Question about Ford F-150

Open Question

Diagram sensor location

Cylinder head temperature sensor location & diagram

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 65 Answers

SOURCE: how do i change cylinder head sensor and where is it located

if you know engine fairly well the sensor should be pretty easy to spot it will be coming out of the cylinder head and have a wire attached to it although I haven't done much work on those models I wasn't aware they had that type of sensor are you sure your not looking for the temp sending unit? if so you will need to look on the intake manifold or near the water pump either way you may consider buying the sensor first then matching it with the wire/wires coming into it then simply unplug that sensor and unscrew (standard threads) make sure to properly seal the threads on the new one tighten to spec (be careful not to over tighten this component more than likely will thread into aluminum threads) better to be to loose and have to be tightened again than to have to replace a major component

Posted on Apr 26, 2009

  • 783 Answers

SOURCE: location of CHT sensor

It is located at the back of the passenger side cylinder head close to where the intake manifold and head meet.It will have a YE/LG and GY/RD wires to it.

Posted on May 24, 2009

  • 1810 Answers

SOURCE: Where is the Cylinder Head Temp Sensor on the 2001

chilton make a great bible for your car that will help it's sold at chapters

Posted on Jan 06, 2010

  • 95 Answers

SOURCE: Need to know where the cylinder head temperature

It should be on the driver's side of the head in the heater hose or tube, there should be two of them, one for the computer and one for the temperature gauge. Good luck.

Posted on Jun 25, 2010

  • 400 Answers

SOURCE: 1994 Chevrolet Astro replacing coolant temperature sensor. Where is it located? Picture or diagram answer

Its usually in the side of your thermostat housing. has a 2 or 3 wire plug hooked to it

Posted on May 04, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

4.6 L. V8 Triton. Where is the CHT sensor located?

Cylinder Head Temperature (CHT) Sensor -4.6L and 5.4L Removal
  1. Remove the intake manifold; refer to Section 303-01B .
  1. Remove the cylinder head temperature (CHT) sensor.
    1. Disconnect the connector.
    1. Remove the CHT sensor.

Feb 22, 2016 | 1998 Ford F150 Regular Cab

1 Answer

2001 Excursion 6.8 V10, hard start, high idle, code P1288 KOEO, and KOER, no memory codes, with temp gauge in normal range scan data reads 20 deg F, suspect CHT sensors looking for sensor location.

CHT -cylinder head temperature sensor located under the intake have to remove intake manifold to replace sensor its in the cylinder head.

Oct 22, 2013 | Ford Cars & Trucks

1 Answer

Location of coolant temperature sensor on a 2006 Nissan Sentra

it is on the back of the cylinder head and can see it from the passenger side

Dec 12, 2012 | 2006 Nissan Sentra

1 Answer

Please can anyone tell me where the Coolant Temp Sensor is located

FOr 1993 Audi 90 2.8L SFI 6cyl the Coolant Temperature Sensor is located under hood, passenger side, rear engine area, mounted in cylinder head. Im sorry, but haven't some diagram.

Hope this helps (remember to rate this answer).

May 10, 2011 | 1993 Audi 90

1 Answer

Need to located the temperature sensor on 2002 ford f-150 4.2

The coolant temperature is measured from the cylinder head temperature sensor CHT and is located on the drivers side cylinder head in the rear. It is connected to the harness by connector C107 and has gray/red and yellow/light green wires going to pins 39 and 55 of the processor.

Apr 07, 2011 | 2002 Ford F150 Regular Cab

1 Answer

Cobalt coolant temperature sensor diagram


Aug 20, 2010 | Chevrolet Cobalt Cars & Trucks

1 Answer

I need a full diagram of under the hood of a 1989 Honda Accord Lx or the diagram of where to find the Coolant Temperature Sensor

The coolant temperature sensor is located under the hood on the driver's side, upper engine area, and mounted on the rear of the cylinder head. Hope this helped and best wishes.

Sep 09, 2009 | 1989 Honda Accord 4 Door

1 Answer

Where is the coolant temperature sensor

These are located in the cylinder head in the back of the head...meaning 180 degrees from the belts and pulleys(front) or the side the transmission is on. Two sensors exist...the single wire sensor is for the dash gauge. Saturn pn# 21025106 is the one you need

Aug 12, 2009 | Saturn SL1 Cars & Trucks

3 Answers

97 Pontiac Sunfire - where is the temperature sensor located?

the coolant temp sensor is located: Under hood, driver side, upper engine area, below valve cover, mounted in cylinder head

May 05, 2009 | 1997 Pontiac Sunfire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides