At least this is a common problem. I have a 02 Intrepid ES with the auto climate control. The L.E.D. display quit working a little over a year ago, but all buttons work. I've been trying to find a new one to see if it will work.
I had the same problem.
Push the top right corner of the panel surrounding the LED display hard and see if it works again. If it does, disassemble and the reassemble the panel and it should be working again.
It worked for me.
I hope this helps.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Levi, If you have the same climate control, then below is a link to a repair video for your climate control. Sorry, this is the part 3 video, look a the side to find the part 2 video and watch it first.
Climate control is turned on by pressing the 'auto/econ' button.
There will be a temperature control for it that lights up on the right hand side of console display. One can also control the fan speed there or leave it on 'auto'
Might be the same....You may want to do the diagnosis proceedure. Alot of times its the door actuators. Servos in replace of old cable design. Usually it will be a code 46. DOOR BLEND ACTUATOR SHORT TO BATTERY. The DTC's can be checked with the MTC control and the Odometer
Display of the Mechanical Instrument Cluster if a DRBIII® scan tool is
not available. The MTC control can only be placed into the diagnostic
mode while the engine is running and the vehicle is not moving. To place
the system into it's diagnostic mode, adjust the MTC control to the
The engine must be running with vehicle not moving.
The fan speed set to any speed except OFF.
The temperature control knob in full cold (full counterclockwise position).
The mode control knob must be placed in Defrost position (full clockwise position).
The A/C button can be On or Off.
and hold the rear window defogger (EBL) button until the mechanical
instrument cluster odometer display indicates an "AC00". The BCM will
chime once and the MTC A/C button LED will begin blinking.
the EBL button and wait until the MTC A/C button LED stops blinking.
This means that the error check and climate control door calibration is
complete. NOTE:It is important that no
other control knob or button is pushed until all DTC's are read. Pushing
any button except the A/C button or turning a control knob will end the
diagnostic test without showing the rest of the DTC's. There also may
be other DTC's stored in the BCM not related to the climate control
system. These DTC's can only be found using the DRBIII® scan tool. DTC's
related to the MTC control head will appear on the odometer display in
numerical form after the letters "AC". The odometer display will return
to normal operation if no DTC's are found. If a problem is found, then
the odometer will display the letters "A/C" followed by the DTC number.
The odometer display can only show one DTC at a time. Under certain
circumstances, more than one DTC could be in the memory. To scroll
through any additional DTC's, press the A/C button on the MTC control.
The BCM will beep each time the A/C button is pushed. Continue pushing
the A/C button and recording the DTC's until the odometer returns to
normal operation (note the letters AC will dissapear.