Smartlock problems ed fairmont ghia

Replace the actuator in that door. Its bad.

need a new key. Smartlock ECU not recognising the right key in the ignition barrel. I had same prob with mine. There should be a code stamped on the door lock barrel. You will have to remove it to read it. There might be a code on the boot barrel too. This might be easier to access, so I would try him first.

Just because you charged the battery doesn't mean it is any good. Have it load tested bet it is not good.

Probably a broken wire somewhere or a bad power window motor.

Possible vacuum leak in the system or Central locking vacuum advance module fried.Hope I could help

try by turning the ignition to on and press the rear demister button 10 times then unlock on the remote then turn ignition off and check the operation of the remote

if its centrally locked via keyfob then i wuold look at the motor. if its manual then there will be a problem with the rear of the lock where you will find a fixing plate and a linkage similar to your gearsing system but smaller, make sure that all this is intact and then try lock again. if this does not work then you will have to explain more.

hi karisha,, unless you have cut the wires instead of unpluging them, the wires will only go in to the matching plugs. the lock has a white six pin plug with five wires in it. this plug is attached to the pannel with a plastic clip

Adding and Removing remote Keypads to the Smartlock module
------------------------------
Up to four Keypads can be programmed and used with the Smartlock Remote
Central locking system.
If you have replaced the BEM, or new keypads are being added to the
system, you will need to train the keypad codes to the module.
# 1. The ignition switch should be in the Off position, with all the
doors shut and Unlocked.
# 2. Turn the ignition key to the ACCESSORY position and within 5
seconds, operates the rear demister switch exactly three times in quick
succession. (IE. Press the switch so the Demister light turns on, then
off, then back on again.)
# 3. After the 5 seconds is up, the door locks will change state, to
indicate that the BEM has entered keypad learn mode.
NOTE : All existing keypads at this point, have been erased from memory
!
# 4. Press either buttons on the keypad that is to be trained. The door
locks will change state twice, to indicate that the keypad has been
added to the BEM memory.
# 5. Follow step 4. for each keypad that is to be added to the BEM
memory. A maximum of 4 keypads can be added to the BEM memory.NOTE :
You must teach all remote keypads for the Smartlock module, before
proceeding.
# 6. When you have taught all the remote keypads, turn the ignition to
the Off position to leave the learn mode. The door locks will change
state to indicate a return to normal mode.
# 7. Check the function of both buttons on each keypad, to ensure that
the keypad has been trained.