Question about 2000 Pontiac Sunfire

1 Answer

I have a 2000 pontiac sunfire, the brake lights, turn signals, rear window heater, door locks and hazard lights all stopped working at the same time. All fuses have been checked and are good. What could be the problem here?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 72 Answers

I would check for a broken ground strap some where

Posted on Mar 18, 2014

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 84 Answers

SOURCE: rear window defroster pontiac sunfire

those can be tricky to solve. get in the back of the car and look for a connector on the window. some times for some reason they let go. if it has let go then visit you auto store and ask for a fix there are a few products that are cheap. if it has not let go then if you know how to use a multi meter check for voltage on the connector/s if theres voltage then there is a break in the defroster somwhere

Posted on May 04, 2009

  • 3 Answers

SOURCE: 2000 pontiac montana power window|locks doesnt

I had a 99 with the same problem, and suggest you check under the passenger side front carpet. Remove the flat door kick plate, lift up the carpet on the front passenger side floor and you will see a large wiring harness running along the floor, wrapped in black tape. Water and salt gets into this harness and will rot out several wire splices that you will see. Look for wires that run from 2 wires down into one (under black tape.) These are spliced together, and rot out. There was several large gauge wires/splices(windows up and down) and I think 2 very thin wires/splices (lock/unlock) . Even if the wires look connected, give them a good tug, they will come apart and be green with corrosion. This is a very common problem and worth the effort to check out. Repairing these splices fixed both the power windows and locks at the same time. Good luck

Posted on Aug 15, 2009

  • 381 Answers

SOURCE: My 1999 Pontiac Sunfire's left

Your turn signal switch in your sterring colum is bad. The turn signal canceler in the switch is bad causeing both brake lights to be canceled all the time. Common problem

Posted on Nov 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My turn signal lights all work on my sunfire 2003 but, when put the flasher on (left or right), they either flash and then stop or not at all.......MAYDAY........


I think the turn signal and hazard light have different fuses. I believe the brake and hazard light have the same fuse. Does your brake light seem to work. First thing to check fuses and bulbs. This is my thought at the present time.

Jul 03, 2017 | Cars & Trucks

1 Answer

What fuse controls brake lights on a 2000 sunbird pontiac


The tail/stop/turn lights are protected by the 20A stop/hazard fuse in the instrument panel fuse block

Sep 08, 2012 | 2000 Pontiac Sunfire

1 Answer

Alarm not chirping dash not working


The problem is in the ignition cylinder lock.
The body control module (BCM) is what controls the theft deterrent system on the 2000 Pontiac Sunfire.
It can be reprogrammed, but is complex to do.

Here are some pictures for you.
http://www.autofuseboxdiagram.com/4232-2000-pontiac-sunfire-2-2-fuse-box-diagram/

http://www.automotix.net/usedautoparts/2000-pontiac-sunfire-chassis_computer-inventory.html?fit_notes=e1360a49a192739e006f059ad1d62904&seq_num=8

Sep 06, 2012 | Cars & Trucks

1 Answer

Fuses panel described in English


Hope this helps your out. I know the diagram and locator is a bit blurry but hopefully it gets what you need.
Drivers kick panel:
Front wiper 20A - Front wiper system Cigar 15A- Cigarette lighter Audio 10A- Audio, remote control mirror Air Bag 10A -Air bag diagnostics Stop lights- 15A -Rear brake light, high mounted stop light ECU B+ 10A - Shift lock actuator, transaxle controle module, radio, engine control module Room 10A - Interior light, clock, ignition key reminder, rear cargo area light switch ABS 10A- Anti lock brake system control unit ECU IG1 10A - Transaxle control module, shift lock actuator, ABS control unit, DRL unit Meter 10A - Instrument panel, back-up switch, electronics time control module, inhibit switch Turn signal 10A- Hazard switch ,front and rear turn lights, turn indicator IGN1 20A - Ignition switch ABS 30A- ABS pump motor TNS 30A- Tail light, license plate light COOL/FAN 30A- Cooling fan Cond/Fan 20A- A/C condenser fan Starter 15A- Start signal , Fuel pump Blower 25A- Blower Motor SR/ACC 10A - Ignition switch Hazard 15A - Hazard and turn signal light D/Lock 25A- Door locks ABS 30A - Anti lock brake system control P/W RH 20A- Power window motor right hand P/W LH 20A- Power window motor left hand IGN2 25A- Ignition Switch
Engine compartment :
Head 25A- headlights IG 2 30A- Ignition switch IG coil 15A -Ignition coil, condenser,generator IC regulator, diagnostic connector. O2 down 10A- Rear O2 sensor O2 up 10A- Front O2 sensor Fuel pump 10A -Fuel pump unit Injector 10A -Fuel injector ,camshaft positioning sensor, purge solenoid valve, EVAP, IAC actuator, Mass Airflow sensor, EGR stepper motor. fuel pump relay coil, vehicle speed sensor. A/Con 10A - A/C compressor controls, cooling fan BTN 30A- Brake light , high mounted stop light. Tail light LH 10A- License plate light, tail light , rear combo light, instrument panel illumination Tail light RH 10A-License plate light, tail light , rear combo light, instrument panel illumination Head low 15A- Headlight Head Hi 15A-Headlight Horn 15A- Horn jlmacman.png jlmacman_0.png

