2007 Kia Rio 1.6 Logo

Related Topics:

O
Oloyede Abdulwasiu Posted on Jan 31, 2014

P0745 Kia rio

The car is not sharp when taking off from rest

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Oct 02, 2008

SOURCE: Kia Rio 2002 - Car not response when press gas

can anyone tell me how to change the time belt on my kia rio cinco

Ad

Anonymous

  • 1 Answer
  • Posted on Nov 19, 2008

SOURCE: 2003 Kia Rio radio station settings

Go to the radio station that you want, once there, push any of the numbered buttons and hold it there for a couple of seconds. That should set it.

Danniboi

Dan Doherty

  • 1099 Answers
  • Posted on Feb 03, 2010

SOURCE: kia rio wont start after changing lambda sensor

Hi
I cant tell you why but I do have a solution for you to try, I had a similar fault on a fiat punto last year, I disconnected the battery for an hour and then put it back and the car started, Im still puzzled by this but It may work for you, worth ago, make sure you have your radio code before removing the battery

Hope this helps
Regards
Dan

Anonymous

  • 2 Answers
  • Posted on May 02, 2010

SOURCE: 2003 kia rio I changed the fuel filter the car

had similar problem, 2003 rio 1.6l idle fine and die when trying to accelerate or lurch and die ran fine in reverse change timing belt,wires plugs, had codes for multi cyl misfire and low injector voltage, still same lurch and die. try wiggle test on sensor plugs and main engine harness between battery and engine . i did this and found car smoothed out,tried wiggle again and car died,took harness apart where i wiggled it and found broken wire to crank sensor.good now

GeoffW1

Geoffrey White

  • 3965 Answers
  • Posted on Sep 13, 2012

SOURCE: 2004 Kia Rio timing belt replaced but now car shakes and runs rough

Most likely the timing is out by a tooth or two on the new belt. It will have to be taken off and reset.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Torque spec 2009 kia rio inner tie rod end

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals
0helpful
1answer

Swapping kia Sophia engine into 2001 kia rio

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals
0helpful
1answer

How do I find a free step by step diagram for reconnecting the engine of a 2008 kia rio

Sorry, you don't. But if your just down to electrical. lay the harness out across the engine. Injector and coil plugs are the same, but usually won't stretch to the next part. The rest of the will not plug into another sensor/actuator.
2helpful
1answer

Remove alternator on kia rio 2002

its not easy i wont lie to u i have a 2002 kia rio and ive removed the alternator 6 times the real trick is to take ur front passenger tire off and jack the car up high enough to have some wiggle room underneath. when u disconnect everything, youll want to face the alternator pretty much upside down and u just have to wiggle it out past your drive shaft and control arm
1helpful
1answer

Where is the drain/refill plug for gear oil? kia rio 5spd 2002

I have a 2004 Kia Rio and you have to take off the speedometer cable/wiring harness from the top of the trans and fill it from there...the drain plug/bolt is underneath the trans from there...
0helpful
2answers

Kia Rio from'03 timing belt repair

sounds about right. timimg belts are not replaced that frequently. I have a truck with over 80,000 miles, and haven't replaced the belt yet.
0helpful
1answer

2003 Kia Rio Cold Start Problem

http://www.kiatechinfo.com/index.asp

Good source for Kia its free to register NO STRINGS
0helpful
1answer

Replacement of a 2004 kia rio rear drum stud

Loosen the remaining lug nuts, then jack up the car, take off the wheel, and ease off the brake drum. Whack the end of the stud to start it out of the hole, then take a rod, buggered up socket extension, or other object and drive out the stud the rest of the way. Be careful not to use too much force or you will damage the wheel bearings. If it doesn't want to come out, take the hub off, put it down on a solid surface, and whack the heck out of it. Once the stud is out insert the stud into the hole and thread on the lug nut to pull the lug into the hub. After going as far as it will go, back off the lug nut, put the drum and wheel back on, thread the lug nuts back on, hand tighten, and then lower the vehicle to the ground and tighten the rest of the way.
1helpful
1answer

Gear box oil filler plug - kia rio 2004

you have to take off the speedometer cable/wiring harness from the top of the trans and fill it from there....one 10mm bolt...very awkward spot...it might be snug, so just take a flat head screwdriver from underneath to tap it loose...
8helpful
1answer

Gear box oil filler plug - kia rio

you have to take off the speedometer cable/wiring harness from the top of the trans and fill it from there....one 10mm bolt...very awkward spot...it might be snug, so just take a flat head screwdriver from underneath to tap it loose...
Not finding what you are looking for?

176 views

Ask a Question

Usually answered in minutes!

Top Kia Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...