2000 jeep cherokee classic has no brake lights-need fuse panel diagram

SOURCE: 2000 jeep cherokee sport fuse diagram

unfortinately the fuse box is under the hood and there is no panel inside the 2000 cherokee or diagram, i had to buy an online manual to find out what fuse went where for my jeep but its not with me. You can just pull the fuses out one at a time and look at them - I know its a pain. It might be your window controll switch - mine is bad as well. It is a common problem for these cherokees especially over 100k, they wear out - I initally thought it was my fuse as well because the lights in the window switch didn't light up anymore - but it is my switch.

SOURCE: the tail lights are out, so the brake lights-Jeep Grand Cherokee

i have a 2002 jeep grand cherokee i had the same problem when i would apply my brakes when the headlights were on my brake lights would go out, i found that my bulbsocket was not making good contact with the socket housing, if you notice when you take off a bulb, look at the light fixture where you unscrewed your breaklight bulb you will notice 3 medal contacts-they should be silver in the socket housing and like a copper on the socket bulb, in the socket housing their should be 2 silver contacts together and 1 by itself the one that looks by itself is making bad contact with the copper one thats by itself on the bulb, what you can do for a quick fix is; get a small piece of low cage wire or a thin piece of metal like copper stick that in to the bottom or top of that metal contact--i did it through the bottom leave the wire or piece of medal sticking out enough for where it can get contact with the bulb (just a little wire is enough to make contact, now screw the bulb on and test it---it will work----i did it to mine, if you need more assistance let me know [email protected]

SOURCE: 2000 Mazda 626 brake lights

It may be the switch on the brake pedal, it should be located on top of the brake pedal arn.

SOURCE: 1999 jeep grand cherokee - brake lights and turn

The tail lights and the brake/turn lights use the same bulb but, there is 2 filamants in the bulb. One for tail lights and one for brake/turn lights. So just because the brake lights and turn signals work doesn't mean the bulbs are good. If bulbs are good you can check to see if there is power getting to the tail light assy's by unplugging the connector at the assy and using a test light probe the connector (harness side) with the headlights on. If you are getting power to the assy the test light will light. To make sure, turn off the headlights and test light will go off. Hope this is helpful. Good luck.

SOURCE: 2000 jeep cherokee sport fuse diagram

Likely you are looking for a 30 amp circuit breaker...(Looks like a small rectangular metal fuse) But...if the power door locks work, i don't think that it's bad (serves locks & windows) My diagrams show a bunch of diodes and resistors inside the master (drivers) door switch, but I've had a few apart and never saw any. (embedded?) Personally I don't see anything that shows me reliability built into the switch...It's a really "iffy" design (one in my niece's Jeep only works when the sun shines on the drivers door) There is also a control module associated with the windows but I've never needed to replace one and the manuals never tell you where they are!
Check power at the switch and check harness where it goes through the rubber boot between the door and body. at least 80% of problems I've seen are either the switch or that wiring. Wires can be spliced and you can get a decent used switch at most scrap yards.
Good luck...glad they aren't stuck down!!!