Inside kick panel jlmacman_1.png

Mar 07, 2011 | 1995 Kia Sephia

2 Answers

My 1999 Pontiac Sunfire's left and right brake lights are not working. The center one in the rear window does though. I have checjed the bulbs, the fuses and i have even changed out the brake switch at...


Your turn signal switch in your sterring colum is bad. The turn signal canceler in the switch is bad causeing both brake lights to be canceled all the time. Common problem

Nov 18, 2010 | 1999 Pontiac Sunfire

1 Answer

2003 pontiac sunfire no right rear turn signal or brake light just taillamp


I have had this experience myself. If the lamp is good try scraping the contacts inside the recepticle and raise the prongs on the lamp to make tighter contact. It worked for me.

Jan 08, 2010 | 2000 Pontiac Sunfire

3 Answers

Brake lights not working even though the brake peddle is pushed down The switch still goes in and out. Fuse box has some fuses missing. The fuse box does not have a desription on every plug of what it is...


Here are the numbers on your fuseblock and fuses coresponding to the number that is on your fuse block.
1-20 amp (yellow)
Hazard flasher
2-10 amp (red)
back up lights, A/C clutch cycling Switch
3-30 amp (green)
Power windows
4-30 amp (yellow)
A/C or heater blower motor
5-20 amp (yellow)
Panel Lights, Side marker lights, Park, Taillights, Clock & radio display Intensity, License & panel lights.
#6-10 amp (red)
Stoplight, buzzers, Anti-lock brake module
#7-15 amp (lt. Blue)
Tachometer, horn & Relay
#8-8 amp (yellow)
Power Door locks
#9-10 amp (red)
Radio
#10-10 amp (red)
Rear Wheel Anti-lock module, Turn Signals
#11-20 amp (Yellow)
Windshield wiper & washers
#12-15 amp ( LT. Blue)
Cigarette Lighter
#13-5 amp (tan)
Speed Control, warning buzzers, gauges, indicator lights
#14-5 amp (tan)
Time/delay relay & under-hood light, dome light, power mirrors, readio & clock Memory, Interior lights, reading lights
#15-blank
Not used
#16-4 amp (pink)
Radio Lights & overdrive switch light 1989-91, Cluster lights, Cigarette Lighter light & as tray light, Cluster lights, A/C & heater controls.
#17-relay
Hazard Flasher warning
#18-relay
Relay
#19-Circuit breaker
#20-relay
Turn signal Flasher
#21-buzzer
Warning
#22-Relay
Horn

Aug 04, 2009 | 1991 Dodge Dakota

1 Answer

Brake lights/turn signals work sporatically.


heyii lady i am not so sure in this case but if it is not a short then may be your induction coil is producing more crrent than required.. so get your coil checked.. or this time..if u have not been then put genuine compant lamps.. i hope this will help you out.. belated Merry X-mas and Happy New Year :)

Dec 29, 2008 | 2000 Pontiac Sunfire

1 Answer

No turn signals, cruise control, or brake lights


tou need to repl;ace the multi-function switch (turn signal switch) all your lights are run through it
rank my solution & vote 4 me

Dec 12, 2008 | 1995 Pontiac Sunfire

Not finding what you are looking for?
2000 Pontiac Sunfire Logo

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...