Question about Cars & Trucks

Open Question

How to replace rack and pinion on a 2001 chevy malibu

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: Replacing a rack and pinion for 1999 Toyota Corolla

no you do not/ Please rate my response thank you very much

Posted on Feb 02, 2009

  • 57 Answers

SOURCE: replace rack/pinion

The book calls for about 5 hours labor with a lift, air tools, and experience. It's a tough job. Here are a few tips, Take the lines loose from the rack; not the pump. With the tires off, Remove the nuts from the outer tie rods.Run the nuts back on the tie rods stud and hit the steering knuckle where the tie rod's stud goes through.This will free the stud. Remove the steering shaft from the rack.(take the bolt all the way out.Remove rack mounting bolts. Twist,pull ****,and fight the rack out the side of the car with the most room. The new rack will have inner tie rods already installed. Make sure the new rack is centered.(Turn left then right count the turns then center same # of turns from left to right). Count the threads or measure from the outer tie rod's jam nut to the last thread on the inner tie rod.(you can leave the jam nut in place and take the outer tie rod off and measure from the jam nut to the end of the rod.)Install the outer tie rods. Replace rack in car. hook up steering shaft.Bolt up rack. Hook up lines. Add fluid and work rack back and forth to bleed air. recheck fluid. Have it aligned. (or just take it to a shop.This job is going to be a nightmare!!!)

Posted on May 23, 2009

  • 3600 Answers

SOURCE: rack and pinion leak

It needs replaced a rebuilt unit cost $350.00 and you need the tools to remove the tie rod ends and you have to unhook the steering wheel, if you have a hoist it's not to bad but a do it yourselfer it's a pretty big job, the fluid is that color because it's sucking air into the fluid because of the leak and the shaking is caused by one side not holding hydrolic pressure because of the leak and wore out inner tierod ends. If you do do it you need a whole lot more information and much more instructions to do it, afterwords it will have to be alingned, having done it before and having the proper air tools I can do one in three hours. You might take a week but it would be a learning experince.

Posted on May 30, 2009

  • 109 Answers

SOURCE: rack & pinion replacement

there many web sites that offer tech suppurt, even Chrysler, just start looking, also Napa Auto Parts. Auto Zone. This is to hard to explain on a site like this. GOOD LUCK RDJRP

Posted on Aug 07, 2009

  • 468 Answers

SOURCE: how to replace rack and pinion on chevy 2003

Silverados do not have rack and pinion steering. The steering box is bolted to the frame on the drivers side, that can be removed by removing the bolts holding it on, the steering shaft bolts, and the pitman arm.

Posted on Oct 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove rack and pinion on 2002 chevy venture


Gary: Try watching this video that shows how to replace your rack and pinion: https://www.youtube.com/watch?v=lBAy-Jcy-BQ

Nov 02, 2013 | 2001 Chevrolet Venture

1 Answer

How to replace the rack and pinion on a 01 chevy malibu


how to change rack and pinion on Malibu 2001

Jan 20, 2013 | 2001 Chevrolet Malibu

1 Answer

How to remove rack and pinion from 99 chrysler lhs


There are few help links showing exact accurate procedure to replace Rack and Pinion. Click the link below and follow the procedure:-----
Pinion Seal Replace on Dodge Dakota? http://howtobyme.blogspot.in/2012/04/pinion-seal-replace-on-dodge-dakota.html

-----------

How to Replace a Rear Pinion Seal.
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-rear-pinion-seal.html
------------

How to replace Power steering rack and pinion gear on Chevy Silverado 2500 HD? http://technoanswers.blogspot.in/2012/02/how-to-replace-power-steering-rack-and.html

----------
How to replace Power Rack and Pinion Steering Gear on Acura Car Models? http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-power-rack-and-pinion.html

-----------
How to replace power rack and pinion steering gear on Toyota cruiser? http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-power-rack-and-pinion.html

----------


How to replace Power Rack and Pinion Steering Gear on Acura Car Models? http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-power-rack-and-pinion.html


------------
Front Drive Pinion Seal Removal on Ford Explorer? http://repairhelpcenter.blogspot.in/2012/03/front-drive-pinion-seal-removal-on-ford.html

-------------
How to Replace Driveshaft, Pinion Flange & Seal?

http://repairhelpcenter.blogspot.in/2012/03/how-to-replace-driveshaft-pinion-flange.html

------------


How to Replace Power Rack & Pinion Steering Gear On 2007 Ford Taurus? http://repairhelpcenter.blogspot.in/2012/03/how-to-replace-power-rack-pinion.html


----------
How to Remove Power Rack & Pinion Steering Gear on Ford Windstar? http://repairhelpcenter.blogspot.in/2012/03/how-to-remove-power-rack-pinion.html

-----------

Power Rack & Pinion Steering Gear replacing details for Buick Park Avenue and Pontiac Bonneville

http://repairhelpcenter.blogspot.in/2012/03/power-rack-pinion-steering-gear.html

-------------


How to Replace Power Rack & Pinion Steering Gear on Mercedes Benz Truck? http://howtobyme.blogspot.in/2012/03/how-to-replace-power-rack-pinion.html


---------
How to replace Power Rack & Pinion Steering Gear on Toyota 4Runner? http://howtobyme.blogspot.in/2012/03/how-to-replace-power-rack-pinion_27.html

-----------

Power Rack & Pinion Steering Gear Replacing on Toyota Land Cruiser & Sequoia? http://schematicsdiagram.blogspot.in/2012/03/power-rack-pinion-steering-gear.html

----------
Power Rack & Pinion Steering Gear Removal on Toyota RAV4? http://repairhelpcenter.blogspot.in/2012/03/power-rack-pinion-steering-gear-removal.html

----------
How to Replace Power Rack & Pinion Steering Gear on Toyota Sienna? http://technoanswers.blogspot.in/2012/03/how-to-replace-power-rack-pinion.html

------------
These details will help.
Thanks.



Nov 23, 2012 | Cars & Trucks

1 Answer

What's your problei have a 2004 chevy malibu classic, when im brakeing and turning to the left the car sounds like a bad bearing but it feels like its binding up. what could be causing this proble


It could be something to do with the rack n pinion. I also own a 2004 chevy malibu classic and I have had to change the "steering rack." Now dont hold me to that, but with a little more info on how the car is acting and driving I may be able to further assist this problem. Hope this helps. Good luck

Apr 27, 2012 | Chevrolet Malibu Cars & Trucks

2 Answers

How do you fix the power steering of a 2006 chevy malibu, when drive the steering wheel locks up and its very hard to turn.


a few possibilities.
Low power steering fluid. check for correct amount on pump filler measureing guage.

Loose power steering belt. check to see if the belt slips over the power steering pulley while trying to turn the steering wheel. may need an assistant.

last, but most expensive. Rack and pinion steering bar is defective and needs replacing.

Jan 13, 2011 | 2006 Chevrolet Malibu

1 Answer

Is it easy to get to the rack & pinion on a 1998 chevy malibu


Depends on where you are located but log on to the main site to get details or try for second hand spares.

www.chevrolet.com/malibu

Sep 16, 2010 | 1998 Chevrolet Malibu

2 Answers

Steering knock/pop while turning on 2005' chevy


sounds like a steering column universal gone bad try shaking wheel while in park an look under hood at steering shaft

Aug 05, 2009 | 2005 Chevrolet Malibu

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...