Question about 2006 Toyota RAV4

Open Question

2&4 MISFIRE ON A 4 CLY. - 2006 Toyota RAV4

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 43 Answers

SOURCE: misfire cly#2 & cyl#4

What size engine is it ? Is the fault intermittent or constant?

Posted on Oct 14, 2013

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

05 navigator codes po012 intake " A " camshaft position over ******** bank 1 po302 random misfire po302 cyl. 2 misfire po303 cly. 3 misfire po304 cyl. 4 misfire po2195 o2 stuck lean bank 1 sensor 1 po2196...


there is nothing wrong with the timing chain position . Just a series of sensors that have gone outside the set parameters so if you check and change each one you will clear the faults.

Jan 03, 2014 | Lincoln Navigator Cars & Trucks

1 Answer

1997 saab 900 se 2.5. mutiplue misfire, cly #1 cly #3, cly #5. Checked timing belt, marks are lined up. car pops thru exhaust, and somtimes thru intake..


check for moisture in the distributor cap if you have one. Check that the HT leads are not touching each other causing a misfire through the lead with no compression in the cylinder. Use lead separators to stop the leads touching

Dec 13, 2013 | Saab Cars & Trucks

1 Answer

2011 Chrysler Town & Country


First check plug and wire .compression check #4 and one other cly. Compare . If you get the same or close to the same reading from both clys then you can eliminate a possible burnt valve.if it has individual coils switch#4 with another coil. And see if it reads another code for the cly you put #4into.if it still shows #4 misfire again,it's more than likely a bad or pluged injector when engine is running use long screwdriver and listen to hear the injector "click"...if it clicks that means you are getting a signal to the injector...good luck

Oct 31, 2013 | Cars & Trucks

3 Answers

Have a missing on 08 f150 4.6 went to auto zone and got a code reading and it said probable cause is a sludge throttle body/air flow got cleaner for it and clean throttle body but it still misses some one...


it is possible for it to be a coil, the thing with fords are that it takes alot of time for the misfire counter to turn the check engine light on and at the smae time set a code for missfire, if you have a code reader available check to set if there is a po301-po302 -po303,and so on the p is for power tran the o is that it is a generic code 3 indicateds misfire, 01,02 indicate which cly. is misfiring , alot of time you have to drive the fords for awhile before it will set a misfire code. if you have a good scan tool you can go to mode 6 and check misfire counters for which cly. is missing. than you can check compression in that cly, chec coil and plug.

Oct 30, 2013 | Cars & Trucks

1 Answer

Misfire cly#2 & cyl#4


What size engine is it ? Is the fault intermittent or constant?

Oct 14, 2013 | 2006 Toyota Tacoma

2 Answers

I have a 2000 lincoln ls 3.9 it has a misfire cly 4. I change spark plugs, coils, injector. and the intake seal. It still misfire cly 4. I also check compression it all same i all cly read 120 psi. it also...


Check the fuel injector..some time they give the same code like misfire..if it is good, than go ahead and check the wiring harness if there is a signal coming from it..if no signal..then follow the wire back to the source to see if there a short or open...good luck

May 05, 2011 | Lincoln LS Cars & Trucks

1 Answer

Check Engine Light coming on


get the soft ware up grade. and have the coils checked.

Mar 03, 2010 | 2002 BMW Z3

1 Answer

2002 PONTIAC VIBE, 1.8 L CODE SAYS MISFIRE ON # 2 CYL. ? NEED TO KNOW FROM L TO R CLY LOCATION?


the front of the engine is on the passenger side, so from right to left 1-2-3-4

Oct 06, 2009 | 2003 Pontiac Vibe

1 Answer

Engine misfire No cly.


Hi

Did you get to the bottom of this? thanks,jamie

Apr 29, 2009 | Volkswagen Golf Cars & Trucks

Not finding what you are looking for?
2006 Toyota RAV4 Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...