2003 dodge Caravan FWD wheel stud replacement

Here is some help for you to replace the broken wheel studs on your 2002 Dodge Grand Caravan, you will need to follow these steps:

First, you will need to remove the tire that has the broken studs. You can do this by using a tire jack to lift the car and then using a lug wrench to loosen the lug nuts. Once the lug nuts are loosened, you can remove the tire from the car.

Once the tire is removed, you will need to use a hammer and punch to carefully tap the remaining pieces of the broken studs out of the hub.

Next, you will need to purchase new wheel studs that are compatible with your car. You can find these at an auto parts store or online.

Once you have the new studs, you will need to use a press or a hydraulic tool to press the studs into the hub. Make sure that the studs are pressed in evenly and securely.

Finally, you can replace the tire and lug nuts, and lower the car back to the ground. Test the new studs to make sure that they are secure and that the tire is properly seated on the hub.

jack up vehicle, remove tire. knock out old stud with a hammer and punch. put new stud in from back if need be. to draw it up tight.use a lug nut with something under it so when you tighten the nut it brings the stud into position. remove the nut you put on. and replace the tire. good-day! if the brakes and rotor are in the way. you will have to remove them to replace the wheel stud.

Hi, what you will need to do is take 5 to 6 washers and take the wheel off and put the washers on over the stud that is loose and take a lug nut and tighten it down till it pulls the stud back into the hub. if it does not tighten up and spins you will need to replace it. just take the brake caliper and bracket off and the rotor. then pound the old stud out and insert the new one then use the washers and lug nut to pull the stud into the hub. good luck

Yeah , it's a fairly simple repair, All the wheel studs must be replaced and lug nuts also.Closely examine the wheel or get competent tyre replacement company to double check for damage ! Remove the brake disc caliper and brake disc itself (usually 2 cross head screws) , tap off (gently) it may be stuck thru corrosion / rust etc , Broken studs can be knocked out(towards drive shaft ) of the hub assy with a suitable drift and hammer (splined into hub) . The studs are a servicable replacement part. Check all other wheel nuts as this is usually a result from poor fixing or wheel replacement recently .. Good luck

Yes they will, front or back, smack the end of stud with a good ballpeen hammer and wiggle them out, **** the new one in place with lots of big washers and socket and torque handle, then torque your wheel nuts with rim on to 85 ft lbs. GOOD LUCK, RDJRP

Should be a pressed in wheel stud, remove hub and have old one pressed out or you can do it the primitive way, by double nutting the old stud and striking it with a hammer to pound it out, if threads are bad then just strike the stud by itself , then replace new stud in opposite fashion...

The studs press out and in. Perhaps a hammer would work. Replacements studs can be purchased. Need to remove hub, of course.

Not on front wheel drives,the hub needs to be removed to do it.

front rotor is slip on design..just may be stuck to hub..remove caliper and caliper bracket..remove rotor knock broken stud out with hammer/punch..install new stud with washers and nut

You can get a complete hub with bearing and its can just be bolted on, without having to have bearing pressed in and out. Good luck and thanks for using FIX YA