battery voltage through CKT 1732 from the BCM, through the liftgate ajar switch, and is grounded through CKT 650 to the rear ground splice pack. The rear dome lamp will turn on when the liftgate is opened. The cargo lamp is fed battery voltage through CKT 1732 from the BCM, through CKT 744 and grounded through the decklid ajar switch.
The courtesy lamps are fed battery power through CKT 1732 and are grounded through CKT 745-- left front, CKT 747--left rear, CKT 748--right rear, CKT 746--right front. These circuits will ground through the door jamb switches. The courtesy lamp will be illuminated when the affected door is opened. For example, when the right rear door is opened, the right rear door courtesy lamp will turn on.

Not a fuse problem , if the BCM had blown fuse other thing's wouldn't be working as well . . Probably wiring or BCM . Using factory diagnostic,s instead of guessing as to what the problem is , is the proper way .

Interior Lamps Diagnosis
Symptom
Procedure
Important: Before proceeding with these diagnostics, check for DTCs. If DTCs are present, complete the associated diagnostics. If the condition still exists, return to this chart.
All of the interior lamps are inoperative when any door is opened.
Chart 1
The dome lamp is inoperative in the ON position, but OK in the door position. The map lamps operate normally.
The dome lamp switch is faulty. Replace the dome lamp switch.
The dome lamp is inoperative in the DOOR position, but is OK in the ON position.
Chart 2
The dome lamp is inoperative in any position and both reading lamps are inoperative.
Disconnect the dome lamp connector (BLK 3-way).
Check for voltage at terminal "C" CKT 1732 ORN wire.
If OK, the dome/map lamp is faulty. If no voltage is present, there is an OPEN in CKT 1732.
Either the right or the left sunshade mirror lamp is inoperative.
Chart 3
Either the right or the left rear reading lamp is inoperative in the ON or the DOOR position.
Chart 4
The rear reading lamp is inoperative in the ON or the DOOR position.
Chart 5
Battery rundown protection is shorted to ground - B1482.
B1482
The left rear reading lamp is inoperative in the ON or the DOOR position.
Chart 6

Dec 12, 2017 | 1998 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...