Question about 2006 Audi A4

Open Question

Audi a4 transmission range sensor - 2006 Audi A4

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

TLRogue
  • 99 Answers

SOURCE: temperature sensor audi a4

Possibly located at the back of the engine behind cylinder head, usually located in a small plastic hose block.

TL

Posted on Jan 23, 2009

  • 1 Answer

SOURCE: audi a4 2.8 30v 1998 ack engine

It is mounted to the transmission bellhousing on the driver's side. The connector is mounted on the firewall and is a smaller, gray connector. You can reach the sensor from underneath.

Posted on Apr 01, 2009

  • 37 Answers

SOURCE: fill transmission fluid on 19999 audi a4

LISTEN CLOSE. THERE IS A PLUG ON PAN. REMOVE IT. WITH A SYRINGE TYPE CANISTER YOU NEED TO INJECT THE FLUID INTO IT UNTIL IT STARTS TO COME OUT. THEN CAREFULLY START VEHICLE AND INJECT ANOTHER 3/4 QUART UNLESS IT STARTS TO COME OUT OR EVEN A QUART.LET IT RUN FOR 5 MINUTES THEN CONTINUE TO INSERT UNTIL IT OVERFLOWS AND TIGHTEN THE PLUG BACK TO THE PAN. i WOULD ONLY USE AUDI VOLKSWAGON FLUID AND YES IT CAN RUN $14 TO $18 A LITER

Posted on Apr 06, 2009

TDISLine
  • 1874 Answers

SOURCE: where is the 2004 audi a4 rpm sensor

For Diesel and also for Otto engines on 2004 Audi A4, this rpm sensor (impulse sender - crankshaft) is placed on the bottom left back side of the cylinder block. 966a88d.jpg Please Rate my Response! Thanks!

Posted on Jun 18, 2009

pippall
  • 1486 Answers

SOURCE: 1995 Audi A4 transmission control

If the tranmission codes are the same. yes you can.

Posted on Aug 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change crankshaft sensor on my 01 Audi A4 Quatro


What engine? Sensor is held in place by 10mm wrench size hex bold, on driver side of engine, near engine/transmission flange.

Jan 11, 2017 | 2001 Audi A4

1 Answer

Where is the vehicle speed sensor on a 2003 audi a4 quattro 3.0


the speed sensor is located in the transmission and when you replace it the speedometer should work like it should

Jan 03, 2017 | 2003 Audi A4

1 Answer

Adjust shift linkage


Either the unit itself or the internal wiring harness

Sep 23, 2013 | Audi A4 Cars & Trucks

1 Answer

Code P0706 transmission control module repair cost


You just don't throw a part on, If the problem is the transmission range selector switch (not the control module) the cost to repair will be around $250.00
P0706 AUDI - Transmission Range Sensor Circuit Range Performance
Possible causes- Open or short park/neutral position switch circuit
- Poor park/neutral position switch circuit connection
- Misadjusted park/neutral position switch
- Park/neutral position switch may be faulty
When is the code detected?The transmission range switch detects the selector lever position and sends a signal to the TCM.

Sep 18, 2012 | 2006 Audi A4

1 Answer

2002 a4 3.0 .need to know where the spped sensor is located ,and how to replace it thanks gerry


Speed sensor as in transmission like VSS Audi doesnt use on or RPM sensor as in the engine, Or wheel sensor for ABS Audi does use it is it for transmission or engine of wheel speed for ABS

Apr 24, 2011 | 2002 Audi A4

1 Answer

Audi a4 no reverse 5hp19


If all the gear selectors on the dash are lit up the tranny is in limp mode, so its more than likely the transmission range switch thats acting up not the transmission

Dec 19, 2010 | Audi A4 Cars & Trucks

1 Answer

Auldi a4 2005 auto will not go into rev some times have to turn car of then back on all warning lights come up


have warning light checked check fluid level of transmission could be a transmission sensor audi is haveing alot of trouble with transmissions

Dec 11, 2010 | 2005 Audi A4

2 Answers

Location of reversing light switch audi a4 cabriolet 2005 2.4 v6 reversing lights on permanantly when driving


I think on top of the transmission, the one has a wire, and looks like a sensor. To remove, need a 19mm , open wrench or socket wrench.

Feb 28, 2010 | 2005 Audi A4

2 Answers

Transmission problem with a 1999 audi a4 quattr0 2.8l


you may not need a transmission replacement, just try replacing the sensor of the transmission, it may help

Jul 02, 2009 | 1999 Audi A4

2 Answers

Audi a4 2.8 30v 1998 ack engine


It is mounted to the transmission bellhousing on the driver's side. The connector is mounted on the firewall and is a smaller, gray connector. You can reach the sensor from underneath.

Oct 07, 2008 | 1998 Audi A4

Not finding what you are looking for?
2006 Audi A4 Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14337 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...