Question about 1995 Buick LeSabre

1 Answer

My 95 Buick LeSabre skips a lot when breaking.

Its been doing it a lot. I do not here the screeching sound of the brakes just skipping when I brake.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Buick Master
  • 2,007 Answers

Warped rotors or bad brake pads. Remove and replace. It could aslo your electronic brake pressure modulator valve. Its on the left side under your dash. When you start your car does the red BRAKE warning light come on for a few seconds and then go out? If it does, that's normal, and your problem is warpage or pads. Be sure your brake fluid resovoir is full too.

Posted on Jun 04, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My third brake light keeps blowing out on my 95 Buick lesabre how do I fix this problem

Are you touching the bulb with your fingers when you install it? The oil on your skin will cause the glass to break or crack and will cause the bulb to fail, in short use rubbing alcohol to clean it and don't touch it with bare skin use a paper towel. Also is water leaking into the light fixture? I had this issue and I installed an LED bulb replacement and no more problems.

Mar 18, 2017 | 1995 Buick LeSabre

1 Answer

How do I replace a brake booster on a 1998 Buick LeSabre? Brakes hold but make a whooshing when applied.

May not be the booster as some do make a noise when the brakes are applied. To test press the brakes several times with engine off, Press the pedal down hard and start the engine , the pedal should move down slightly and there should be no whooshing sound . if the above is ok so is the booster.

Mar 26, 2015 | 1998 Buick LeSabre

1 Answer

Loud brake noise in 97 buick lesabre

When you had the drums off, did you inspect the shoes for excessive wear? And How do the drums look? Are they grooved? Can you be more specific about the loud noise. Does it sound like a grinding noise, or a screeching or pulsating noise. Is it lower pitch or high pitch?

May 04, 2014 | 1997 Buick LeSabre

1 Answer

2001 buick lesabre, shifter wont move out of park, the car runs, brakes good but wont shift.

Check the BTIS(Brake Transmission Interlock Solenoid). This solenoid allows the shifter to be moved out of Park only when the brake is pressed.I did not like this idea(the first year it was introduced,we had to replace that solenoid on every Buick Skylark).We had so many on the lot that I decided to just carry the keys and my tools around the storage lot instead of binging them into the shop to save time.

Oct 07, 2012 | 2001 Buick LeSabre

1 Answer

1998 Buick Century Low Trac light comes on and car skips.

have you bled the brakes? If you have, you may need to do it again as there sounds like there's an air lock in your lines.

Mar 14, 2010 | 1998 Buick Century

1 Answer

1995 BUICK LeSabre front drives is brakeis sticking already replace it with a new caliper, what else can it be?

IT sounds like the brake pipe ,you might have a problem with the flex pipe as some times it breaks up inside the pipe on return and holds it on slightly or the disc isent buckeled enough as it has to have a slight bow in the disc to return the pads back 1 thou
(or -.0001" ) both sides.
But when you do the brakes you should do both sides and new rotors and pads ..

Oct 26, 2009 | 1995 Buick LeSabre

2 Answers

Abs system

it is a failed wheel bearing.the hub and bearing comes with an abs sensor and when the bearing could not be located by the sensor it will turn on the abs light and make the car skip when braking.check to see if your not missing any brake fluid and that the truck is still able to brake.if all is good then change the faulty wheel bearing.if you dont want to invest right away just disconnect the connector for the abs to the bearing.braking will feel normal and youll just have the abs light on.

Oct 04, 2009 | 1999 GMC Jimmy

3 Answers

Screeching in right rear wheel ,sound stops when breaks applied

its the brake pad wear indicator telling you your pads are in need of replacing

Sep 09, 2009 | 2006 Kia Sedona

2 Answers

Rear brakes need ajustment on Buick Lesabre

I don't know if this works on a Buick but I have had two cars that the auto adjusters worked when you used the parking brake, I rarely use the parking brake so I got in the habit of working the parking brake 20 times or so at oil change time.

Apr 15, 2009 | 1998 Buick LeSabre

1 Answer

No brakes in my 1998 buick leSabre

running master low enought for brake light to come on, you might have got air into system, if that is the case you will have to bleed out the breaks. worse case, it would need a new master cyl.

Jan 18, 2009 | 1998 Buick LeSabre

Not finding what you are looking for?
1995 Buick LeSabre Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides