Question about 2000 Pontiac Bonneville

Open Question

How to remove ac compressor on bonneville

What bolts do I need to remove and how many and where are the located

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 611 Answers

SOURCE: ac compressor relay location

bottom left of he engine silver lines goin to it

Posted on Jun 16, 2008

  • 611 Answers

SOURCE: ac compressor relay location

should be in the fuse box under the hood

Posted on Jun 18, 2008

johnny5846
  • 379 Answers

SOURCE: 1999 Pontiac Bonneville serpentine belt installation.

if you look by the crankshaft pulley to the right you will see a tubular looking shaft about 1" diameter , you will notice you can't get the belt out from under this piece , it has a nut on it , once you take the nut off , you will notice it has a star shaped point on the tip of the stud , it requires a reverse torx socket or wrench to remove the stud , when you get the stud out the tube piece it can be removed , then the belt comes off , replace the belt , now comes the tricky part , fitting that tube spacer back into its spot , it can be difficult , once its in place put the stud back in , and put the nut on and tighten it , your pretty much a pro now . thanks.

Posted on Dec 30, 2008

emissionwiz
  • 75030 Answers

SOURCE: need to bypass the a/c compressor with pulley

see the dealer for the delete AC pulley, that is the only place to get it.

Posted on Aug 28, 2009

  • 3 Answers

SOURCE: i am trying to replace the ac compressor on my 98

there are two in the back. One to each side of the two lines. Center bolt holds the two lines in. Hard to get to. I had to disconnect the exhaust flange there to get some access

Posted on Jul 30, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove the alternator from a 2002 chrysler sebring without discharging the ac


alternator in tight spot,you need to loosen remove brace bolts you need brace with alternator.remove alternator pivot bolt and spacer and adjustment nut and bolt,when you remove alternator you have to angle it out through bracket by the AC COMPRESSOR. YOU DONT HAVE TO DISCONNECT ANY AC LINES OR COMPRESSOR TO REPLACE ALTERNATOR.

Nov 27, 2012 | Cars & Trucks

1 Answer

I have a 1995 pontiac Bonneville compressor is locked up and broke the serpentine belt need to fix please help thanks Ron


Most cars have an option to buy a belt for a car with or without Air Conditioning. I would check first if your car offers that option (then if you don't need AC you can just buy the other belt and not have to fix the compressor). If you need AC you will have to buy a new compressor (local junkyard is your cheapest bet). I would have a mechanic install either the new belt (to make sure no other pulleys were bent when the belt snapped) or the compressor (some AC lines can be difficult or dangerous to repair or replace). Good Luck!

Jan 11, 2011 | 1995 Pontiac Bonneville

1 Answer

Ac compressor grinding


You will need a new compressor clutch plate and pulley installed.If you attempt this the specs for spacing between the plate and pulley are 18-24 thousandths gap.You will also need a puller to remove the clutch plate.

Dec 06, 2010 | 1997 Pontiac Bonneville

1 Answer

Hello I have a 1997 Bonneville SE 3.8 with climate control display shows AC is on and Blower is high. BUT no AC and no Blower. I checked power connector at the blower motor and is reading 1.5 Volts.


you need new blower module located at blower under hood, against the firewall under the relays it has four or five wires in it, and two bolts holding it in.

Sep 02, 2009 | 1997 Pontiac Bonneville

1 Answer

I cannot remove AC compressor


in order to pull your bracket you have to pull the compressor of first, there are two bolts up front and one or two in the rear, those will have to be removed first

Jul 11, 2009 | 1997 Chevrolet Cavalier

1 Answer

01 Accent AC problems


1. Discharge/Recover the refrigerant. 2. Remove the tension bolt. a4c16f6.jpg 3. Remove the V-belt and magnetic clutch wire harness connector.
d768bec.jpg
4. Remove the suction hose and discharge hose from the compressor. 5. Remove the 4 mounting bolts on the compressor.
3bb9fac.jpg 6. Remove the compressor downwards.

INSTALLATION IN REVERSE ORDER
1. Tighten the 4 compressor mounting bolts.
2. Connect the suction hose and discharge hose to the compressor. 3. Connect the V belt. 4. Adjust the V belt tension.5. Reconnect the magnetic clutch wire harness connector.

Jun 04, 2009 | 2001 Hyundai Accent

2 Answers

Serpentine belt


Or buy the shorter belt and bypass the whole thing a/c comp.and all.just measure using some string and go buy the belt.

Aug 23, 2008 | 1995 Pontiac Bonneville

1 Answer

Ac repair procedure 2003 ford taurus


recover r134. remove cooling fan and shroud assembly. Remove surp belt. Unplug compressor connector. From under car. Remove ac manifold retaining bolt. Remove O2 sensor from exhaust for clearance. Unbolt compressor and remove (some of the bolts will have to be inserted into the new compressor prior to installation. Reverse all steps and evacuate and recharge system.

Jul 08, 2008 | 2003 Ford Taurus

1 Answer

Ac compressor relay location


should be in the fuse box under the hood

Jun 18, 2008 | 1991 Pontiac Bonneville

1 Answer

Ac compressor relay location


bottom left of he engine silver lines goin to it

Jun 14, 2008 | 1991 Pontiac Bonneville

Not finding what you are looking for?
2000 Pontiac Bonneville Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...