Question about 1991 Ford Festiva

1 Answer

I just can't seem to get the last part of the Cv out of the tranny is ther a certian trick to it?

Posted by on

  • dj_bum Jun 04, 2009

    well yeah i tried that yesterday i o just coulden't get it i even had a truck hoooked up to it and it woulden't give like its a brand new one though so maybe it will just take alot of force



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 142 Answers

A pry bar and a good bit of force to get the circle clip out of the groove where it slides into the tranny.

Posted on Jun 04, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Broke off about an inch and a half of the cv joint were the snap ring fits the tranny and cv on a 2 4 LITER MITSU AUTO 99 Seibring

If the CV shaft broke off in the tranny and the lock ring is still in the tranny then your probably going to have to take your car to a tranny shop because with that snap ring still on it ,it will be hard to get that piece out without taking the tranny apart.

May 12, 2011 | Chrysler Sebring Cars & Trucks

1 Answer

Tranny wont shift to out of first all of a sudden. no problems up to this day. Drove to church and parked. ran great but i went to run to the store later and she would not gear up when she should. stuck in...

if its auto you need to check the oil level first could be low. thers a filter in there that can be changed as well. this should do the trick if thats all that youve done. if it dont then its toast

Nov 02, 2009 | Dodge Ram 1500 Cars & Trucks

2 Answers

Cv joint installation

smaller one to tranny

Jul 02, 2009 | 1996 Ford Probe

1 Answer

Cv axle removal from transmission

take a pry bar to the side of the tranny and pry the cv out, there is a clip on the shaft of the axle on the inside of the tranny

May 14, 2009 | 1998 Ford Escort

1 Answer

1996 jetta, drive shaft seals

Best way to remove the axle is yo place a prybar between the transmission and axle housing and give it a quick jolt. The axle is held in the transmission slines by a retainer ring so all you have to do is pop it out. But be careful not to tear the cv boot and do not pull on the shaft or you will seperate the cv joint. Good luck.. Hope this helps.

Feb 06, 2009 | 1996 Volkswagen Jetta

Not finding what you are looking for?
1991 Ford Festiva Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

5575 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides