Question about 1994 Ford Thunderbird

1 Answer

My car has stop to work

My car stop working when I replaced the coils(because on of them was broken) The car worked four times and sedomly stop starting ,and I checked if it had fire on one of the spark plugs.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,187 Answers

Have the connections rechecked. There could be loose connections. Check also the ground wires if they were connected and secure.

Posted on Jun 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will the oil pressure sensor prevent ignition to the motor? 1999 Ford Laser - KN or Mazda 323


no oil sensor not related

fuel ,spark a broken timing belt

fuel
pump or relay you should be able to hear the fuel pump working
if engine light is on
crank angle sensor

Nov 05, 2016 | Ford Cars & Trucks

1 Answer

Speedometer stop working and the four wheel drive a mechanic said it's the bcm i want to know if the bcm can make it not to work thank you


spedos stop working because of
if the speedo is cable driven , the inner cable has broken
or
if the speedo is electronic --the VSS has failed

Feb 19, 2016 | 2003 Hummer H2

2 Answers

I have a 2005 Toyota corolla le and I replaced the v v t solenoid and the coil packs and it still won't start the engine diagnostic s Says ignition coil a b c d primary secondary circuit


Make sure that the vvt solenoid connector and its wires are all firm and not corroded or damaged. Any one of the four igniters can be at fault but not all of the four at a time. This fault often arises when the vvti sensor connector is faulty, detached, damaged. It also happens when number 2 Ignition confirmation signal (IGF) wire or number 3 Ignition Timing (IGT) wire on any of the ignition coils is broken or disconnected at the coil connector.

25652097-ts5vql1j3jwqenesgxdwpnsg-5-0.png

Apr 17, 2015 | 2005 Toyota Corolla

1 Answer

How do i fix a fuse problem? Fuse for turn signals blow every time I replace it. Almost immediately the four ways start flickering then the signals stop working. When I remove the fuse it is extremely


you have a dead short in your lighting system ,start by going to each and every bulb and check them and leading wiring to them look in all the places around fuse box for corrosion shorted wires, broken or rubbing together with bare spots , see if all other lights work well with out signals or 4ways, check brake lights as well,if you have a towing wiring check plug for damage or broken wires and corrosion.

Sep 11, 2014 | 1999 Saab 9-5

1 Answer

1991 chevy 3/4 ton 4 wheel drive doesn't work


You might have to change the switch on the transfer case or check to see if you have a broken wire or fuse blowen hope this helps

May 29, 2014 | 1999 Chevrolet Silverado 1500

2 Answers

Power windows stopped working


If the power to the illumination and the switches is out in the door, I would say it is a broken wire in the A-pillar to the door on the driver's side.

This is a Light Blue w/ Black stripe wire, it powers both the illumination and the windows themselves.

Jun 09, 2010 | 2006 Ford F-150

1 Answer

Gas gauge only works from 1/2 tank to empty do you know why


The tank sending unit has a contact arm that slides over a resistance coil of wire.
When a range stops working, either the wire in the coil broke, or the arm is not making contact.
You can bend the arm, but a broken coil needs replacement. Although I have wound my own when desperate.

Jan 03, 2010 | 2000 GMC Denali

1 Answer

Car starts, but won't work


the inertia switch in the trunk could be stuck and therefore could cause your car to not start because of no fuel getting to the engine.

Jun 02, 2009 | 1994 Ford Thunderbird

1 Answer

Rear brake lights stopped working


brake light switch fault, above the brake pedal, may have two wires or four depending on variation of model, not expensive to replace.

Good luck Davelee

Apr 26, 2009 | 2002 Land Rover Freelander

Not finding what you are looking for?
1994 Ford Thunderbird Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...