NEED TO REPLACE ALTERNATOR MYSELF

here's 96. should be the same. Be very careful not to overtighten any of the belts or you can break the snout off the crankshaft and ruin you engine.

Section 14-02: Generator, Integral Regulator — Internal Fan and Regulator Type 1996 Villager Workshop Manual
REMOVAL AND INSTALLATION Generator Removal

1. Disconnect the battery ground cable (14301).
   

1. Raise and support the vehicle.
   

1. Remove the five engine and transmission splash shield bolts and two engine and transmission splash shield screws.
   
   
   
   
   

1. Remove the RH engine and transmission splash shield (6775).
   

1. Remove the wire harness bracket bolt.
   
   
   
   
   

1. Remove the B-terminal insulator boot.
   

1. Disconnect the generator electrical connector from the generator (GEN) (10346).
   

1. Remove the ground wire nut from the generator and position the ground wire aside.
   

1. Remove the B-terminal nut from the generator and position the B-terminal wire aside.
   
   
   
   
   

1. Loosen the inner and outer generator-to-bracket bolts.
   
   
   
   
   

1. Loosen the generator locking bolt.
   
   
   
   
   

1. Loosen the generator adjustment bolt.
   
   
   
   
   

1. Remove the drive belt (8620) from the generator pulley (10344).
   

1. Remove the generator locking bolt and washer.
   

1. Remove the inner generator-to-bracket bolt and the two washers.
   

1. Remove the outer generator-to-bracket bolt and the two washers.
   

1. Remove the generator.
   

Installation
To install, reverse the removal procedure. Tighten the inner generator-to-bracket bolt to 23-26 Nm (17-19 lb-ft). Tighten the outer generator-to-bracket bolt to 23-26 Nm (17-19 lb-ft). Tighten the generator locking bolt to 16-20 Nm (12-15 lb-ft). Adjust the drive belt very carefully. Refer to Section 03-05 for the procedure.

how to change the fan belts on 1993 Nissan Quest Minivan