Question about Chevrolet Malibu

Open Question

Erls fuse blowing

The elrs fuse is blown as soon as the switch is turned on.this is an o3 Malibu.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
gottahemmy
  • 26 Answers

SOURCE: blowing atc fuse

you have a short in the circuit somewhere. look for a wire that has been rubbing on something or has come lose and is grounding out.

Posted on Jan 04, 2009

Ad
  • 111 Answers

SOURCE: rear fog light blows fuse

Check the relay for these lights. Might be melted or frayed wires. Also check any existing wires coming to/from the lights. These are usually run in series with something else and could be just a ground/hot wire popping the fuse.

Posted on May 21, 2009

motor1258
  • 6674 Answers

SOURCE: fuse blows for wiper as soon as i turn on the wiper switch

If you can remove connector to wipers, do it, then turn them on and see what happens. If fuse blows, it's most likely a short in wiring harness, if it doesn't, then most likely the motor. Does it attempt to move at all, before it blows? Look for bad or bare wire in harness as well.

Posted on May 31, 2009

  • 22 Answers

SOURCE: My key will not turn the switch in my 2003 Chevy

sometimes when people have to many things on a keychain it can cause wear in the tumblers in the ignition so always have just your car key and remote only on your keyring,but try to mess with the shifter at the same time turn the key ive seen this happen alot.

Posted on May 29, 2010

  • 4044 Answers

SOURCE: illuminating lights out fuse is

By your description I assume this is an interior light. You will need to trace the wires going to the lights and find the one that is grounding and causing a short. You might be able to remove all the interior bulbs and replace the fuse then after turning them on if the fuse doesn't blow replace them one at a time till you find the one that has a problem and trace that wire back. Make sure you check any spices you may have added to install Amplifiers or Radios that didn't come with the vehicle.

Posted on Aug 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 Cadillac deville elrs fuse blowing intermittently need Mitchell electrical wiring schematic / harness locations


fuses blow because the current flow is in excess of the fuse rating and that is normally from a dead short in the circuit after the fuse
I suspect that the ac compressor rely is faulty and I would start looking in that area

Aug 12, 2016 | 1993 Cadillac DeVille

1 Answer

09 Sonata both low beams stopped working this morning. Fuse was blown, replaced it as soon as I turned on key fuse blows. Switched relay...no help


If fuse is black when it blows is because of a short most likely a wire pinched against the body. Is fuse blows and not black than it is an overload at which I don't think that would be the case

Mar 25, 2015 | 2009 Hyundai Sonata

1 Answer

Fuse keeps blowing


Once a fuse blows & you replace it-- ONE Time--
then you stop

You go to wiring diagrams of the circuit with the
blown fuse & start your testing

Aug 11, 2014 | 1994 GMC Sonoma

1 Answer

Fuse to heater keeps blowing


Is this fuse also feeding power to something else that is sucking too much power? when it has blown, what else stops working, because there is no power to it? is it dash lights?, the stereo?, any other thing?

Dec 21, 2013 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

Fuse #47 blowes on my 2000 focus all bulbs are good


it only means that your elecrical system on your running light was grounded thats why everytime you switch on the running light the fuse blown. The only solution to that is to find out where the line was shorted or grounded. you must start tracing it from your switch going down the elecrical line going to the fuse, relay and lights.
That's it, good luck then.!!!

Oct 01, 2012 | 2000 Ford Focus

1 Answer

Both elec door mirrors stopped responding same tme, why?


First, make sure you do not have the mirror control switch in the "neutral" position. If it is, neither mirror will work. If the switch is in the correct position to operate each mirror and neither of them work, the next thing I would check would be the MIRRORS fuse (2 Amp) located in the Body Control Module Fuse Block under the right side of the dash near the blower motor. If the fuse is blown, you probably have one of your mirror circuits shorting to ground. In this case, I would replace the fuse and see if it blows again when I operate each mirror. If one side works and the fuse blows when trying to operate the other side, then you at least know which mirror circuit is shorted and you can diagnose accordingly. If the fuse blows immediately (without operating the switch), or if the fuse is not blown, then you most likely have a defective mirror control switch or a broken wire in the umbilical that goes between the body and the driver's door.

Jan 09, 2012 | 2004 Chevrolet Malibu Maxx

1 Answer

Wind shield wiper blowing fuses


You have a short circuit to ground when the switch for the wipers is turned on. It does absolutely no good to keep replacing the fuse until the short circuit has been located and repaired. I guess you are just starting to figure this out five fuses later.

The lesson here is that fuses do not cause electrical circuit failures. Electrical circuit failures cause blown fuses. There are many people that do not understand this.

If the fuse remains intact until you turn the switch on, you will find the problem between the wiper (combination) switch and the wiper motor assembly or the wiper motor itself.

Nov 23, 2011 | 2004 Kia Sorento

1 Answer

As soon as i turn key in ignition it blows a 20amp fuse under hood,know little about electrics but afford to take it to garrage,checked starter connection nothing. any help would be greatful.


Which fuse does it blow? do a wiggle test to wires that comedown from ignition switch.the component fuse would give us a clue. does vehicle start with fuse blown?

Mar 27, 2011 | Toyota RAV4 Cars & Trucks

1 Answer

2001 cheve malibu. The Automatic lights, fuel guage, power windows quit working. The radio comes on when you turn off the switch but goes off when you turn it on.


It sounds like a short in your ignition switch. I assume you engine will not start? Check your fuses because if it is a short it should have blown a fuse or you would have smelled burning isolation from the wires. If you find a fuse blown it could give you a starting place to start checking. If the ignition fuse is blown it is in the ignition, wiring, starter or ignition key switch.

Aug 12, 2010 | 2001 Chevrolet Malibu

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...