Started to work this am and when i shifted to 5th it was nothing there, no noise or nothing 5th gear was just gone
SOURCE: 94 Jeep Wrangler intermittently stalls when put in reverse, drive
Take the air inlet hose off where it enters the throttle body and take a look at the throttle plates. It is likely that they’re dirty and have a build-up of carbon deposits. That is the most common cause for stalling that we see in the shop for your vehicle. Sometimes all it takes is a good cleaning to cure the stalling problem. There is an idle speed setting on your Jeep, but to check and/or perform this service step requires the use of a computer scan tool for your vehicle. If the cleaning doesn’t help ask a repair facility to check and reset, if needed, the minimum idle speed on your Jeep.
Thnx.
SOURCE: 1991 jeep wrangler sahara shifting promblems
Your clutch is not disengaging. If it a hydrolic clutch chk. the fluid in resavor, Or slave cyl. for the clutch is bad, Or it has got air in it and needs to be bleed. This is a clutch problem, nothing wrong with trans. If its a manual clutch linkage its an ajustment thing. My best guess if its hydrolic slave cyl. went bad, or resavor is out of fluid.
SOURCE: 1999 jeep wrangler no reverse
i would say your reverse gear is locking up on you and that you need to get it to a transmission shop before you break the gear off trying to back it up,,it will mess up the other gears
SOURCE: 5th. Gear
Sounds like you may have bent a shift fork or your cluster gear has some missing teeth on it now. I would venture to say that is it a bent shift fork. This will require the transmission be removed to gain access to inspect and repair.
SOURCE: 1989 jeep wrangler wont shift gear and clutch gone loose
Get the clutch slave cylinder and master cylinder looked at.One of the 2 has failed.If the pedal goes to the floor or is very loose,this is very likely the cause.Not an expensive fix.Hope this helps
Testimonial: "succinct. precise. prompt. thank you so much."
294 views
Usually answered in minutes!
×