Question about 1998 Jeep Grand Cherokee

1 Answer

1998 grand cherokee...went to start it alarm went off....no key fob.....what to do i do.how do i reset it...i disconnected the neg cable an d when i put it back it still goes off

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 17 Answers

Try unlocking the drivers door with the key, if that doesn't work try locking the doors and unlocking the rear hatch with the key

Posted on Jun 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I disable the alaram system or could itbe another problem?


Shut and lock all the doors. The unlock it with the key or fob. This usually does the job

Aug 13, 2014 | 1998 Dodge Grand Caravan

1 Answer

1997 jeep grand cherokee won't start after alarm went off


I just had the same prblem. Reconnect your alarm first of all. You need to use your key bob "remote" to deactivate the alarm before starting. It is a feature "good one" i might add that should someone try to steal it the jeep will not start until u deactivate it w theke bob.

Jan 20, 2013 | 1997 Jeep Grand Cherokee

1 Answer

Won't start, could it be fob or engine?


Try not using the fob at all open the door with the key. And start the jeep if it works without issue then its the fob. If its still not working correctly remove the battery from the fob and try again(since if it was damaged could be sending the signal for the panic button) the next step is the key try your spare security key can become worn and cause issues with the antitheft system. After that it only leaves computer problems and those can get spendy

Jan 05, 2012 | 2005 Jeep Grand Cherokee

1 Answer

Alarm went off and key fob quit working


start the car. if that dose not work remove ground form battery then after it stops put ground back on that will reset the alarm.

Jan 28, 2010 | 2009 Dodge Grand Caravan

1 Answer

I have a 1999 jeep grand cherokee. the alarm goes off whenever i open the door if the vehicle has been locked the alarm stops when i start the vehicle i only have a key, no remote any ideas on how to fix...


If ithe alarm is factory when they will have to reset the alarm module with a scanner. If the alarm if aftermarket go to the control module and see if it has a reset button. FOBs (remote) can reset alarm. You Jeep is always set for break-in mode. The FOB sets this when ever the FOB is used to lock the doors. May be bad alarm module - Sorry - Good luck

Oct 17, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Remote goes off continueouslly and unless battery cable remove won't stop. Also, vechicle won't start.


Some Jeep models have the ability to reset the alarm by following this procedure. Connect the battery cables and allow the antitheft alarm to trigger (usually horn honking and lights flashing). Use your ignition key to lock, unlock, lock and unlock the passenger front door. This should reset the system to be used normally. If your key fob is the problem, remove batteries to stop alarm trigger and have dealership test and/or replace fob. Hope this helps.

Aug 14, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Reset security


pull the battery terminals off the battery and hold the pos and neg cables together for 3-5 min. this should reset the cars computer and alarm
provided it is factory alarm...

May 03, 2009 | 1998 Jeep Grand Cherokee

1 Answer

Alarm went off, car wont start. reset switch??


Pull the battery cables, hold them together for 3-5 minutes, this resets the cpu in the car. That should fix it.

Apr 24, 2009 | 1998 Jeep Grand Cherokee

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...