Question about Ford Territory

1 Answer

Noise in transfer case

Have only had this car for a couple of months and when I went for a drive in the hills I noticed a noise coming from under the car, my son in-law is a mechanic and thinks that it is the transfer case, was wondering if anyone else has had a similar problem the car has only done 72600 km's and it is a 2010 AWD territory

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

  • Contributor
  • 35 Answers

It must be suspension.

Posted on Feb 07, 2014

Testimonial: "Thankyou for your response Sameer but I should have added that the noise comes on when travelling at about 80 kmph and when the car is under load as in going up hills. My son in=law had a listen while the car was up on a hoist and could hear the noise through a screwdriver placed on the transfer casing. I was wondering if this was a common fault with this model car. again thankyou for your input, regards Jeff"

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: transfer case clunk 2000 chevy silverado 1500 4x4

One thing to check, which is often the culprit in these situations is the U-joints. With the truck off, crawl under the vehicle and grab hold of the shaft leading into as well as the shaft going out of your transfer case, If htere is a lot of "slop in it, chance are it is in need of repair. Also I would check the oil level in the transfer case, in an attempt not to challenge you intelligence, there should be a plug located in the lower part about 2 inches from the bottom or so. it usually has a square hole that a 1/2" ratchet fits into. Pull the plug, and stick your pinky into the hole, you should be able to feel the lubricant just below the hole, if not it is in dire need of a filling. also check for metallic remnants in the fluid. this is a sign that things are not as they should be. In that case contact a repairman for a more thorough look.

Posted on Jul 13, 2009

fastboyz
  • 674 Answers

SOURCE: 2003 Mitsubishi Galant ES Clunking noise

the first thing i would check is the sway bar bushings they usualy go first. you have a bushing out somwhere. ive replace many struts because people have requested new struts and when we install them they come back and complain that the clunk is still there and all it needed was a bushing kit for $20
hope this helps

Posted on Aug 24, 2008

MrScary66613
  • 1990 Answers

SOURCE: my 1990 chevy is making a clicking noise around the transfer case

Is it louder when it is Cold?

Posted on Jan 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 chevy siverado Z71 4x4 noise from front differential when in 2 hi, no noise in 4 hi or low. Changed gear lube lube, went for drive no noise. Next day noise came back, any help


Are you sure that the noise isn't coming from the transfer case? The front dif shouldn't care what gear your transfer case is in, it is either receiving power or it isn't.

Jan 23, 2016 | Cars & Trucks

1 Answer

I have a '08 Ford F150 FX4. Recently I had to use my 4 H for a short drive. I had no issues until a couple of days later, when I notice a rattling noise in 2H, which sounded like a rattling noise si


If it isn't a heat shield or something like that,
then your pulling the transfer & taking it apart

Google your transfer mfg case or unit number & see what
problems come up

Call this place
They have a web site

Drivetrain.Com

Mar 11, 2014 | Cars & Trucks

1 Answer

2007 Saturn Vue front wheel noises


replace with new one pads recommend manufacturer!!

Jun 04, 2013 | Cars & Trucks

1 Answer

I have a 4.0 grand cherokee 2000, when shifting reverse gear , it makea a loud sound (TUK). But there is no problem in driving and gear shifting is normal.


Some vehicles with automatic transmissions have enough slop to create this noise normally. If the problem just started or has become increasingly worse, it could be due to worn universal joints. The universal joints couple the drive shaft to the drive axle and the transmission on 2-WD and to the transfer case on 4-WD. Another noise that comes from worn universal joints is a squeeking sound at lower speeds. A vibration could also be noticed with worn universal joints.

Jun 05, 2011 | 2000 Jeep Grand Cherokee

1 Answer

Very noisy front axle when in four wheel drive, noise is excesive and gets worse when going up hill.


You may have a bearing or a u joint going bad, transaxle or transfer case may be bad also.. this is a new truck, get it to the dealer so they can fix this under warranty

Apr 28, 2011 | 2011 Chevrolet Silverado 1500

1 Answer

The 4 wheel drive on my 2000 jeep grand cherokee


The ticking noise is most likely your tranfer case chain. the chains in this case...overtime....will stretch, causing the chain to have enough slack the hit the bottom of the case.

Jan 21, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Clicking noise from drive shaft


Take it back to the installer of the drive shaft and demonstate to them the problem.

The symptons you describe a indicate to me you have a faulty constant velocity drive joint or inadequate grease lubrication in the joint.

If the drive shaft proves to be the problem, it should be replaced with a new unit under warranty.



Jun 14, 2009 | 2001 Volvo S40

1 Answer

Maybe transfer case or tranny


I would start with checking u joints first they can make more noise if under more load.

May 18, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Transfer case is popping/jerking in low speed turns


Center differential is broken,you can test it by doing tight circles in a car park 3 or 4 to the left and repeat to the right,if it doesn't un block and it still feels like you're driving over marbles (big ones) when you turn you're sure it's the c.diff.
Check tyres are all in spec.identical and same usage, right pressure.

May 15, 2009 | 2004 Subaru Forester

1 Answer

Well where the real drive shaft meets the front axel which I think is the 4 wheel drive chain case. It was making a noise, that sounded like I was dragging a can behind the truck. It started to get worse...


The transfer case is what you are describing,,and to convert it to 2wd is possible,but very expensive as you would have to change the transmission itself to a 2wd,and then obtain a rear 2wd driveshaft.It would be more cost effective to rebuild,or replace with a good used,transfer case.

Jul 13, 2008 | 2001 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

739 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5677 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...