pedal goes to floor no brake. brake fluid leaks out of a crack between rubber and a brass cylinder. There are I think four of these cylinders sticking out of a large component where all the brake lines seem to set out from. The one that leaks is off set a bit like it blew out a bit...it is not the master cylinder....I think that if one could pull it out and replace the rubber seal it might seem to fixer up god forbid if the whole large assembly needs replacing because it makes my pocketbook shiver at the thought....
Comments:
Jun 06, 2009
- thanks for the reply,but what is this device? ABS?
disconnect the line check the threads on the cylinder to make sure they are not crossed if they aren't replace the line if they are you could either replace the cylinder or tape the threads
pushed clutch in and petal stayed on floor. vehicle is still in gear. clutch is realatively new and...
(More)
pushed clutch in and petal stayed on floor. vehicle is still in gear. clutch is realatively new and didn't have any problems untill i pushed it in to shift.
i have a 92 bronco and iam putting different doors on it that have power windows locks and...
(More)
i have a 92 bronco and iam putting different doors on it that have power windows locks and mirrors.can u help me with the wiring
I get axle lube on the passenger front wheel mag.It takes some timeafter cleaning the wheel 3-400...
(More)
I get axle lube on the passenger front wheel mag.It takes some timeafter cleaning the wheel 3-400 miles.
my scaner give me de code -172 ego not switching lean exhaust bank 1 -136 no ego (h0o2-1)...
(More)
my scaner give me de code -172 ego not switching lean exhaust bank 1 -136 no ego (h0o2-1) switch-lean exhaust (bank 2) -335 egr (pfe-dpfe) signal out of range -and exhaust precsure higt or egr (pfe) signal hiht my car is a 1994 ford explorer------ 4.0